JBL P1802 Manual
Here you can view all the pages of manual JBL P1802 Manual. The JBL manuals for Amplifier are available online for free. You can easily download all the documents as PDF.
Page 1
Power Series Amplifiers P80.2, P180.2, P80.4, BP150.1, BP300.1, BP600.1, BP1200.1 OwnerÕs Manual GENUINE JBL Power Series OM 4/15/99 9:17 AM Page 1
Page 2
¥ Before drilling or cutting holes, use a utility knife to remove unwanted fabric or vinyl to keep material from snagging in a drill bit. ¥ When routing cables, keep input-signal cables away from power cables and speaker wires. ¥ When making connections, make certain they are secure and properly insulated. ¥ If the amplifierÕs fuse must be replaced, use only the same type and rating as that of the original. Do not substitute another kind. 2 Installation Warnings and Tips¥ Always wear protective...
Page 3
3 BP150.1, BP300.1, BP600.1, BP1200.1 Note:Drawing is provided only for connector, control and fuse location. Please see ÒSpecificationsÓ for fuse requirements. SPEAKER OUTPUTSFUSES 40A x 3 POWER+ Ð Ð + + BATT REM GND RR LL HIGH LEVEL FRONT INPUTS REAR INPUTSHIGH LEVEL INPUT LEVELLPF FREQBASS BOOST R L R L + Ð Ð + Ð ++ Ð4V 250mV 32Hz 320Hz 0dB +6dB P80.4 HIGH LEVELHIGH LEVEL R LR L FRONT REAR + R Ð Ð L...
Page 4
4 FREQUENCY INDUCTOR CAPACITORCrossover 6dB/oct. LP 6dB/oct. HP (4-ohm) (4-ohm) 75Hz 8.0mH 530µF 100Hz 6.4mH 400µF 125Hz 5.0mH 318µF 150Hz 4.2mH 265µF 175Hz 3.6mH 227µF 200Hz 3.2mH 198µF Wiring the Power ConnectionsRefer to Figures 1Ð3 for connector loca- tions. All the Power Series amplifiers will accept up to 4-gauge power and ground wire. For power, remote and ground connec- tions, strip off one end of each jacket to reveal bare wire for insertion into the connectors. Connect a wire from the GND...
Page 5
5 Setting Input Level Initially, turn the input-sensitivity LEVEL control to its maximum (counter-clock- wise) position. Turn on the source unit and increase the volume control until it is approximately three-quarters of maxi- mum-output level. Slowly increase the input LEVEL control (clockwise) while lis- tening to the quality of the reproduced sound. When you hear distortion on the music peaks, turn the LEVEL control back slightly. This is the maximum undistorted output level of your system. Turning...
Page 6
6 TroubleshootingSymptom Likely Cause Solution No Audio Short circuit in speaker or speaker wire. Disconnect speaker leads one at a time to determine (Red LED flashes every four seconds) which speaker or wire is shorted or defective. Repair the short circuit or replace bad speaker.No Audio No voltage at BATT or REM terminals. Check voltage at amplifier terminals with VOM. (Power indicator is off) Bad or no ground connection.No Audio Amplifier overheated. Make sure amplifier cooling isnÕt prevented by...
Page 7
7 SpecificationsP80.2, P180.2, P80.4, BP150.1, BP300.1, BP600.1, BP1200.1Specifications P80.2 P180.2 P80.4 BP150.1 BP300.1 BP600.1 BP1200.1 Power Output, 40W x 2 90W x 2 40W x 4 75W 150W 300W 600W4 ohms Power Output, 80W x 2 180W x 2 80W x 4 150W 300W 600W 1200W2 ohms Power Output, 160W x 2 360W x 1 160W x 2 NA NA NA NA4 ohms Bridged Minimum speaker 2 ohms 2 ohms 2 ohms 1 ohm* 1 ohm* 1 ohm* 1 ohm*impedance Frequency 10Hz Ð 50kHz 10Hz Ð 50kHz 10Hz Ð 50kHz 10Hz Ð 320Hz 10Hz Ð 320Hz 10Hz Ð 320Hz 10Hz Ð...
Page 8
Declaration of Conformity We, JBL Europe A/S Kongevejen 194B DK-3460 Birkerød DENMARK declare in own responsibility, that the products described in this owner’s manual are in compliance with technical standards: EN EN 55013/A12/8.1994 55020/12.1994 Steen Michaelsen JBL Europe A/S Birkerød. DENMARK. 4/99 JBL Consumer Products 250 Crossways Park Drive, Woodbury, NY 11797 8500 Balboa Boulevard, Northridge, CA 91329 1-800-336-4JBL (4525) (USA only) www.jbl.com ©1999 JBL, Incorporated JBL is a...