Home > HP > Monitor > HP Compaq S1922 User Guide

HP Compaq S1922 User Guide

    Download as PDF Print this page Share this page

    Have a look at the manual HP Compaq S1922 User Guide online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 1114 HP manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							
    ENWW 25
    LCD Monitor Quality and Pixel Policy
    Your LCD Monitor uses high-precision technology, manufactured according to high 
    standards, to help guarantee trouble-free performance. Nevertheless, the display may 
    have cosmetic imperfections that appear as small bright or dark spots. This is 
    common to all LCD displays used in products supplied by all vendors and is not 
    specific to your LCD Monitor. These imperfections are caused by one or more 
    defective pixels or subpixels.
    A pixel consists of one red, one green, and one blue subpixel. A defective whole pixel 
    is always turned on (a bright spot on a dark background), or it is always off (a dark 
    spot on a bright background). The first is  the more visible of the two. A defective 
    subpixel (dot defect) is less visible than a  defective whole pixel, and is small and only 
    visible on a specific background.
    To locate defective pixels, the monitor should be viewed under normal operating 
    conditions and in normal operating mode at  a supported resolution and refresh rate, 
    from a distance of approximately 50 cm (16 inches). We expect that, over time, the 
    industry will continue to improve its ability  to produce displays with fewer cosmetic 
    imperfections, and we  will adjust guidelines as im provements are made. For more 
    information about your LCD Monitor,  refer to the HP Web site at: 
    http://www.hp.com/support .
     
    						
    							
    ENWW 26
    C. Agency Regulatory Notices
    Federal Communications Commission Notice
    This equipment has been tested and found to comply with the limits for a Class B 
    digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
    provide reasonable protection against harmful  interference in a residential installation. 
    This equipment generates, uses, and can r adiate radio frequency energy and, if not 
    installed and used in accordance with  the instructions, may cause harmful 
    interference to radio communications. Ho wever, there is no guarantee that 
    interference will not occur in a  particular installation. If this equipment does cause 
    harmful interference to radio or television reception, which can be determined by 
    turning the equipment off and on, the user is encouraged to try to correct the 
    interference by one or more of the following measures:
    Reorient or relocate the receiving antenna. 
    Increase the separation between the equipment and the receiver.
    Connect the equipment into an outlet on a circuit different from that to which the 
    receiver is connected.
    Consult the dealer or an experienced radio or television technician for help.
    Modifications
    The FCC requires the user to be notified  that any changes or modifications made to 
    this device that are not ex pressly approved by Hewlett Packard Company may void 
    the users authority to operate the equipment.
    Cables
    Connections to this device  must be made with shielded  cables with metallic RFI/EMI 
    connector hoods to main tain compliance with FCC Rules and Regulations.
     
    						
    							
    27 Appendix C.   Agency Regulatory NoticesENWW 
     
    Declaration of Conformity for Products Marked with the FCC Logo 
    (United States Only)
    This device complies with Part 15 of the  FCC Rules. Operation is subject to the 
    following two conditions:
    1. This device may not cause harmful interference.
    2. This device must accept any interference received, including interference that  may cause undesired operation.
    For questions regarding the product, contact:
    Hewlett Packard Company
    P. O. Box 692000, Mail Stop 530113
    Houston, Texas 77269-2000
    Or, call 1-800-HP-INVENT (1-800 474-6836)
    For questions regarding this FCC declaration, contact:
    Hewlett Packard Company
    P. O. Box 692000, Mail Stop 510101
    Houston, Texas 77269-2000
    Or, call (281) 514-3333
    To identify this product, re fer to the Part, Series, or Model number found on the 
    product.
    Canadian Notice
    This Class B digital apparatus meets all requirements of the Canadian Interference-
    Causing Equipment Regulations.
    Avis Canadien
    Cet appareil numérique de la classe B respecte toutes les exigences du Réglement 
    sur le matériel br ouilleur du Canada.
    German Ergonomics Notice
    HP products which bear the GS approval  mark, when forming part of a system 
    comprising HP brand computer s, keyboards and monitors that bear the GS approval 
    mark, meet the applicable ergonomic require ments. The installation guides included 
    with the products provide configuration information.
     
    						
    							
    ENWW 28
    Japanese Notice
    Korean Notice
    Power Cord Set Requirements
    The monitor power supply is provided with Automatic Line Switching (ALS). This 
    feature allows the monitor to operate on input voltages between 100
    −120V~ or 200−
    240V.
    The power cord set (flexible cord or wall plug) received with the monitor meets the 
    requirements for use in the country where you purchased the equipment.
    If you need to obtain a power cord for a different country, you should purchase a 
    power cord that is approved for use in that country.
    The power cord must be rated for the product and for the voltage and current marked 
    on the products electrical ratings label. The voltage and current rating of the cord 
    should be greater than the voltage and current rating marked on the product. In 
    addition, the cross-sectional area of the wire must be a minimum of 0.75 mm2 or 18 
    AWG, and the length of the cord must be between 6 feet (1.8 m) and 12 feet (3.6 m).
    If you have questions about the type of po wer cord to use, contact an authorized HP 
    service provider. A power cord should be routed  so that it is not likely to be walked on 
    or pinched by items placed upon it or against  it. Particular attention should be paid to 
    the plug, electrical outlet, and the point where the cord exits from the product.
     
    						
    							
    29 Appendix C.   Agency Regulatory NoticesENWW 
     
    Japanese Power Cord Requirements
    For use in Japan, use only the power cord received with this product.
     CAUTION:   Do not use the power cord received with this product on any other 
    products.
    Product Environmental Notices
    Materials Disposal
    This HP product contains mercury in the fluorescent lamp in the display LCD that 
    might require special handling at end-of-life.
    Disposal of this material can be regulate d because of environmental considerations. 
    For disposal or recycling information, cont act the local authorities or the Electronic 
    Industries Alliance (EIA)
    http://www.eiae.org .
    Disposal of Waste Equipment by Users in 
    Private Household in  the European Union
    This symbol on the product or on its packagi ng indicates that this product must not be 
    disposed of with your household  waste. Instead, it is your responsibility to dispose of 
    your waste equipment by handing it over to a designated collection point for the 
    recycling or waste electrical and electronic equipment. The separate collection and 
    recycling of your waste equipment at the time  of disposal will help to conserve natural 
    resources  and ensure that it is recycled in a manner that protects human health and 
    the environment. For more information about where you can drop off your waste 
    equipment for recycling, please contact th e local city office, the household waste 
    disposal service or the shop where you purchased the product.
    Chemical Substances
    HP is committed to providing our custom ers with information about the chemical 
    substances in our products as needed to comply with legal requirements such as 
    REACH (Regulation EC No 1907/2006 of the European Parliament and Council). A 
    chemical information report for this product can be found at  
    http://www.hp.com/go/reach .
    HP Recycling Program
    HP encourages customers to recycle used electronic hardware, HP original print 
    cartridges, and rechargeable batteries. For more information about recycling 
    programs, go to  http ://www.hp.com/recycle .
     
    						
    							
    ENWW 30
    Restriction of Hazardous Substances (RoHS)
    A Japanese regulatory requirement, defined by specification JIS C 0950, 2005, 
    mandates that manufacturers provide Mate rial Content Declarations for certain 
    categories of electronic products offered for  sale after July 1, 2006. To view the JIS C 
    0950 material declaration for this pr oduct, visit http://www.hp.com/go/jisc0950 
     
    						
    							
    ENWW 31
    Turkey EEE Regulation
    In Conformity  with the EEE Regulation
    EEE Yönetmeliğine Uygundur
     
    						
    All HP manuals Comments (0)

    Related Manuals for HP Compaq S1922 User Guide