Indesit Iwd 6105 W Instructions For Use

							GB
11
Precautions and tips
! This washing machine was designed and constructed in 
accordance with international safety regulations. The fol-
lowing information is provided for safety reasons and must 
therefore be read carefully.
General safety
•  This appliance is not intended for use by persons (inclu -
ding children) with reduced physical, sensory or mental 
capabilities, or lack of experience and knowledge, unless 
they have been given supervision or instruction concer -
ning use of the appliance by a person responsible for 
their safety. Children should be supervised to ensure that 
they do not play with the appliance.
•  This appliance was designed for domestic use only.
•  Do not touch the machine when barefoot or with wet or 
damp hands or feet.
•  Do not pull on the power supply cable when unplugging 
the appliance from the electricity socket. Hold the plug 
and pull. 
•  Do not open the detergent dispenser drawer while the 
machine is in operation.
•  Do not touch the drained water as it may reach extreme-
ly high temperatures. 
•  Never force the porthole door. This could damage the 
safety lock mechanism designed to prevent accidental 
opening.
•  If the appliance breaks down, do not under any circum-
stances access the internal mechanisms in an attempt 
to repair it yourself.
•  Always keep children well away from the appliance while 
it is operating.
•  The door can become quite hot during the wash cycle.
•  If the appliance has to be moved, work in a group of two 
or three people and handle it with the utmost care. Never 
try to do this alone, because the appliance is very heavy.
•  Before loading laundry into the washing machine, make 
sure the drum is empty.
Disposal
• Disposing of the packaging materials: observe local 
regulations so that the packaging may be re-used.
•  The European Directive 2002/96/EC on Waste     
  Electrical and Electronic Equipment, requires that   
  old household electrical appliances must not be    
  disposed of in the normal unsorted municipal waste  
  stream. Old appliances must be collected separately  
  in order to optimise the recovery and recycling of the  
  materials they contain and reduce the impact on human   
  health and the environment. The crossed out “wheeled  
  bin” symbol on the product reminds you of your obliga- 
  tion, that when you dispose of the appliance it must be  
  separately collected.   
Consumers should contact their local authority or     
  retailer for information concerning the correct    
  disposal of their old appliance.
    
						

							12
GB
Care and maintenance 
Cutting off the water and electricity 
supplies
• Turn off the water tap after every wash cycle. This will 
limit wear on the hydraulic system inside the washing 
machine and help to prevent leaks.
•  Unplug the washing machine when cleaning it and du-
ring all maintenance work.
Cleaning the washing machine
The outer parts and rubber components of the appliance 
can be cleaned using a soft cloth soaked in lukewarm 
soapy water. Do not use solvents or abrasives.
Cleaning the detergent dispenser dra -
wer
Remove the dispenser by 
raising it and pulling it out 
(see figure).
Wash it under running wa-
ter; this operation should be 
repeated frequently.
Caring for the door and drum of your 
appliance
•  Always leave the porthole door ajar in order to prevent 
unpleasant odours from forming.
Cleaning the pump
The washing machine is fitted with a self-cleaning pump 
which does not require any maintenance. Sometimes, small 
items (such as coins or buttons) may fall into the pre-cham -
ber which protects the pump, situated in its bottom part.
 
!  Make sure the wash cycle has finished and unplug the 
appliance.
To access the pre-chamber:
1. using a screwdriver, 
remove the cover panel 
on the lower front part of 
the washing machine (see 
figure);
2. unscrew the lid by rota-
ting it anti-clockwise (see 
figure): a little water may 
trickle out. This is perfectly 
normal;
3. clean the inside thoroughly;
4. screw the lid back on;
5. reposition the panel, making sure the hooks are securely 
in place before you push it onto the appliance.
Checking the water inlet hose
Check the inlet hose at least once a year. If there are any 
cracks, it should be replaced immediately: during the wash 
cycles, water pressure is very strong and a cracked hose 
could easily split open.
! Never use second-hand hoses.
    
						

							GB
13
Troubleshooting
Your washing machine could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure 
that the problem cannot be not solved easily using the following list. 
Problem:
The machine does not switch on.
The wash cycle does not start.
The machine does not fill with wa-
ter or the indicator light for the first 
wash cycle stage flashes rapidly.
The machine continuously fills with 
water and continually drains away
or Water left in the drum
or Stuck on wash.
The machine does not drain or 
spin.
The machine does not heat or poor 
wash results.
The programme takes too long.
The machine vibrates a lot during 
the spin cycle.
Possible causes / Solutions:
•  The appliance is not plugged into the socket fully, or not enough to make contact.
•  There is no power to the socket, or the fuse has blown in the mains plug.
•  The door is not closed properly.
•  The ON/OFF button has not been pressed.
•  The START/PAUSE button has not been pressed.
•  The water tap has not been turned on to allow water to flow into the machine.
•  A delayed start has been set.
•  The water inlet hose is kinked.
•  The water inlet hose is not connected to the water supply.
•  The water pressure is too low.
•  The water tap has not been turned on to allow water to flow into the machine.
•  There is no water supply to the house.
•  The inlet valve filter is blocked.
•  The START/PAUSE button has not been pressed.
•  The top of the drain hose is too low - It must be fitted at a height between 65 
and 100 cm from the floor (see “Installation”).
•  The drain hose is connected incorrectly to the sink trap allowing water to run 
into the machine, the drain hose must be positioned higher than the bott\
om of 
the sink to prevent water flowing down the drain hose .
•  The end of the drain hose has been pushed too far down the standpipe, the 
‘U’ bracket should be fitted 100 mm from the end of the drain hose.
•  The Pump filter is blocked .
•  The drain hose is kinked  (see “Installation”).
•  New Installation -  The blanking cap or spigot has not been removed if   
connected under a sink.
•  The drain hose or sink trap is blocked .
•  The wash cycle does not include draining, some wash cycles require the drain 
phase to be started manually .
•  The ‘Spin Speed’ selector knob is in the 
 position .
•  The ‘Temperature’ selector knob is in the “
” position .
•  Programme times will vary due to water pressure, the incoming water tempera -
ture and if the wash load goes out of balance. This will increase the programme 
times accordingly (see ‘ The machine wont spin properly’ below) .
•  The feet have not been adjusted, enabling the machine to rock.
•  New Installation -  Either the Transit Bolts including the plastic spacers, or the 
Polystyrene Packaging have not been removed when installing the machine.
•  The machine is trapped between cabinets and/or walls .
•  The load is in a slight out of balance condition and machine is spinning, but at 
a lower speed .
    
						

							14
GBThe machine is noisy.
The machine wont spin properly.
The machine leaks from the  
dispenser.
The machine leaks (other than 
dispenser).
The indicator lights on the console 
are flashing rapidly.
The machine smells.
The machine door cannot be   
opened.
Door Seal damaged at the bottom.
The water level is too low when 
the machine is washing.
There is too much foam.
After completing the programme, 
or before starting a programme, 
the machine has turned itself off  
(no lights).
General. • 
There will always be some motor, pump and drum noise during spin .
•  Out of Balance detected when attempting to go into a spin cycle - If this 
happens the machine will continue to try to repeat the distribution of the load 
required before the machine will go into higher spin speeds - This will increase 
the programme time accordingly. This is a safety feature to prevent damage.  
Out of Balance can be caused by washing a single heavy item (eg duvet, \
quilt, 
etc).  - Try the programme again using a different load.
•  The dispenser drawer is blocked with detergent and requires cleaning.
•  The water pressure is too high and requires turning down - turn down the tap 
on the water supply pipe slightly and try again .
•  The machine is tilting forwards - It must be level when in its final position .
•  The fill hose is loose, check both the cabinet and tap ends .
•  The fill hose is tight but still leaks, if so replace the rubber washers, or the fill 
hose is missing the rubber washer .
•  The drain hose is not fixed in properly.
•  Switch off the machine and unplug it, wait for approximately 1 minute and then 
switch it back on again If the problem persists contact the Technical Assistance 
Service.
•  The machine requires a service wash. Run a 90 degree wash cycle with deter -
gent and no laundry.
•  The door will not open until the door lock indicator light goes out shortly after 
the program has finished.
•  The door seal has drainage holes at the bottom - This is normal.
•  The water level is correct if it can be seen at the bottom of the door.
•  The detergent is not suitable for machine washing (it should display the text   
‘for washing machines’ or ‘hand and machine wash’ or the like) .
•  Too much detergent was used - less detergent is required in soft water.
•  To comply with new energy saving regulations the machine is fitted with an 
automatic standby system. Press ‘ON/OFF’ button for 3 seconds to activate 
the machine, it can then either be switched off or a new programme selected.
•  Your washing machine contains sensors that monitor progress during the wash 
cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/pro-
gress).
   Normally, if your machine successfully completes the cycle, there is unlikely to  be anything wrong!
Remember, you will be charged for a service call for problems caused by incorrect installation, as listed 
above.
Not emptying contents from pockets may cause pump or drain blockages, or may damage the machine.\
Do not wash items which do not have a wash label, or wash items that are not intended as machine   
washable.
    
						

							GB
15
12 Months Parts and Labour Guarantee
Your appliance has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve  months from the date of purchase.
This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either  workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you.
This guarantee is subject to the following conditions:                                                                     
-  The appliance has been installed and operated correctly and in accordance with our operating and      
  maintenance instructions.
-  The appliance is used only on the electricity or gas supply printed on t\
he rating plate.
-  The appliance has been used for normal domestic purposes only.
-  The appliance has not been altered, serviced, maintained, dismantled, or otherwise interfered with by any     
  person not authorised by us.
-  Any repair work must be undertaken by us or our appointed agent.
-  Any parts removed during repair work or any appliance that is replaced become our property.
-  The appliance is used in the United Kingdom or Republic of Ireland.
The guarantee does not cover:
-  Damage resulting from transportation, improper use, neglect or interference or as a result of improper      
  installation.
-  Replacement of any consumable item or accessory . These include but are not limited to: 
  plugs, cables, batteries, light bulbs, fluorescent tubes and starters, covers and filters.
-  Replacement of any removable parts made of glass or plastic.
THIS GUARANTEE WILL NOT APPLY IF THE APPLIANCE HAS BEEN USED IN COMMERCIAL OR   
NON-DOMESTIC PREMISES.
5 Year Parts Guarantee
Indesit also offers you a free 5 year parts guarantee. This additional guarantee is conditional on y\
ou registering your appliance  with us and the parts being fitted by one of our authorised engineers. Ther e will be a charge for our engineer’s time. To 
activate the extra parts warranty on your appliance, simply call our registration line on 08448 24 24 24  (Republic of  Ireland 01 230 0800)
Extended Guarantees
We offer a selection of repair protection plans that enable you to fully cover yourself against the expen\
se of repair bills for the  life of your policy.  To find the ideal plan for you please call our advice line on 08448 226 226 (Republic of Ireland 01 230 0233).
Free Helpdesk Service
We have a dedicated team who can provide free advice and assistance with your appliance if you experience any techn\
ical  difficulties within the first 90 days of ownership. Simply call our Indesit\
 Service Hotline on  08448 224 224 (Republic of 
Ireland 0818 313 413)   for telephone assistance, or, where necessary, to arrange for an engineer to call.
Assistance
    
						

							16
GB
195082141.02 04/2010  -  Xerox Fabriano
After Sales Service
No one is better placed to care for your Indesit appliance during the course of its working life than \
us - the manufacturer.
Essential Contact Information
Indesit Service  
We are the largest service team in Europe offering you access to 400 skilled telephone advisors and 1100 fully quali\
fied  engineers on call to ensure you receive fast, reliable, local service.
UK: 08448 224 224
Republic of Ireland: 0818 313 413 www.indesitservice.co.uk
Please note: Our advisors will require the following information:  Model number: 
Serial number:
Parts and Accessories  
We supply a full range of genuine replacement parts as well as accessory products that protect and hygienically clean your  appliance to keep it looking good and functioning efficiently throughout its life.
UK: 08448 225 225
Republic of Ireland: 0818 313 413 www.indesitservice.co.uk 
Appliance Registration
We want to give you additional benefits of Indesit ownership. To activate your free 5 year parts guarantee you must  register your appliance with us.
UK: 08448 24 24 24
Republic of Ireland: 01 230 0800 www.indesitservice.co.uk
Indesit Company UK Ltd. Morley Way, Peterborough, PE2 9JB Indesit Company Unit 49 Airways Industrial Estate, Dublin 17
 Recycling & Disposal Information
As part of Indesit’s continued commitment to helping the environment, Indesit reserves the right to use quality, recycled 
components to keep down customer costs and minimise material wastage. 
Please dispose of packaging and old appliances carefully. To minimise the risk of injury to children, remove the door, plug 
and cut the mains cable off flush with the appliance.  Dispose of these parts separately to ensure that the appliance can 
no longer be plugged into a mains socket, and the door cannot be locked \
shut.