InFocus Projector IN2124 User Manual

30
Controlling the projector through a LAN environment
The projector supports Crestron® software. With correct settings for the  Network menu, 
you can manage the projector from a computer using a web browser when  the computer and 
the p
rojector are properly connected to the same local area network.
Configuring the LAN control setting
If you are in a DHCP environment:
1Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the  
projector and the other end to the RJ45 port .
2Press...

31
Controlling the projector remotely through a web 
browser
Once you have the correct IP address for the projector and the projector is on or in standby 
mo
de, you can use any computer that is  on the same local area network to
 control the 
pr
ojector.
• If you are using Microsoft Internet Explorer, make sure it is version 7.0 or 
higher.
• The screen shots in this manual are for reference only, and may differ 
depending on your browser.
1Enter the address of the projector in the address bar of your...

32
•/ > < $ % +    are prohibited. 
About Crestron e-Control ®
1The 
Crestron e-Control® page provides a variety of virtual keys to control 
the projector or adjust the projector’s image. 
a
a
i
You can press  /
 to reveal more 
buttons.
a. These buttons function the same as the ones on the OSD menus or remote 
control. 
• Source List : To switch the source, click on the desired source. 
• Menu : Use to go back to previous OSD menu, exit and save menu settings. 
• When you use the projector control panel...

33
2
The 
Tools  page allows you to manage the projector, configure the LAN 
control settings and remotely access the network operations of  this projector.
cb
a
a. This area is only used with a Crestron Control System. Please contact Creston or  refer to the Crestron user manual for setup information.
b. This area is used for naming the projector,  associating it with a particular location, 
assigning a responsible party to  it, and adjusting network settings.
c. This area is used to set User and Admi n...

34
3
The 
Info page displays the information and status of this projector.
Press  exit to go back to the Crestron remote network operation page.
4After pressing the  Contact IT Help  button, the Help Desk  window will 
display in the  upper right corner of the screen. You will be able to send 
m

essages to RoomView™  software administrators/users who are connected 
to

 the same local area network.  
• For more information, visit  http://www.crestron.com and 
www.crestron.com/getroomview .
Crestron...

35
Maintenance
Cleaning the lens
1Apply a non-abrasive camera lens cleaner to a soft, dry cloth.
•Pr
ojector must be off and the lens must be at room temperature.
•Avoid using an excessive amount of cleaner, and don’t apply the cleaner 
directly to the lens. Abrasive cleaners, solvents or other harsh chemicals 
might scratch the lens.
2Lightly wipe the cleaning cloth over the lens in a circular motion.
WARNINGS:
•Turn the projector off and unplug power cord before cleaning any part of 
the projector.
•...

36
Replacing the projection lamp
The Lamp Hours timer in the Projector Info menu counts the number of hours the 
lamp has been in use. Twenty hours before the lamp life expires, the message 
“Replace lamp” displays on the screen at startup.
•NOTE : Be sure to use the InFocus lamp module designed for this projector. 
You can order new lamps from www.infocus.com  (in select areas), your 
retailer or your dealer.  Only genuine InFocus lamps are tested for use 
in this projector.  Use of non InFocus lamps...

37
1
Turn off the projector and unplug the power cord.
2Wait 60 minutes to allow the projector to cool thoroughly. 
3Remove the lamp door, located on top of the projector, by removing the screw 
on the side of the lamp door, sliding 
the door forward, and lifting the lamp 
door off.
4Loosen the captive screws that attach the lamp housing to the projector.   
NOTE : If the 
 projector is installed on a ceiling mount, be careful not to drop 
the lamp module once the captive screws are loosened.
5Carefully...

38
INDEX
Numerics
3D Sync Invert 26
A
Apply 29
Aspect Ratio 25
Audio In Computer connector 7
Auto Image 25
Auto Off Time 29
Auto Source 28
AV Mute 27
B
Blank Key 27
Blank Screen 27
Brightness 25
C
Cable box 10
Ceiling Mount 27
Closed Captions 27
Color Space 26
Computer In connector 7
Connecting Video device 10
Contacting InFocus 18
Contrast 25
Crestron e-Control
® 32
Crestron RoomView 34
Customer service contact information 18
D
Default Gateway 29
Detect Film 26
DHCP 29
Digital Zoom 27
DNS 29
F
Factory...

39
Prevent PC Screen Saver 26
Programmed Dimming 28
Keypad buttons 21
Menus 24
Positioning 6
Setting up 6
Troubleshooting problems 11
Projector Info 27, 29
R
Rear Project 27
Red/Green/Blue Gain 26
Red/Green/Blue Offset 26
Remote control 19
Resetting the projector 29
Restart Network... 29
S
Search Screen 28
Service 29
Set Black Level... 27
Sharpness 25
Show Messages 28
Source 27
Source Info 27, 29
Subnet mask 29
Sync Threshold 26
T
Tint 26
Tracking 26
Troubleshooting 11
TV tuner 10
U
USB 5
V
Vert Shift...