Home > Honeywell > Control panel > Honeywell control panel VISTA32FBVISTA128FB User Manual

Honeywell control panel VISTA32FBVISTA128FB User Manual

Here you can view all the pages of manual Honeywell control panel VISTA32FBVISTA128FB User Manual. The Honeywell manuals for Control panel are available online for free. You can easily download all the documents as PDF.

Page 61

 
 
– 61 – 
Quick Guide To System Functions 
FUNCTION PROCEDURE COMMENTS 
Check Zones  Press [✱].  To view faulted zones when is system not ready 
Display All 
Descriptors Press and hold [✱] for 5 seconds.  Displays all alpha descriptors programmed by 
installer. 
Arm System  Enter code. 
Press arming key desired (AWAY, 
STAY, INSTANT, MAXIMUM). Arms system in mode selected. 
 
Disarm System  Enter code.  Press OFF [1].  Disarms system and silences alarms. 
Bypass Zones  Enter code.  Press BYPASS [6]....

Page 62

 
 
– 62 – 
Quick Guide To System Functions (cont’d) 
FUNCTION PROCEDURE COMMENTS 
Delete a User  Enter master/manager code. 
Press CODE [8]. 
Enter user no. to be deleted. 
Enter master/manager code. 
Press 1 (Yes) at prompt. Master & Manager level users can delete users. 
A user can only be deleted by a user with 
higher authority level. 
Enter security code.  Press [#] 
Enter 71 or 72. Activate output device as programmed. 
Enter security code.  Press [#] 
Enter 70. Activate output device manually...

Page 63

 
 
– 63 – 
Summary Of Audible Notification 
(Alpha Display Keypads) 
SOUND CAUSE  DISPLAY 
LOUD, 
INTERRUPTED* 
  Keypad & External FIRE ALARM FIRE is displayed; descriptor of zone in alarm is 
displayed. 
LOUD, 
CONTINUOUS* 
  Keypad & External BURGLARY/AUDIBLE EMERGENCY 
ALARM  ALARM  is displayed; descriptor of zone in alarm is 
also displayed. 
ONE SHORT BEEP 
 (not repeated) 
Keypad only a. SYSTEM DISARM   
b.  SYSTEM ARMING  ATTEMPT 
WITH AN OPEN ZONE. 
c.  BYPASS VERIFY  a. DISARMED/READY TO ARM...

Page 64

 
 
– 64 – 
 UL NOTICE: This is a “GRADE A” system. 
“FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15 STATEMENT” 
This equipment has been tested to FCC requirements and has been found acceptable for use.  The FCC 
requires the following statement for your information: 
This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in 
strict accordance with the manufacturer’s instructions, may cause interference to radio and television 
reception. It has been...

Page 65

 
 
– 65 – 
 
 “FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 68 NOTICE 
This equipment complies with Part 68 of the FCC rules. On the front cover of this equipment is a 
label that contains, among other information, the FCC registration number and ringer equivalence 
number (REN) for this equipment. If requested, this information must be provided to the 
telephone company. 
This equipment uses the following jacks: 
  An RJ31X is used to connect this equipment to the telephone network. 
The REN is used to...

Page 66

 
 
– 66 – CANADIAN DEPARTMENT OF COMMUNICATIONS  
(DOC) STATEMENT 
 
NOTICE 
The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction. 
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local...

Page 67

 
 
– 67 – 
WARNING!   
THE LIMITATIONS OF THIS ALARM SYSTEM While this system is an advanced design security system, it does not offer guaranteed protection against burglary or fire or other emergency. Any alarm system, whether commercial or residential, is subject to compromise or failure to warn for a variety of reasons. For example:   Intruders may gain access through unprotected openings or have the technical sophistication to bypass an alarm sensor or disconnect an alarm warning device. ...

Page 68

 
 
– 68 – 
Index 
#70 command ............................................... 42 
4285 or 4286 VIP module ......................... 9, 42 
AC Loss ........................................................ 57 
Access Another Partition............................... 21 
Access Control Commands .......................... 49 
Access Door.................................................. 41 
Action Code .................................................. 48 
Action Specifier...

Page 69

 
 
– 69 – 
Memory of Alarm ....................................... 7, 34 
Messages ...................................................... 37 
Modem Comm............................................... 57 
MULTI-ACCESS ........................................... 19 
Not Ready ..................................................... 26 
Off ................................................................. 21 
OFF ............................................................... 34 
Open Zones...

Page 70

 
 
– 70 – 
 
LIMITED WARRANTY 
Honeywell International Inc., 165 Eileen Way, Syosset, New York 11791, warrants its product(s) to be 
in conformance with its own plans and specifications and to be free from defects in materials and 
workmanship under normal use and service for 24 months from the date stamp control on the 
product(s) or, for product(s) not having a date stamp, for 12 months from date of original purchase 
unless the installation instructions or catalog sets forth a shorter period, in...
Start reading Honeywell control panel VISTA32FBVISTA128FB User Manual

Related Manuals for Honeywell control panel VISTA32FBVISTA128FB User Manual

All Honeywell manuals