InFocus Projector IN1146 User Manual

ENTER 

2
1. Do not block any ventilation openings. To ensure reliable operation of the projector and to protect from overhea\
ting, it is recommended that you install the projector in a location that does not block ventilation. For example, do\
 not place the projector on a crowded coffee table, sofa, bed, etc. Do not put the 
projector in an enclosure such as a book case or cabinet that restricts air flow .
2. Do not use the projector near water or moisture. To reduce the risk of fire and/or electric shock, do...

3
decLaratIon of conformIty
Manufacturer: InFocus Corporation, 13190 SW 68th Parkway, Portland, Oregon 97223-8368 USA
We declare under our sole responsibility that this projector conforms to the following directives and norms:
 EMC Directive 2004/108/EC
 ErP Directive 2009/125/EC
 EMC:  EN 55022: 2010
   EN 55024: 2010
   EN 61000-3-2: 2006+A2:2009
   EN 61000-3-3:2008
 Low Voltage Directive 2006/95/EC
 Safety: IEC 60950-1:2005; EN 60950-1:2006+A12:2011
trademarkS
Apple, Macintosh, iPod, iPod nano, and...

4
product overvIeW
ENTER
12
910
131114151617
19
45
78
3
2
6
1
182021
product overvIeW
1.   Kensington Lock2.  Focus Dial3. Power Button () 4. Up Button ()
5.  Enter Button (ENTER)
6.  Left Button ()
7. Menu Button () 8. Down Button ()
9.  Auto Source Button ()10. Right Button ()11. IR Receiver
Note
Items 4~10 are also function buttons. Functions vary depending on the cu\
rrent mode.
12. Audio Output Connector13. A/V Input Connector14. SD Card Slot15.   HDMI  Connector16. USB  Connector17.  VGA...

5
1.  Connect the VGA / HDMI device using an appropriate cable.
2.  After powering on the projector, 
press on the control panel 
or  on the remote control to 
automatically switch the input 
source.
adjuSt projected Image heIghtadjuSt the projected Image
The projector is equipped with an elevator foot for adjusting the projec\
ted 
image height.
To adjust the height:
Turn the elevator foot to adjust the projected image position to the desi\
red 
height.
ENTER
Adjust the focus until the image is 
clear....

6
Note
The tripod is an optional accessory. 
InSert uSB fLaSh drIve
LOCK
Insert an SD card into the slot with the gold contacts facing down.
Note• To remove the SD card, simply pull out the memory card from the slot.• Do not remove the SD card while the projector is projecting images from \
the card. This can 
cause data loss or damage the card.
• Supports SD card size up to 32GB.• The SD card is not included in the package.
Plug a USB flash drive into the USB connector at the back of projector.
Note...

7
EZ Media submenu
hoW to uSe the muLtImedIa eZ SuIte menu
Video menuPhoto menu Audio menu
Office viewer menu
General operation (i.e. using the remote control)• To enter Home Menu, use the  Auto Source button to change sources 
until Multimedia is reached.
• Use p/q to highlight the desired main menu option and press  ENTER to 
confirm the selection.
• To playback media files, press  p/q to select [EZ Media] and press  ENTER 
to enter the data source mode. Then press  p/q to select the desired data...

8
Viewing Photos from the USB Flash Drive or SD Card
vIeWIng photoS
Full Screen mode (see page 9)Browse file
Note
The displayed screen may vary depending on the data source selected in t\
he previous step.
Enter Home Menu
Select Photo File
2. Select Data Source
Change data source
Preview File
Select [Photo] 

9
vIeWIng photoS - fuLL Screen dISpLay
If the slide show function is enabled, photos are played continuously at specified intervals.
Menu itemDescription and Available Options
Display  Ratio  Select the aspect ratio of the display.
Available options: Fit to screen / Full screen / Crop to 
screen
Slideshow Enable/Disable the slide show.
Available options: OFF/ ON
Slideshow  Duration Set the interval time between each slide displays.
Available options: 10 sec / 30 sec / 1 min
photo SettIngS
Enter Home...

10
Playing Videos from the USB Flash Drive or SD Card
pLayIng vIdeoS
Video Playback mode (see page 11)
Enter Home MenuSelect Video File
2. Select Data Source
Change data source
Select [Video]
Note
The displayed screen may vary depending on the data source selected in t\
he previous step.
Playback File