InFocus Projector Work Big In15 User Manual

Contents
1
English
English
Unpacking ....................................................................................................................................... 2
Using the User Documentation on the CD-ROM .......................................................................... 2
Register with InFocus ................................................................................................................... 2
Important Lamp...

2
Unpacking
UnpackingAs you unpack the projector, check to make sure that all of the items listed below are present.
The CD-ROM that comes with the projector has a PDF file “Reference Guide” that contains 
detailed explanations about projector operations. 
In order to read the Reference Guide, you need to have Adobe
® Reader® installed on your 
computer. If you dont, go to www.adobe.com to download and install it.
Its quick, easy, and secure.
Activate your warranty to ensure eligibility for service and...

3
General GuideEnglish
General Guide
[Front/Top/Left Side]
[Key and Indicator Panel]
*The projector’s enter key does not have anything printed on it. When you see [ENTER] in 
this manual, it means you should press the projector’s enter key or the [ENTER] key of the 
remote controller.
Warning
zNever look into the lens while the projector is turned on.
zNever allow the intake and exhaust vents to become blocked, and make 
sure there is at least 30 cm (11.8 inches) clearance around the projector. 
Blocked...

General Guide
4
[Bottom]
[Back, Terminals]
zThe anti-theft lock hole is provided for connection of an anti-theft chain. 
WarningzIn the unlikely event of a lamp rupture, particles may be ejected from the 
projector. Keep out of the area under and around the projector when it is 
turned on. See the safety instructions booklet for more details.
Elevation adjustment foot
Left, right
adjustment feet (2)Lamp cover
Elevation
adjustment foot
release button
Anti-theft lock hole
Intake vents
Remote control
signal...

5
General GuideEnglish
The remote control unit comes loaded with a test battery. Before using it for the first time, 
remove the battery insulation sheet from the back of the remote controller.
zTo avoid running down the battery, store the remote control unit so its buttons are not 
pressed inadvertently.
Remote Controller General Guide
Preparing the Remote Controller
[INPUT] key
[AUTO] key
[ ] (Power) key
Remote control signal emitter
[ZOOM +] [ZOOM –] keys
[FOCUS S] 
[FOCUS T] keys
[D-ZOOM +] 
[D-ZOOM...

General Guide
6
Before you can use the remote controller for the first time, you need to load the battery that 
comes with it.
Replacing the Remote Controller Battery
CautionRISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT 
TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Caution
Misuse of a battery can cause it to leak and stain the area around it, or to 
explode, creating the risk of fire and personal injury. Make sure that you 
always observe the following precautions.
zTake care...

7
Getting ReadyEnglish
Getting Ready
Locate the projector on a desk, table, or stand that is firm and level. Make sure to allow 
sufficient space around the sides and back of the projector for proper ventilation.
zThe following illustrations show how the projector should be oriented for optimum projection 
relative to the screen.
zYou can place the projector on a surface that is angled up to 30 degrees upwards or 
downwards during use. Never locate the projector on a surface that is angled more than 30...

Getting Ready
8
You can change the elevation angle of the projector in a range of 0 to 12 degrees. You can 
also make fine adjustments to the left and right side elevation angle when necessary.
To change the projector elevation angle
1.Lift up the front of the projector and press the 
release button.
zThis causes the elevation adjustment foot to drop 
from the bottom of the projector.
zBe sure to press the release button before trying to 
lower the elevation adjustment foot. Pulling on the 
foot without...

9
Getting ReadyEnglish
You can use the projector to project an image of video output from a computer.
zAlways turn off the projector and the computer before connecting them.
You can use the projector to project an image from a video deck, TV, video camera, or other 
video device.
zAlways turn off the projector and the video device before connecting them.
zYou can use the bundled video cable to connect to a pin jack (RCA) type VIDEO output 
terminal. When connecting a video camera or other video device...

Getting Ready
10
Before performing any of the operations in this section, make sure you first set up the projector 
and connect to an output device.
AC Power Cord Precautions
zUse the AC power cord that comes with the projector.
zMake sure that you use a power source with the same voltage as that specified for the 
projector.
zDo not share the outlet supplying power to the projector with other devices. If you are using 
an extension cord, make sure that the ampere rating of the extension cord is...