InFocus Projector IN2126a User Manual

50
LiteBoard™ Wand
The optional LiteBoard™ Wand (p/n HW-LBWAND-02), when combined with 
the LiteBoard Wand dongle (p/n HW-LBRADIO), works like a wireless mouse - 
but one that works in midair, not on your desktop. Just hold the wand in your 
hand, and point it at the projected image to point, click and drag. The wand works 
with all your software, just like a regular mouse.
Charging the Wand’s Battery
When the wand’s red battery light starts to blink, its internal battery is low (if the 
battery is fully...

51
Wand Position and Avoiding Shadows
Your Location Distance from the Screen
You can use the LiteBoard™ Wand right up against the screen, or around the 
room. You might find that your pointing accuracy will improve if you get closer to 
the screen. Also, avoid standing too far off from either side of the screen.
Avoid Shadows!
The wand wont work if its sensor is in a shadow or if it is pointing at a shadow:
How to Hold the Wand
You can hold the wand the way you would hold a normal pencil or pen, or you...

52
Wand Features
Buttons and Wand Tip
The wands buttons are equivalent to the left and right buttons on a mouse. The 
wands tip is also a button, and is equivalent to the left mouse button.
Battery Light
The red battery light shows the status of the wands built-in battery (see below for 
battery information). The battery light will turn on while the wand is charging, and 
it will blink if the battery is low (1 hour of wand use left).
Link Light
The blue link light shows the status of the wands wireless...

53
Lithium Battery Information
Manufacturer: Shenzhen HYB Battery Co., Ltd.
Model: J233
Rating: 3.7V/800mAh
Caution: Lithium battery is only rechargeable, and not user replaceable. Not user 
serviceable.
Troubleshooting LiteBoard™
For the most up-to-date information, visit our support site at www.infocus.com/
support
• If the wand doesnt work at all, or it works intermittently, try one of these 
solutions::
- Press the tip, left or right button on the wand to turn it on.
- If the wands blue Link light...

54
Maintenance
Cleaning the lens
1Apply a non-abrasive camera lens cleaner to a soft, dry cloth.
•Projector must be off and the lens must be at room temperature.
•Avoid using an excessive amount of cleaner, and don’t apply the cleaner 
directly to the lens. Abrasive cleaners, solvents or other harsh chemicals 
might scratch the lens.
2Lightly wipe the cleaning cloth over the lens in a circular motion.
WARNINGS:
•Turn the projector off and unplug power cord before cleaning any part of 
the projector.
•Do...

55
Replacing the projection lamp
The Lamp Hours timer in the Projector Info menu counts the number of hours the 
lamp has been in use.
•NOTE: Be sure to use the InFocus lamp module designed for this projector. 
You can order new lamps from www.infocus.com (in select areas), your 
retailer or your dealer. Only genuine InFocus lamps are tested for use in this 
projector. Use of non InFocus lamps may cause electrical shock and fire, and 
may void the projector warranty.  InFocus is not liable for the...

56
1Turn off the projector and unplug the power cord.
2Wait 60 minutes to allow the projector to cool thoroughly. 
3Remove the lamp door, located on top of the projector, by removing the 
screw on the side of the lamp door, sliding the door forward, and lifting the 
lamp door off.
4Loosen the captive screws that attach the lamp housing to the projector.  
NOTE: If the projector is installed on a ceiling mount, be careful not to drop 
the lamp module once the captive screws are loosened.
5Carefully lift...

57 Numerics
3D Sync Invert 27
A
AC Power On 29
AP Mode 32, 47
Apply 30
Aspect Ratio 26
Audio 1/Audio 2 8
Auto Image 26
Auto Keystone 26
Auto Off Time 30
Auto Source 29
AV Mute 28
B
Battery Light 52
Blank Key 28
Blank Screen 28
Brightness 26
C
Cable box 11
Ceiling Mount 26, 28
Client Mode 32, 47
Closed Captions 28
Color Space 27
Computer 1 28
Computer 1/Computer 2 8
Computer 2 28
Connecting
Video device 11
Connecting a video device 11
Contacting InFocus 19
Contrast 26
Crestron e-Control
® 34
Crestron...

58 M
MAC Address 30
Magnify Level 28
Menu Transparency 29
menu usage 25
Mute 28
N
Network 30
O
only 27
Overscan 27, 28
P
Phase 27
PIN Protect 29
Power connector 8
Power cord 8
Power Saving Mode 29
Prevent PC Screen Saver 27
Programmed Dimming 29
Projector
Connecting video devices 11
Keypad buttons 22
Menus 25
Positioning 7
Setting up 7
Troubleshooting problems 12
Projector Info 28, 30
R
Rear Project 28
Red/Green/Blue Gain 27
Red/Green/Blue Offset 27
remote control 20
Reset Button 52
Resetting the...

59 Z
zoom 10