Home > Hitachi > Planer > Hitachi F20a Manual

Hitachi F20a Manual

Add to Favourites
    Download as PDF

    View the Hitachi F20a Manual for free. All the Hitachi manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 MODEL F 20A -# 1 - 1. NOTES ON DISASSEMBLY AND REASSEMBLY As notes concerning usage are presented in the Handling Manual, notes on disassembly, assembly and repair are presented here. The bottom surfaces of the front and rear bases must be kept level and parallel at all times. The power source cord must be un- plugged from the electric outlet during all disassembly, assembly and repair procedures. 1-1. Set Gauge Adjustment In addition to the items presented in the Handling Manual, supplementary...
    Page 2 -#2 - can be at the same surface as the rear base. However the L sizes in Fig. 1 and Fig. 2 are checked for accuracy before the shipment, the L size in Fig. 2 has possi- bility to differ from the L size in Fig . 1. For this reason, it is necessary to ask customers to double check the L sizes in Fig. 1 and Fig. 2. The first time the customer removes the blade holder and the L size in Fig. 2 must be checked to confirm that it coincides with the L size in Fig. 1. The setting gauge should be adjusted with...
    Page 3 -#3 - armature 12 and cutter block 16 are extracted together with end bracket 28, by lightly pounding the shaft of armature 12 and the end of spindle cutter block 16 with a wooden hammer, the fitting the handle of a box spanner, or some similar instrument. B. Removing the Stator 1. After removing the stator, the handle cover is removed by unscrewing M4 plus head machine tapping screws 29. (4 pcs.). 2. Then, cut the connector (of the lead wire from cord 43, condenser 41, and stator 4) as close to...
    Page 4 -#4 - 2. Pulley (A) 54 and pulley (B) 55 are screwed (right hand screw and left hand screw respectively) on the armature shaft and the cutter spindle. Pulley (A) 54 is removed by setting a spanner on the pulley, holding armature 12 firm with a vise, and rotating the spanner in the clockwise direction. 3. Pulley (B) 55 is removed by setting a spanner on the pulley, holding the cutter block firm with a vise, and rotating the spanner in the counterclockwise direction. It is thick rag to prevent injury to...
    Start reading Hitachi F20a Manual
    All Hitachi manuals