Hitachi Projector CP-X265 User Manual

6

Troubleshooting
Regarding the indicator lamps (continued)
POWER 
indicator
LAMP 
indicator
TEMP 
indicatorDescription
Blinking
In Red
or
Lighting
In Red
Turned
off
Blinking
In Red
The cooling fan is not operating.
Please turn the power off, and allow the projector to 
cool down at least 
 0 minutes. After the projector has 
sufficiently cooled down, please make confirmation 
that no foreign matter has become caught in the fan, 
etc., and then turn the power on again.
If the same indication...

6

Troubleshooting
Phenomena that may be easy to be mistaken for machine defects
WARNING  ►Never use the projector if abnormal operations such as 
smoke, strange odor, excessive sound, damaged casing or elements or cables, 
penetration of liquids or foreign matter, etc. should occur. In such cases, 
immediately turn off the power switch and then disconnect the power plug from 
the power outlet. After making sure that the smoke or odor has stopped, contact 
your dealer or service company.
....

63

Phenomena that may be easy to be mistaken for machine defects (continued)
PhenomenonCases not involving a machine defectReference
page
Sound does not 
come out.
The signal cables are not correctly connected.
Correctly connect the audio cables. ,  3
The MUTE function is working.
Restore the sound pressing the MUTE or VOLUME button 
on the remote control. 8
The volume is adjusted to an extremely low level.
Adjust the volume to a higher level using the menu function 
or the remote...

64

Phenomena that may be easy to be mistaken for machine defects (continued)
PhenomenonCases not involving a machine defectReference
page
Pictures appear 
dark.
The brightness and/or contrast are adjusted to an 
extremely low level.
Adjust BRIGHTNESS and/or CONTRAST settings to a 
higher level using the menu function. 5,   6
The WHISPER function is working.
Select NORMAL for the WHISPER item in the SETUP 
menu.
 6, 35
The lamp is approaching the end of its product 
lifetime.
Replace the...

65

Warranty And After-Ser vice
Warranty and after-service
If a problem occurs with the equipment, first refer to the “Troubleshooting” and run 
through the suggested checks. If this does not resolve the problem, please contact your 
dealer or service company. They will tell you what warranty condition is applied.
Specifications
Specifications
NOTE  • These specifications are subject to change without notice.
ItemSpecification
Product nameLiquid crystal projector
Liquid
Crystal
panel
Panel size .6...

66
Specifications
Specifications (continued)
AC  IN
AUDIO IN3
AUDIO IN2
YRLCB/PBCR/PRAUDIO IN1RGB IN1 RGB IN2
LAN
CONTROLRGB OUT AUDIO OUT
USBVIDEOS-VIDEO
306 mm
49 mm

0 mm

06 mm