Iiyama Prolite E2208hdsv 1 User Manual

							ENGLISH
1
F FF F
F1) Adjust the H.Position so that the left side of the picture frame will move to the left
edge of the display area.
NOTE„When the left side of the picture frame moves apart from the left edge of the display
area during the Pixel Clock adjustment, adjust steps 1) and 2).
„Another way to make the Pixel Clock adjustment is to correct the vertical wavy lines
in the zebra pattern.
„The picture may flicker during the Pixel Clock, H.Position and V.Position adjustment.
„In case the picture frame is bigger or smaller than the data display area after the Pixel
Clock adjustment, repeat steps from 
C. 2) Stretch the right side of the picture frame to the right edge of the display area by
adjusting the Pixel Clock.
C CC C
CPress the Auto Button. (Auto Adjust)
D DD D
DAdjust the image manually by following procedure below when the screen has a
flicker or blur, or the picture does not fit in the display area after performing the Auto
Adjust.
E EE E
EAdjust the V.Position so that the top and bottom of the picture frame will fit to the
display area.
NOTE
OPERATING THE MONITOR     16
PLE2208HDS-e-M043C01.P65 2008/11/28, 13:2421
 
						

							ENGLISH
17     OPERATING THE MONITOR
NOTE„In case the strong flicker or blurs remain on a part of the screen, repeat steps 
F and
G  because the Pixel Clock may not be adjusted correctly. If the flicker or blurs still
remain, set the refresh rate of computer to low (60Hz) and repeat steps from 
C
again.
„Adjust the H.Position after the Phase adjustment if the horizontal position moves
during the adjustment.
H HH H
HAdjust the Brightness and Color to get the desired picture after you complete the
Pixel Clock and Phase adjustments.
Put back your favorite wallpaper. G GG G
GAdjust the Phase to correct horizontal wavy noise, flicker or blur in the zebra pattern.NOTE
PLE2208HDS-e-M043C01.P65 2008/11/28, 13:2422
 
						

							ENGLISH
Even when using the power management mode, the monitor consumes electricity. Turn
off the Power Switch whenever the monitor is not in use, during the night and weekends,
to avoid unnecessary power consumption.NOTE„
It is possible that the video signal from the computer may be on while the H or V sync
signal is missing. In this instance, the POWER MANAGEMENT feature may not work
properly. „
POWER MANAGEMENT FEATURE
Power Management Mode
When the H-sync signal / V-sync signal / H and V sync signals from the computer are off, the
monitor enters into Power Management Mode which reduces the power consumption to less than
2W. The screen becomes dark, and the power indicator turns to orange. From Power Management
Mode, the image reappears in several seconds when either the keyboard or the mouse are
touched again. The power management feature of this product complies with power saving requirement of E
NERGY
STA R® and VESA DPMS. When activated, it automatically reduces unnecessary power consumption
of the monitor when your computer is not in use.
To use the feature, the monitor needs to be connected to a VESA DPMS compliant computer. There
is a power management step the monitor takes as described below. The power management function,
including any timer settings is configured by the operating system. Check your operating system
manual for information on how this can be configured.
„
0  2W 100% POWER
CONSUMPTION
Blue
Orange
Power Indicator
NORMAL MODE
POWER MANAGEMENT MODE
OPERATING THE MONITOR     18
PLE2208HDS-e-M043C01.P65 2008/11/28, 13:2423
 
						

							ENGLISH
19     TROUBLE SHOOTING
TROUBLE SHOOTING
Perform the adjustments described in OPERATING THE MONITOR, depending on the problem you
have. If the monitor does not get a picture, skip to 2.
2. Consult the following items if you cannot find an appropriate adjustment item in OPERATING THE
MONITOR or if the problem persists.
If you are experiencing a problem which is not described below or you cannot correct the
problem, discontinue using the monitor and contact your dealer or iiyama service center for
further assistance. 3.
Problem Check
†
†
†The AC socket is live. Please check with another piece of equipment.
†If the blank screen saver is in active mode, touch the keyboard or the
mouse.
†
Increase the Contrast and/or Brightness.
The computer is ON.
†
The Signal Cable is properly connected. †The Power Switch is turned ON.
A
†The signal timing of the computer is within the specification of the monitor.
(Power indicator
is orange.)†
If the monitor is in power management mode, touch the keyboard or the
mouse.
The screen is not
synchronized.†The Signal Cable is properly connected.
†The signal timing of the computer is within the specification of the monitor.B
†
The signal timing of the computer is within the specification of the monitor.
†The video output level of the computer is within the specification of the
monitor.
The screen
position is not in
the center.†The signal timing of the computer is within the specification of the monitor.
The screen is
too bright or too
dark.
The screen is
shaking. C
D
EThe video output level of the computer is within the specification of the
monitor. †
†The power voltage is within the specification of the monitor.
†
The signal timing of the computer is within the specification of the monitor. The computer is ON.
The Signal Cable is properly connected. †
† 1. If the monitor fails to operate correctly, please follow the steps below for a possible solution.
(Power indicator
is blue.)The picture does
not appear.
(Power indicator
does not light up.)
The Power Cable is firmly seated in the socket.
PLE2208HDS-e-M043C01.P65 2008/11/28, 13:2424
 
						

							ENGLISH
Problem Check
No sound.
†The Audio Cable is properly connected.
†F†The audio equipment (computer etc.) is ON.
†The Volume is turned up.
†The Mute is OFF.
The sound is too
loud or too quiet. G†The audio output level of the audio equipment is within the specification of
the monitor.
A strange noise is
heard. H†The Audio Cable is properly connected.
For better environment protection please dont dispose your monitor.
Please visit our web site: www.iiyama.com/recycle for monitor recycling.
RECYCLING INFORMATION
The audio output level of the audio equipment is within the specification of
the monitor.
TROUBLESHOOTING     20
PLE2208HDS-e-M043C01.P65 2008/11/28, 13:2425
 
						

							ENGLISH
21     APPENDIX
SPECIFICATIONS : ProLite E2208HDS
APPENDIX
LCD Panel
Size / Segment Driving system
a-Si TFT Active Matrix
Diagonal: 55cm  / 22
0.248mm H × 0.248mm V
Response time Pixel pitch
5ms (Typical)
Display ColorsApprox.16.7M
Sync FrequencyHorizontal: 31.0-83.0kHz, Vertical: 56-75Hz
Maximum Resolution1920 × 1080, 2.1 MegaPixels
Input Connector
D-Sub mini 15 pin, DVI-D 24 pin
Input Sync Signal
Separate sync: TTL, Positive or Negative Plug & PlayVESA DDC2B
TM
43W typical, Power management mode: 2W maximum* Power Consumption
Dimensions / Net Weight 516.5× 386.0 × 193.0mm / 20.3 × 15.2 × 7.6 (W×H×D)
4.2kg / 9.3lbs
Upward: 20 degrees  Downward: 5 degrees Viewable angle
Right / Left : 85 degrees each, Up:85 degrees, Down: 75 degrees (Typical)
Maximum Screen Size 476.64mm W × 268.11mm H / 18.8 W × 10.6 H
Power Source100-240VAC, 50/60Hz, 1.5A
Environmental
Considerations
Approvals
TCO ’03, CE, TÜV-GS /
MPR3(prEN50279) / ISO 13406-2,
VCCI-B Tilt Angle
* Condition: Audio equipment is not connected.
NOTE
Brightness
Contrast ratio300cd/m2 (Maximum)
1000 : 1 (Typical), ACR Function Available
Analog: 0.7Vp-p (Standard), 75Ω, Positive
Digital: DVI (Digital Visual Interface Standard Rev.1.0) compliance Input Video Signal
Input Audio  Signal 0.5Vrms maximum
Speakers 1W × 2 (Stereo speakers)
Input Audio  Connector ø 3.5mm mini jack (Stereo)
Operating: Temperature
Humidity
Storage:
-20 to 60°C / -4 to 140°F
Humidity5 to 35°C / 41 to 95°F
10 to 70% (No condensation)10 to 80% (No condensation)
Temperature
Model NameProLite E2208HDS-B1 ProLite E2208HDS-B2
2ms (Gray to Gray)
CE, TÜV-Bauart, VCCI-B
PLE2208HDS-e-M043C01.P65 2008/11/28, 13:2426
 
						

							ENGLISH
APPENDIX     22
SPECIFICATIONS : ProLite E2208HDSV
LCD Panel
Size / Segment Driving system
a-Si TFT Active Matrix
Diagonal: 55cm  / 22
0.248mm H × 0.248mm V
Response time Pixel pitch
2ms (Gray to Gray)
Display ColorsApprox.16.7M
Sync FrequencyHorizontal: 31.0-83.0kHz, Vertical: 56-75Hz
Maximum Resolution1920 × 1080, 2.1 MegaPixels
Input Connector
D-Sub mini 15 pin
Input Sync Signal
Separate sync: TTL, Positive or Negative Plug & PlayVESA DDC2B
TM
43W typical, Power management mode: 2W maximum* Power Consumption
Dimensions / Net Weight 516.5× 386.0 × 193.0mm / 20.3 × 15.2 × 7.6 (W×H×D)
4.2kg / 9.3lbs
Upward: 20 degrees  Downward: 5 degrees Viewable angle
Right / Left : 85 degrees each, Up:85 degrees, Down: 75 degrees (Typical)
Maximum Screen Size 476.64mm W × 268.11mm H / 18.8 W × 10.6 H
Power Source100-240VAC, 50/60Hz, 1.5A
Environmental
Considerations
Approvals
CE, TÜV-Bauart Tilt Angle
* Condition: Audio equipment is not connected.
NOTE
Brightness
Contrast ratio300cd/m2 (Maximum)
1000 : 1 (Typical), ACR Function Available
Analog: 0.7Vp-p (Standard), 75Ω, Positive
Input Video Signal
Input Audio Signal 0.5Vrms maximum
Speakers 1W × 2 (Stereo speakers)
Input Audio  Connector ø 3.5mm mini jack (Stereo)
Operating: Temperature
Humidity
Storage:
-20 to 60°C / -4 to 140°F
Humidity5 to 35°C / 41 to 95°F
10 to 70% (No condensation)10 to 80% (No condensation)
Temperature
PLE2208HDS-e-M043C01.P65 2008/11/28, 13:2427
 
						

							ENGLISH
23     APPENDIX
COMPLIANT TIMING
Dot Clock
  25.175MHz
  31.500MHz
  40.000MHz
  49.500MHz
  65.000MHz
  78.750MHz
  68.250MHz
108.000MHz
135.000MHz
106.500MHz
136.750MHz
162.000MHz
146.250MHz
138.500MHz
  25.175MHz
  28.322MHz Vertical
Frequency
59.940Hz
75.000Hz
60.317Hz
75.000Hz
60.004Hz
75.029Hz
60.000Hz
60.020Hz
75.025Hz
59.887Hz
74.984Hz
60.000Hz
60.000Hz
59.930Hz
70.087Hz
70.087Hz
VGA TEXT
VESA
SVGA VGA
XGA 1024 × 768640 × 480
800 × 600
640 × 350
Video Mode
SXGA
1280 × 1024
*
1
*1
WXGA1280 × 768
WXGA+ 1440 × 900Horizontal
Frequency
31.469kHz
37.500kHz
37.879kHz
46.875kHz
48.363kHz
60.023kHz
47.396kHz
63.981kHz
79.976kHz
55.935kHz
70.635kHz
75.000kHz
65.290kHz
66.590kHz
31.469kHz
31.469kHz
UXGA 1600 × 1200
WSXGA+1680 × 1050
Full HD1920 × 1080
720 × 400
PC Input
*1 DVI input is not compliant.NOTE
M043C01
DIMENSIONS
DIMENSIONS
60.5mm/2.4
386.0mm/15.2193.0mm/7.6312.1mm/12.3269.7mm/10.6
478.3mm/18.8516.5mm/20.3
237.3mm/9.3
PLE2208HDS-e-M043C01.P65 2008/11/28, 13:2428