InFocus Projector Lp340 User Manual

							Specifications
31 User’s Guide
Timing Chart 
Resolution H Sync (kHz) V Sync (Hz) Remark
640x350 31.5 70.1
640x400 37.9 85.1 VESA
720x400 31.5 70.0
720x400 37.9 85.1 VESA
640x480 31.5 60.0 VESA
640x480 37.9 72.8 VESA
640x480 35 66.7 Macintosh
640x480 43.3 85.0 VESA
800x600 35.2 56.3 VESA
800x600 37.9 60.3 VESA
800x600 46.9 75.0 VESA
800x600 48.1 72.2 VESA
800x600 53.7 85.1 VESA
832x624 49.7 74.5 Macintosh
1024x768 48.4 60.0 VESA
1024x768 56.5 70.1 VESA
1024x768 60.0 75.0 VESA
1024x768 68.7 85.0 VESA
1280x1024 64.0 60.0 VESA 
						

							Dimensions 32 User’s Guide
DIMENSIONS 
Unit: mm
307.5307.5
242.23242.23
109.46109.46 
						

							Regulatory and Safety
33 User’s Guide
REGULATORY AND SAFETY
This section presents information that shows how your digital projector complies with 
regulations in certain regions. Any modifications to your digital projector not expressly 
approved by Hewlett-Packard could void the authority to operate the digital projector 
in these regions.
LED Safety
The infrared ports located on the digital projector are classified as Class 1 LED (light-
emitting diode) devices according to International Standard IEC 825-1 (En 60825-1). 
This device is not considered harmful, but the following precautions are recommended:
 If the unit requires service, contact an authorized HP service center.
 Do not attempt to make any adjustment to the unit.
 Avoid direct eye exposure to the infrared LED beam. Be aware that the beam is 
invisible light and cannot be seen.
 Do not attempt to view the infrared LED beam with any type of optical device.
Mercury Safety
Wa r n i n g : This digital projector lamp contains a small amount of mercury. If the lamp 
breaks, adequately ventilate the area where the breakage occurred. Disposal of this 
lamp may be regulated due to environmental considerations. For disposal or recycling 
information, please contact your local authorities or the Electronic Industries Alliance 
(www.eiae.org)
U.S.A.
This digital projector has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential installation.
This digital projector generates, uses, and can radiate radio frequency energy. If not 
installed and used in accordance with the instructions, it may cause harmful 
interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation.  If this digital projector does 
cause harmful interference to radio or television reception (which can be determined 
by unplugging the unit), try the following:
 Reorienting or relocating the receiving antenna.
 Relocating the digital projector with respect to the receiver.
 Connecting the digital projector’s power cord to another power outlet.
Connections to Peripheral Devices. To maintain compliance with FCC Rules and 
Regulations, use properly shielded cables with this device.
For more information, consult your dealer, an experienced radio/television technician, 
or the following booklet, prepared by the Federal Communications Commission: How  
						

							Regulatory and Safety 34 User’s Guide
to Identify and Resolve Radio-TV Interference Problems. This booklet is available from the 
U.S. Government Printing Office, Washington, DC 20402, Stock Number 
004-000-00345-4. At the first printing of this manual, the telephone number was 
(202) 512-1800.
Canada
This Class B digital apparatus complies with Canadian ICES-003.
Japan
Ko re a   
						

							Regulatory and Safety35
User’s Guide
European Union 
NOTE
: For regulatory identification pur poses, your product is assigned a 
Regulatory Model Number. The Regulatory Model Number for your product is 
listed in the declaration below. This regulatory number is different from the 
marketing name and product number.    
DECLARATION OF CONFORMITY
According to ISO/IEC Guide 22 and EN 45014
Manufacturer’s Name:                    Hewlett Packard Company
Manufacturer’s Address:               Hewlett Packard Company
                                                         Digital Projection & Imaging
                                                         1000 NE Circle Blvd.
                                                         Corvallis, OR 97330-4239
Declares, that the product(s):
Product Name:  HP Digital Projector
Model Number(s):   VP6120, VP6121, VP6110, VP6111
Regulatory Model Number(s):  CRVSB-03HE
Conforms to the following product specifications:
Safety: IEC 60950:1991 +A1,A2,A3,A4 / EN 60950:1992+A1,A2,A3,A4,A11 
            IEC 60825-1:1993 +A1 / EN 60825-1:1994 +A11 Class 1 LED
            GB4943-1995
EMC:    EN 55022: 1998  Class B [1]
            CISPR 24:1997 / EN 55024:  1998
            IEC 61000-3-2:1995 / EN 61000-3-2:1995 +A1:1998 +A2:1998 +A14:2000
            IEC 61000-3-3:1994 / EN 61000-3-3:1995
            GB9254-1998
            FCC Title 47 CFR, Part 15 Class B/ANSI C63.4:1992
            AS/NZS 3548:1995 Rules and Regulations of Class B
Supplementary information:
The product herewith complies with the requireme nts of following Directives and carries the 
CE marking accordingly:
-Low Voltage Directive:  73/23/EEC
-EMC Directive:  89/336/EEC
[1] The product was tested in a typical configur ation with Hewlett Packard Personal Computer 
peripherals.
This device complies with Part 15 of the FCC Rule s.  Operation is subject to the following two 
conditions:  (1) this device may  not cause harmful interference, and (2) this device must accept 
any interference received, including interf erence that may cause undesired operation.
Corvallis, Oregon, March 7, 2004
  
European Contact for regulatory topics only: Hewlett Packard GmbH, HQ-TRE, Herrenberger 
Straße 140, 71034 Boeblingen, Germany.  (FAX:+49-7031-143143).
USA Contact:  Hewlett Packard Co., Corpor ate Product Regulations Manager, 3000 Hanover 
Street, Palo Alto, CA 94304.  Phone:  (650) 857-1501.