HP V220 User Guide
Have a look at the manual HP V220 User Guide online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 1114 HP manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
21 Preset Display Modes Preset Pixel Format Horizontal Frequency (kHz) Ve r t i c a l Frequency (Hz) 1 640 x 480 31.47 59.94 2 640 x 480 37.50 75.00 3 720 x 400 31.47 70.08 4 800 x 600 37.88 60.32 5 800 x 600 46.88 75.00 6 832 x 624 49.72 74.55 7 1024 x 768 48.36 60.00 8 1024 x 768 60.02 75.03 9 1152 x 720 44.86 60.00 10 1152 x 870 68.68 75.06 11 1152 x 900 61.80 65.96 12 1280 x 768 47.396 60.00 13 1280 x 960 60.00 60.00 14 1280 x 1024 63.98 60.02 15 1280 x 1024 79.98 75.02 16 1440 x 900 55.94 59.89 17 1600 x 1000 61.648 60.00 18 1680 x 1050 65.29 60.00
22 Power Cord Set Requirements The monitor power supply is provided with automatic line switching (ALS). This feature allows the monitor to operate on input voltages in the range of 100–240V ∿, 50/60 Hz, 1.5A. The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the country/region where the equipment was purchased. If you need to obtain a power cord for a different country/region, you shou ld purchase a power cord that is approved for use in that country/region. The power cord must be rated for the product and for the voltage and current marked on the product’s electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the cross-sectional area of the wire must be a minimum of 0.75 mm² or 18AWG, and the length of the cord must be between 4.94 ft (1.5 m) and 12 ft (3.6 m). If you have questions about the type of power cord to use, co ntact your HP-authorized service provider. A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from the product. Pin Assignments Pin Number 15-Pin Side of the Signal Cable 1 Video-Red 2 Video-Green 3 Video-Blue 4 Ground 5 Detect Cable 6 GND-R 7 GND-G 8 GND-B 9 +5V 10 Ground 11 Ground 12 DDC-Serial data 13 H-sync 14 V- s y n c 15 DDC-Serial clock
23 Plug and Play DDC2B Feature This monitor is equipped with VESA DDC2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host system of its identity and, depending on the level of DDC used, communicate additional information about its display capabilities. The DDC2B is a bi-directional data channel based on th e I²C protocol. The host can request EDID information over the DDC2B channel. LCD Monitor Quality and Pixel Policy The HP LCD Monitor uses high-precisi on technology, manufactured according to high standards, to help guarantee trouble-free performance. Ne vertheless, the display may have cosmetic imperfections that appear as small bright or dark spots. This is common to all LCD displa ys used in products supplied by all vendors and is not specific to the HP LCD Monitor. These imperfections are caused by one or more defective pixels or subpixels. A pixel consists of one red, one green, and one blue subpixel. A defective whole pixel is always turned on (a bright sp ot on a dark background), or it is always off (a dark spot on a bright background). The first is the more visible of the two. A defective subpixel (dot defect) is le ss visible than a defective whole pixe l and is small and only visible on a specific background. To locate defective pixels, the moni tor should be viewed under normal operating conditions and in normal operating mode at a supported resolution and response rate, from a distance of approximately 50 cm (16 in). We expect that, over time, the industry will continue to im prove its ability to produce displays with fewer cosmetic imperfections, and we will adjust guidelines as improvements are made. For more information about your v220 Mo nitor, refer to the HP Web site at: http://www.hp.com/support Agency Regulatory Notices Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pr ovide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not o ccur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the in terference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit diffe rent from that to which the receiver is connected. Consult the dealer or an experienced ra dio or television technician for help.
24 Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Hewlett-Packard Company may void the user’s authority to operate the equipment. Cables Connections to this device must be made with shielded cables with me tallic RFI/EMI connector hoods to maintain compliance with FCC rules and regulations. Declaration of Conformity for Products Marked with FCC Logo, United States Only This device complies with Part 15 of the FCC Rules. Operation is subj ect to the following two conditions: (1) this device may not cause harmful interference, and (2 ) this device must accept any interference received, including interference that may cause undesired operation. For questions regarding yo ur product, contact: Hewlett-Packard Company P. O. Box 692000, Mail Stop 530113 Houston, Texas 77269-2000 Or call: 1-(800)-474-6836 For questions regarding this FCC declaration, contact: Hewlett-Packard Company P. O. Box 692000, Mail Stop 510101 Houston, Texas 77269-2000 Or call: 1-(281)-514-3333 To identify this product, refer to the part, series, or model number found on the product. Canadian Notice This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Avis Canadien Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
25 European Union Regulatory Notice This product complies with the following EU directives: Low Voltage Directive 2006/95/EC EMC Directive 2004/108/EC Compliance with these directives implies conformity to applicable harmonized European standards (European Norms) which are listed on the EU Declaration of Conf ormity issued by Hewlett-Packard for this product or product family. This compliance is indicated by the following conformity marking placed on the product: This marking is valid for non-Telecom products and EU harmonized Telecom products (e.g., Bluetooth). xxxx* This marking is valid for EU non-harmonized Telecom products. *Notified body number (used only if applicable — refer to the product label). Hewlett-Packard GmbH, HQ-TRE, Herrenberg er Straße 140, 71034 Böblingen, Germany
26 Disposal of Waste Equipment by Users in Private Households in the European Union This symbol on the product or on its packaging indicates th at this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste elec trical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disp osal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the environm ent. For more information about where you can drop off your waste equipment for recycling, plea se contact your local city office, your household waste disposal service or the shop wh ere you purchased the product. Japanese Notice
27 Japanese Power Cord Notice Japanese Material Content Declaration A Japanese regulatory requirement, defined by Specification JIS C 0950, 2005, mandates that manufacturers provide Material Content Declarations for certain categories of electronic products offered for sale after July 1, 2006. To view the JIS C 0950 material declarat ion for this product, visit www.hp.com/go/jisc0950. Korean Notice Materials Disposal This HP product contains Mercury in the fluorescent lamp in the display LCD that might require special handling at end-of-life. Disposal of this material can be regulated because of environmental considerations. For disposal or recycling information, please contact your local authoritie s or the Electronic Industries Alliance (EIA) ( www.eiae.org).
28 HP Recycling Program HP offers product end-of-life return programs for HP and other manufacturers’ hardware in several geographic areas. The terms and availability of these programs vary by geography because of differences in regulatory requirements and local customer demand. For information on the HP recycling program, refer to the HP Web site at: http://www.hp.com/recycle EPA ENERGY STAR® Compliance Products marked with the ENERGY STAR ® logo on the packaging box qualify with the U.S. Environmental Protection Agency’s ENERGY STAR® guidelines for energy efficiency. Products with the ENERGY STAR ® label are designed to use less energy, he lp you save money on utility bills, and help protect the environment. ENERGY STAR ® is a registered trademark ow ned by the U.S. government.