Indesit G85c Manual

Tumble dryer
Instructions for installation and use 

3
IMPORTANT 

4
CAUTION:
When the dryer is in use avoid touching the
rear of the dryer as it may be hot! 

Electrical Requirements
Supply
Changing
the fuse
Moulded plug
Changing
the plug
Rewirable plug
Changing the
mains cable
WARNING: This appliance must be earthed!
REFER TO THE RATING PLATE FOR VOLTAGE AND CURRENT
REQUIREMENTS. (see diagram for location.)
The flexible mains lead is supplied fitted with a BS1363 plug and
with a 13 amp BS1362 fuse.
The plug should be connected to the mains supply via a suitable
switched socket which is accessible after installing your dryer.
If it is necessary to fit a...

6
Features - Get to know the main parts of your dryer
Push here to
open door
NOTE: If your
dryer is new wipe
out the inside of
the drum before
you first  use  it   
to remove any
dust which may
have accumulated
during transit.
Water Container
(Empty after Each Load)
Air intake
grille
Plinth Moulding
(Not fitted to all models)
Serial & Model
numbers
Fluff filter
CLEAN AFTER
EACH LOAD
Door
catch
Rating Plate
Condenser
(Keep clear of fluff)
Clean periodicallyDoor latch
see The Controls 

7
HINGE
HINGE DOOR
LATCHDOOR
CATCH
Your Tumble Dryer should NOT be located adjacent to a gas hob,
cooker, heater or eye level grill as flames from the burners could
cause damage to your machine.. When the dryer is fitted under a
work surface, allow space for air to exit the rear grille, a 15mm gap
each side of the dryer is recommended. This airflow is essential to
condense the water produced drying the washing, the dryer will not
operate efficiently in an enclosed space or cupboard.
If using your dryer...

8
How to use your dryer
1. Plug in, switch
on electricity.2. Sort your laundry
(see section “Sorting
Your Laundry”)
3. Open the door
by pressing and
releasing the front
panel in the position
shown.4. Always check
the following:
5. Load the dryer
placing the
clothes carefully in
the drum pushing
them well towards
the back and
away from the
door seal. Close
the door.6. Select the alarm,
if required.
(see section “The
Controls”)7. Select the
required programme
or drying time.
(see section “The
Controls”)
8....

9
The Controls
Programme Control Start Switch
Alarm SwitchActive / Empty Water Light
To set the programme, all you have to do is turn the Programme
Control knob until the required selection appears in line with the
indicator.
Automatic programmes (for load sizes more than 1kg)
1. Dry Cottons  ( HIGH heat) This gives driest results.
Some bulky items or large load of towels 
may appear slightly damp after this 
programme and require a short period of 
timed drying.
2. Damp Cottons  ( HIGH heat)
3. Iron Dry...

10
The Controls
Indicator Lamp
Cool Tumble
phase
Crease Care
phaseThe indicator lamp turns orangeduring a drying programme when
the water container is full. When this happens, you must empty the
water container. The programme goes directly to the cooling phase
and the dryer stops. The orangelight warns you that the load will not
be dried correctly. Empty the water container and start the
programme again by pressing the start button.
At the end of the drying programme if the water container has filled
the...