Hitachi Cp-S220w Users Manual

1-11
O OP
PE
ER
RA
AT
TI
IO
ON
NS
S 
 (
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
ENGLISH
Setup Menu
The following adjustments and settings are
possible when SETUP is selected at the top of
the menu. Part of the Setup menu differs
between RGB input and VIDEO/S-VIDEO
input. Select an item with the  and 
buttons, and start operation. Use the Single menu
to reduce menu size (see Table 1.2 MENU
SELECT).
Table 1.3 Setup Menu
Video
RGB
BRIGHT
CONTRAST
V POSIT
H POSIT
H PHASE
H SIZE
COUL BAL  R
COUL BAL  B
ASPECT0
-2
+1...

1-12
O OP
PE
ER
RA
AT
TI
IO
ON
NS
S 
 (
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
Input Menu
The following functions are available when INPUT is selected on the
menu. Select an item with the  and  buttons, and start or stop
operation with the  and  buttons.
Table 1.4 Input Menu
fH:38kHz
fV:60HzRGB
VIDEO
AUTOSETUP INPUT OPT.IMAGE
ItemDescription
RGB
Displays RGB input frequency:Displays the horizontal and vertical sync
signal frequency for RGB input.
* It is effective only at the time of input of RGB.
VIDEO
Select...

1-13
O OP
PE
ER
RA
AT
TI
IO
ON
NS
S 
 (
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
ENGLISH
Image Menu
The following adjustments and settings are available when IMAGE is
selected on the menu. Select an item with the  and  buttons, and 
start operation.
Table 1.5 Image Menu
KEYSTONE
BLANK
MIRROR
START UP+1SETUP INPUT OPT.IMAGE
ItemDescription
KEYSTONEAdjustment:
Reduce size of bottom of image 
↔Reduce size of top of image 
BLANK
Select blank screen color:Select color with the  and  buttons.
* The image is cleared...

1-14
O OP
PE
ER
RA
AT
TI
IO
ON
NS
S 
 (
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
Options Menu
The following adjustments and settings are available when OPTIONS is
selected on the menu. Select an item with the  and  buttons, and
start operation.
Table 1. 6 Options Menu
VOLUMEMENU COLORTIMER
LANGUAGE
AUTO OFF
SYNC ON G128
SETUP INPUT OPT.IMAGE
ItemDescription
VOLUMEVolume adjustment:Reduce VOLUME ↔Increase VOLUME 
MENU COLORSelect menu background color:Select with the  and  buttons.
TIMER
Operation start/stop:Press...

1-15
O OP
PE
ER
RA
AT
TI
IO
ON
NS
S 
 (
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
ENGLISH
No Signal Menu
The same adjustments and settings are available as with the Image and
Options menus when the MENUO button is pressed during display of the
‘NO INPUT IS DETECTED ON ***’ or ‘SYNC IS OUT OF RANGE
ON ***’ message while no signal is received. See Table 1.7 below.
Table 1.7 No Signal Menu
VOLUME
KEYSTONE
BLANK
MIRROR
START UP
MENU COLORTIMER
LANGUAGE
AUTO OFF
SYNC ON G40
+1
ItemDescription
VOLUMEVolume...

* For disposal of used lamp, treat according to the instruction of community authorities.
* Since the lamp is made of glass, do not apply shock to it and do
not scratch it.
* Also, do not use old lamp. This could also cause explosion of the
lamp.
* If it is probable that the lamp has exploded (explosive sound is
heard), disconnect the power plug from the power outlet and ask
your dealer to replace lamp. 
The lamp is covered by front glass and air-tight structure, but, in
rare cases, the reflector and the...

1-17
M MA
AI
IN
NT
TE
EN
NA
AN
NC
CE
E 
 (
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
ENGLISH
Replacing the Lamp
1. Switch the projector OFF, remove the power cord from the power
outlet, and wait at least 45 minutes for the unit to cool.
2. Prepare a new lamp.
3. Check that the projector has cooled sufficiently, and gently turn it
upside down.
4. Remove the two screws as shown in the diagram, and remove the lamp
cover.
5. Remove the ond screw, and gently remove the lamp while holding the
grips. Touching the inside...

1-18
M MA
AI
IN
NT
TE
EN
NA
AN
NC
CE
E 
 (
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
Air Filter Maintenance
The air filter should be cleaned as described below at intervals of approximately 100 hours.
1. Switch the projector power supply OFF, and remove the
power cord from the power outlet.
2. Remove the air filter as shown in the diagram.
3. Vacuum the air filter.
4. Replace the air filter with the reverse procedure.
Other Maintenance
Inside maintenance
Ask a store for cleaning, the check toward an approximate...

1-19
ENGLISH
TROUBLESHOOTING
OSD Message
A message like the bottom table sometimes displays it with this opportunity at the time of power
source on.
Cope in accordance with the bottom table if message appears on the screen.
Table 1-8. Mssage display list.
MessageContents
CANGE THE LAMP
AFTER REPLACING LAMP,
RESET THE LAMP TIME.
*1)
Left message is displayed when ramp use time is 1700 hours.
The use time of the ramp draws near in the life.
A power source is turned off automatically when the use time
of...

1-20
T TR
RO
OU
UB
BL
LE
ES
SH
HO
OO
OT
TI
IN
NG
G 
 (
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
Indicators Message
The POWER indicator, LAMP indicator and TEMP indicator light or blink in the following cases.
Table 1-9. Indicators Message list
POWER
indicatorLAMP
indicatorTEMP
indicatorContents
Lights
orangeTurns offTurns offStandby status
Blinks
greenTurns offTurns offWarming up. Wait.
Lights
greenTurns offTurns offOperation status.
Blinks
orangeTurns offTurns offCool down.
Lights
redLights
redTurns off
The lamp...