HP 2509p User Guide

							User’s GuideB–1
B
Technical Specifications
All specifications represent the typical specifications provided by HP’s component manufacturers; actual performance 
may vary either higher or lower.
HP LCD Monitor
Face treatment: Glare polarizer with hard coating
Input Terminals:
■VGA connector (select models)
■DVI-D 24-pin D-type connector (select models)
■HDMI connector (select models)
Specifications
model 2309p
Display Type:
Viewable Image Size:
Tilt:
Maximum Weight (unpacked):
Dimensions (h x w x d):
Maximum Graphics Resolution:
Optimum Graphics Resolution:
Te x t  M o d e :
Dot Pitch:
Horizontal Frequency (analog mode):
Vertical Frequency (analog mode):
Environmental Requirements
Temperature (independent of altitude)
Operating Temperature:
Non-operating Temperature:
Relative Humidity (non-condensing):
Operating Humidity:
Non-operating Humidity:
Power Source:
Power Consumption:
Sleep Power Consumption:TFT LCD active matrix
23 in. (58.4 cm) diagonal
–5° to +25°
13.7 lb (6.2 Kg)
16.2 x 22.6 x 7.9 in. (412 x 573 x 200 mm)
1920 x 1080 @ 60 Hz analog mode
1920 x 1080 @ 60 Hz analog mode
720 x 400
0.30 x 0.30 mm
24 to 94 kHz
50 to 76 Hz
41° to 105° F (5° to 35° C)
–29° to 140° F (–20° to 60° C)
20% to 80%
5% to 95%
100–240Vv, 50/60 Hz
56 watts maximum

						

							Technical Specifications
B–2 Features may vary by model.User’s Guide
model 2509p
Display Type:
Viewable Image Size:
Tilt:
Maximum Weight (unpacked):
Dimensions (h x w x d):
Maximum Graphics Resolution:
Optimum Graphics Resolution:
Te x t  M o d e :
Dot Pitch:
Horizontal Frequency (analog mode):
Vertical Frequency (analog mode):
Environmental Requirements
Temperature (independent of altitude)
Operating Temperature:
Non-operating Temperature:
Relative Humidity (non-condensing):
Operating Humidity:
Non-operating Humidity:
Power Source:
Power Consumption:
Sleep Power Consumption:TFT LCD active matrix
25 in. (63.44 cm) diagonal
–5° to +25°
21.1 lb (9.6 Kg)
24.3 x 20.3 x 9.3 in. (617 x 515 x 235 mm)
1920 x 1080 @ 60 Hz analog mode
1920 x 1080 @ 60 Hz analog mode
720 x 400
0.29 x 0.29 mm
24 to 94 kHz
50 to 76 Hz
41° to 105° F (5° to 40° C)
–29° to 140° F (–20° to 60° C)
20% to 80%
5% to 95%
100–240Vv, 50/60 Hz
70 watts maximum

						

							Technical Specifications
User’s GuideB–3
Preset Video and High-Definition Modes
The monitor automatically recognizes many preset video input modes that will appear properly sized and centered 
on the screen. 
Factory Preset Video Input Modes, 2309p and 2509p
PresetResolution
Horizontal 
Frequency (kHz)Ve r t i c a l  
Frequency (Hz)
1 640 x 480 31.47 59.94
2 720 x 400 31.47 70.09
3 800 x 600 37.88 60.32
4 1024 x 768 48.36 60.00
5 1280 x 720 45.00 60.00
6 1280 x 960 60.00 60.00
7 1280 x 1024 63.98 60.02
8 1440 x 900 55.94 59.89
9 1600 x 1200 75.00 60.00
10 1680 x 1050 65.29 60.00
11 1920 x1080 67.50 60.00
High Definition Video Formats
PresetTiming NameResolution
Horizontal 
Frequency (kHz)Ve r t i c a l  
Frequency (Hz)
1 480p60 720 x 480 31.47 60
2 720p60 1280 x 720 45.00 60
3 576p50 720 x 576 31.25 50
4 720p50 1280 x 720 37.50 50
5 1080p60 1920 x 1080 67.50 60
6 1080p50 1920 x 1080 56.25 50
 
						

							Technical Specifications
B–4 Features may vary by model.User’s Guide
LCD Monitor Quality and Pixel Policy
The HP LCD Monitor uses high-precision technology, manufactured according to high standards, to help guarantee 
trouble-free performance. Nevertheless, the display may have cosmetic imperfections that appear as small bright or 
dark spots. This is common to all LCD displays used in products supplied by all vendors and is not specific to the 
HP LCD Monitor. These imperfections are caused by one or more defective pixels or subpixels.
■A pixel consists of one red, one green, and one blue subpixel.
■A defective whole pixel is always turned on (a bright spot on a dark background), or it is always off (a dark spot 
on a bright background). The first is the more visible of the two.
■A defective subpixel (dot defect) is less visible than a defective whole pixel, and is small and only visible on a 
specific background.
To locate defective pixels, the monitor should be viewed under normal operating conditions and in normal operating 
mode at a supported resolution and refresh rate, from a distance of approximately 16 inches (50 cm).
We expect that, over time, the industry will continue to improve its ability to produce displays with fewer cosmetic 
imperfections, and we will adjust guidelines as improvements are made.
For more information about your HP LCD Monitor, refer to the HP Web site at: http://www.hp.com/support
Power Cord Set Requirements
The monitor power supply is provided with Automatic Line Switching (ALS). This feature allows the monitor to operate 
on input voltages between 100–240Vv, 50/60 Hz, 1.5A.
The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the 
country/region where you purchased the equipment.
If you need to obtain a power cord for a different country/region, you should purchase a power cord that is 
approved for use in that country/region.
The power cord must be rated for the product and for the voltage and current marked on the product’s electrical 
ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked 
on the product. If you have questions about the type of power cord to use, contact your HP-authorized service 
provider.
A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or against 
it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from the 
product.
 
						

							User’s GuideC–1
C
Agency Regulatory Notices
Federal Communications Commission Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off and on, the user 
is encouraged to try to correct the interference by one or more of the following measures:
■Reorient or relocate the receiving antenna.
■Increase the separation between the equipment and the receiver.
■Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
■Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly 
approved by Hewlett-Packard Company may void the user’s authority to operate the equipment.
Cables
Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain 
compliance with FCC rules and regulations.
Declaration of Conformity for Products Marked with FCC 
Logo, United States Only
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this 
device may not cause harmful interference, and (2) this device must accept any interference received, including 
interference that may cause undesired operation.
For questions regarding your product, contact:
Hewlett-Packard Company
P. O. Box 692000, Mail Stop 530113 
Houston, Texas 77269-2000
Or
Call: 1-800-474-6836
For questions regarding this FCC declaration, contact:
Hewlett-Packard Company
P. O. Box 692000, Mail Stop 510101
Houston, Texas 77269-2000
Or
Call: 1-281-514-3333
To identify this product, refer to the part, series, or model number found on the product.
 
						

							Agency Regulatory Notices
C–2 Features may vary by model.User’s Guide
Materials Disposal
This HP product contains mercury in the fluorescent lamp in the display LCD that might require special handling at 
end-of-life:
Disposal of this material can be regulated because of environmental considerations. For disposal or recycling 
information, contact your local authorities or the Electronic Industries Alliance (EIA) (http://www.eiae.org).
Chemical Substances
HP is committed to providing our customers with information about the chemical substances in our products as 
needed to comply with legal requirements such as REACH (Regulation EC No 1907/2006 of the European 
Parliament and the Council). A chemical information report for this product can be found at: 
http://www.hp.com/go/reach
Canadian Notice
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Avis Canadien
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du 
Canada.
European Union Regulatory Notice
This product complies with the following EU Directives:
■Low Voltage Directive 2006/95/EC
■EMC Directive 2004/108/EC
Compliance with these directives implies conformity to applicable harmonized European standards (European 
Norms) which are listed on the EU Declaration of Conformity issued by Hewlett-Packard for this product or product 
family.
This compliance is indicated by one of the following conformity markings placed on the product:
Hewlett-Packard GmbH, HQ-TRE, Herrenberger Straße 140, 71034 Böblingen, Germany
 
XXXX*
This marking is valid for 
non-Telecom products and for EU 
harmonized Telecom products 
(for example, Bluetooth).This marking is valid for EU 
non-harmonized Telecom products.
*Notified body number (used only if 
applicable—refer to the product label).
 
						

							Agency Regulatory Notices
User’s GuideC–3
Disposal of Waste Equipment by Users in Private 
Households in the European Union
This symbol on the product or on its packaging indicates that this product must not be disposed of 
with your other household waste. Instead, it is your responsibility to dispose of your waste 
equipment by handing it over to a designated collection point for the recycling of waste electrical 
and electronic equipment. The separate collection and recycling of your waste equipment at the 
time of disposal will help to conserve natural resources and ensure that it is recycled in a manner 
that protects human health and the environment. For more information about where you can drop 
off your waste equipment for recycling, please contact your local city office, your household waste 
disposal service or the shop where you purchased the product.
Japanese Notice
Japanese Power Cord Notice
Japanese Material Content Declaration
A Japanese regulatory requirement, defined by Specification JIS-C-0950, 2008, mandates that manufacturers 
provide Material Content Declarations for certain categories of electronic products offered for sale after July 1, 
2006. To view the JIS-C-0950 material declaration for this product, visit www.hp.com/go/jisc0950
Korean Notice
 
						

							Agency Regulatory Notices
C–4 Features may vary by model.User’s Guide
EPA ENERGY STAR® Compliance
Products marked with the ENERGY STAR® logo on the packaging box qualify with the U.S. 
Environmental Protection Agency’s ENERGY STAR
® guidelines for energy efficiency.
Products with the ENERGY STAR
® label are designed to use less energy, help you save money on 
utility bills, and help protect the environment.
ENERGY STAR
® is a registered trademark owned by the U.S. government.
HP Recycling Program
HP offers product end-of-life return programs for HP and other manufacturers’ hardware in several geographic areas.
The terms and availability of these programs vary by geography because of differences in regulatory requirements 
and local customer demand. For information on the HP recycling program, refer to the HP Web site at: 
http://www.hp.com/recycle
Republic of Turkey EEE Regulation
Republic of Turkey: In conformity with the EEE Regulation.
 
						

							Agency Regulatory Notices
User’s GuideC–5
The Table of Toxic and Hazardous Substances/Elements and their Content 
as required by China’s 
Management Methods for Controlling Pollution by Electronic Information Products 
Toxic and Hazardous Substances and Elements
Part Name Lead
(Pb)
Mercury
(Hg)
Cadmium
(Cd)
Hexavalent
Chromium
(Cr(VI))
Polybrominated
biphenyls (PBB) 
Polybrominated
diphenyl ethers 
(PBDE)
Liquid Crystal Display 
PanelX X  O  O  O  O 
Chassis/OtherXOOOOO
O: Indicates that this toxic or hazardous substance contained in all of the homogeneous materials for this part is below 
the limit requirement in SJ/T11363-2006.
X: Indicates that this toxic or hazardous substance contained in at least one of the homogeneous materials used for this 
part is above the limit requirement in SJ/T11363-2006.
All parts named in this table with an “X” are in compliance with the European Union’s RoHS Legislation – “Directive 
2002/95/EC of the European Parliament and of the Council of 27 January 2003 on the restriction of the use of certain 
hazardous substances in electrical and electronic equipment”. 
Note: The referenced Environmental Protection Use Period Marking was determined according to normal operating use 
conditions of the product such as temperature and humidity. 
	


	


	


(Pb)
(Hg)
(Cd)
(Cr(VI))

(PBB)

(PBDE)
X X O  O  O  O 
	/
XOOOOO
O
SJ/T11363-2006 !#$%&(
X
)*+,-.SJ/T
11363-2006 !#$%(
X”	

RoHS!
“
/
200312701123 !2002/95/EC#$%&
 !#
$%&()*+),-.
 
						

							Agency Regulatory Notices
C–6 Features may vary by model.User’s Guide