InFocus ScreenPlay 7200 Projector User Manual

							10
Connecting a computer		/	9&1!	
(1!	/			
/	2	 	/	/		0/	0		 
	#0				00	/	
1!	/		D0	 
	/		1!	/		/	1/	2	0
	!	!!	 
./		*&3/	2	D	0!0#		 
NOTE
!	/		1!	//	0//	2	 
./	2	/		 
H!/	2	*3!	!	1
	#
						

							11
Shutting down the projectorPow e r  S av e
./	2	/				/			/+
!!/	!	#!	0			0	 	(
00!	/#!/	2		0 	
#!			01		/	2		0/	#	0!	0 
H	/	Pow e r10!#		,	/	
	0 
Turning off the projector
./	2		/	Powe r1 ./	! 0/	
*&31!#		1		/!	/		
!/	! /	/	!/!	0/	*&3!#/#		0/	
 %!#/		1!	!		!	/	2	 
Troubleshooting your setup#			!/			/		:	
E#	 ($G 0	1!	//		 
./	*&3/	2	D	00	/		/	2	
0/	!1!	/ 

./	!!#1!	/		!1!	 			
/	1!	!0	0 ./	!/	0	/	
				0 /	/	1!	!	0/	00!
! 
Table 2: LED behavior and meaning
LED color/behavior
Meaning
solid green The projector is plugged in, or the projec-
tor has been turned on and the software 
has initialized. The projector has been 
turned off and the fans have stopped.
blinking green The Powe r button has been pressed and 
the software is initializing, or the projec-
tor is powering down and the fans are 
running to cool the lamp.
blinking red
The projector will not start up if the LED 
is blinking red. You must correct the prob-
lem, disconnect and reconnect the power 
cable, then power on the projector. 
See page 34 for more information on 
blinking red LEDs.A fan (blinks 4 times) or lamp (blinks 3 
times) failure has occurred. Turn off the 
projector and wait one minute, then turn 
the projector on again. Also check for a 
blocked vent or a stopped fan (blinks 5 
times).
solid red An unidentifiable error : please contact 
Technical Support. 
						

							12
Problem Solution Result
No startup screenPlug power cable in and remove lens cap
press Power button
Correct image
Image not centered on screenMove projector, adjust zoom, adjust heightCorrect image
ScreenPlay
Adjust horizontal or vertical position in 
Picture>Advanced menuzoom 
						

							13
Image not squareAdjust keystone on keypadSquare image
Image does not fit 16:9 screenChange aspect ratio to 16:9 in 
Picture>Aspect ratio menuCorrect image
Edges of image distortedTurn Overscan on in the Picture>Advanced 
menu
Correct image
AB
AB 
						

							14
1. Projected colors don’t match source
2. Colors are washed out or too deep
3. Image from component source appears greenish1. Adjust color, tint, color temperature, 
brightness, or contrast in the menus.
2. Pick another gamma setting
3. Pick another color space
Correct image
Image upside downTurn off Ceiling in Settings>System menuCorrect image
Image reversed left to right
Turn off Rear in Settings>System menu
Correct image 
COLOR
COLOR
A
B
AB
A
AB 
						

							15
Video image “torn” and fragmentedChange Video Standard in 
Picture>Advanced menuCorrect image
Lamp won’t turn on, LED blinking red (page 11)Make sure vents aren’t blocked; allow 
projector to cool for one minute Unplug projector; wait one minute; plug in 
projector and turn it on: lamp lights
A
AB
B
AB
blinksred
 
ScreenPlay 
						

							16
Computer-specific troubleshooting
Only startup screen appearsPress the Source button 
Activate laptop’s external portComputer image projected
No computer image, just the words “Signal out of 
range” Adjust computer refresh rate in Control 
Panel>Display>Settings>Advanced>
Adapter (location varies by operating 
system)Computer image projected
A
ScreenPlay
or restart
laptop
A
A
A
Signal out of
range
A
A 
						

							17 Still having problems?
		0	!!
			0	!
1-800-799-9911 		1			6  06  .
0
/#/
0 !1!	)/		/0
			0		(+444+7$+64 
	0	+!
 [email protected] 
&	!!
./	)	/	!0(31) 35-6474010 
!!
#	(65) 6334-9005 ./01	01!	0+	 +	
L/#			!1	/	00	!	 /		0+
#/	2					0/#/	#+
!#	!/#	!##/	
/!!		/# !./#	
!1!	/	/0	0	;		/# 
!			/	!!!	  Image fuzzy or cropped Set your computer’s display resolution to 
the native resolution of the projector 
(Start>Settings>Control 
Panel>Display>Settings tab, select 
1280x720) Image clear and not cropped
A
AA
For a laptop,
disable laptop
monitor
or turn-on dual-
display mode
A 
						

							18
Using the keypad buttons
1	0	1	00	!/		1/			+
	/	

Pow e rR/	2	E#	 4G0E#	 4G 
MenuR	/	+			E#	 (G 
SelectR/	0	/		E#	 (G 
Up/down arrowsR#	002	#/		E#	 (G 
Auto imageR		/	2	/		 
PresetsR!	/#//	,!1!					#E#	 8G 
Key s t o n eR02;		/	#	E#	 ((G 
BrightnessR02	/	#	E#	 G 
ResizeR/#	/		E#	 G 
SourceR/#	/			E#	 4G 
menu navigation buttons 
						

							19
Using the remote control./				EG0	01		 ./			!!!	0
1!0#/		/			D1!##/	S0+	0/	
1		!0#/	!	0/		!#/		 
.		/			/	2			/	2	E
/	0	0			G ./	#		
,		E$ (8G 
	/			DMenu1	/	2	D		 %	
/	1#	0/	Select1	!			0
02!	/		 		#	 (	/		 
./			!/

KPow e r1/	2	0E		#	 ((/+
0G
K 1!#/1!#//			D1/	0
KBrightness0Contrast102/	#	
KBlank10!1!			0/		#	E
/#	/	!/					#	 $G
KSource1/#	E#!	
	1		#	 4G0	##!	
KResize1/#	/