HP Deskjet F2420 User Manual
Here you can view all the pages of manual HP Deskjet F2420 User Manual. The HP manuals for Printer are available online for free. You can easily download all the documents as PDF.
Page 51
Make sure the margin settings for the document do not exceed the printable area of the product. To check your margin settings 1.Preview your print job before sending it to the product. In most software a pplications, click the File menu, and then click Print Preview. 2. Check the margins. The product uses the margins you have set in your software application, as long as they are greater than the minimum margins the product supports. For more information about setting margins in your software...
Page 52
want. In that case, turn off autocropping in the HP Solution Center software and crop the scanned image manually, or not at all. Cause:The software was set to automatically crop scanned pictures. Scanned image shows dotted lines instead of text Solution: Make a black-and-white copy of the original and then scan the copy. Cause: If you used the Text image type to scan text that you planned to edit, the scanner might not have recognized color text. The Text image type scans at 300 x 300 dpi, in black...
Page 53
Copy troubleshooting Use this section to solve these copy problems: • Parts of the original do not appear or are cut off • The printout is blank Parts of the original do not appear or are cut off Try the following solutions to resolve the issue. Solutions are listed in order, with the most likely solution first. If the first solution does not solve the problem, continue trying the remaining solutions until the issue is resolved. • Solution 1: Place the original correctly on the glass • Solution 2: Clean...
Page 54
•Solution 1: Place the original correctly on the glass • Solution 2: Check the ink levels in the print cartridges Solution 1: Place the original correctly on the glass Solution: Load your original print side down on the right front corner of the glass. Cause:The original was placed incorrectly on the glass. If this did not solve the issue, try the next solution. Solution 2: Check the ink levels in the print cartridges Solution: Check the estimated ink levels remaining in the print cartridges. NOTE:Ink...
Page 55
Flashing lights The lights on the product flash in special sequences to inform you about various error conditions. Refer to the following table for information on solving your error condition based on which lights are on or flashing on the product. On lightAttention lightInk attention lightsDescriptionSolution OffOffOffThe product is turned off.Press the On button to turn the product on. BlinkingOffOffThe product is processing a job.Wait for the product to finish. OnFast blinkingOnThe tape was not...
Page 56
On lightAttention lightInk attention lightsDescriptionSolution check that the carriage is not blocked. Fast blinkingFast blinkingBoth fast blinkingThe product has a fatal error.1.Turn off the product. 2. Unplug the power cord. 3. Wait a minute, then plug the power cord back in. 4. Turn on the product. If the problem persists, contact HP Support. OnOffOnPrint cartridge(s) are getting low on ink.Replace one or both print cartridges when print quality is no longer acceptable. OnOffTri-color print...
Page 57
Printing in ink-backup modeSolution: If you receive the ink-backup mode message and two print cartridges are installed in the product, verify that the protective piece of plastic tape has been removed from each print cartridge. When plastic tape covers the print cartridge contacts, the product cannot detect that the print cartridge is installed. 1Copper-colored contacts 2Plastic tape with pink pull tab (must be removed before installing) 3Ink nozzles under tape Cause: When the product detected that only...
Page 58
9 Stop the current job To stop a print job from the HP All-in-One ▲Press Cancel on the control panel. If the print job does not stop, press Cancel again. It can take a few moments for printing to be cancelled. Stop the current job 55 Stop the current job
Page 60
10 Technical information The technical specifications and international regulatory information for the HP All-in-One are provided in this section. For additional specifications, see the printed documentation that came with the HP All-in-One. This section contains the following topics: • Notice • Specifications • Environmental product stewardship program • Regulatory notices Notice Hewlett-Packard Company notices The information contained in this document is subject to change without notice. All rights...