Hitachi 42pd8a10 Instructions For Use

-10-
and 9. The TV will switch to the selected
programme after a short delay.
• For a two digit programme number enter thesecond digit after pressing the first digit
within 2 seconds.
Menu System
Your TV has been designed with a menu
system to provide easy manipulation of a
multifunction system.
Press the
button to enter the menu.
Press
_/`button to select a menu title and
then
a/bbutton to select a menu item and
_/`or “ OK ” button to enter the menu item.
•Pressthe
button to exit the menu.
•Pressthe...

-11-
ing films to see the fast motion scenes
clearly.
3D Comb
3D Comb is used to improve colour transi-
tions and colour quality of pictures.
By pre ssing
a/bbutton, select3D Comb.
Press
_/`button to set this feature On or
Off.
Reset
By pressing
a/bbutton, select Reset.
Press
_/`or “ OK” button to reset the picture
modes to factory default settings.
Sound menu
By pressing_/`button, select the second
icon. Sound menu appears on the screen.
Vo l u m eSOUND
EqualizerBalance
Headphone
Sound Mode 10
0...

-12-
volume
By pressing
a/bbutton, selectVolume.
Press
`button to increase hp volume level.
Press
_button to decrease hp volume level.
Headphone volume level can be adjusted
between 0 and 63.
sound mode
By pressing
a/bbutton, select Sound
Mo de. Press
_/`button to change sound
mode.
Sound mode is used to identify sound mode of
the headphone and can be set to mono, ste-
reo, dual a or dual baccording to the transmis-
sion.
balance
By pressing
a/bbutton, select Balance.
Press
`button to increase balance...

-13-
Sleep Timer
By pressing
a/bbutton, selectSleep
Ti mer. The timer can be programmed be-
tween Off and 2 hours in steps of 10 min-
utes by pressing
_/`button. If sleep timer
is activated, at the end of the selected time,
the TV goes automatically to stand-by mode.
Child Lock
You can use this feature to prevent children
turning the TV on or changing programs or
adjustments etc. without remote control.
The child lock feature can be set by
_/`but-
ton to either onoroff. W hen offis selected,
there will...

-14-
Pixel Shift: This item can be set to off,5,
10, 20, 40 min. or 1 hour. W hole picture is
shifted 2 pixels in the directions of the figure
shown below.
f
ff
ff1
2
3 4
5Pixel
The time entered in this setting refers to the
time between the picture being moved. If you
are using games consoles or similar set to
5 mins but try not to leave static images on
the screen for long periods of time.
Install menu
By pressing_/`button, select the fourth
icon. Install menu appears on the screen.
ProgramINSTALL...

-15-
Program menu
By pressing_/`button, select the fifth icon.
Program menu appears on the screen.
PROGRAM01 ITV
02 ZDF
03 CH5
04 C - 02
05 C - 05
06 C - 06
07 C - 08
08 C - 21
09 C - 23
10 C - 35 11 C - 4 3
12 C - 64
13 C - 68
14 S - 40
15 -----
16 -----
17 -----
18 -----
19 -----
20 -----
NameInsert
Delete APS
By moving the cursor in four directions you
can reach 20 programmes in the same
page. You can scroll the pages up or down
by pressing the navigation buttons to see all
the programmes in TV mode...

-16-
PC Mode
Installation
• Power off both Computer and Display beforemaking any connections.
• Set your PC’s resolution correctly before conne cting to the TV. Se e the ta ble on pa g e
25 for supported modes.
• Use a D-SUB cable to connect the TV’s PC input to the computer’s RGB output termi-
nal.
15 Pin Mini D-Sub Connector
• Tighten the screws of the Display cable untilthe connectors are fastened securely (fin-
ger-tighten only).
Menu System in PC mode
Press thebutton. The menu will be dis-
played...

-17-
PC PICTUREContrastBrightness
RG32 30 46
32Colour TempNormal
Reset B
32
Contrast, Brightness and Colour Tempera-
ture adjustments in this menu are identical
to adjustments defined in TV picture menu.
W hen Colour Temp is Manual, you can also
adjust the R,G,B items. R, G and B adjust
the TV image colour in PC mode. You can
change the TV colour to your desired colour:
R (Red), G (Green), B (Blue)
Select Resetand press
_/`or “OK” button
to reset the picture modes to factory default
settings.
Sound...

-18-
Source restrictions of PAP Mode are same
as in PIP Mode.
Freeze Picture
You can freeze the picture on the screen by
pressing the
button. AtPIPand PAP lay-
outs; only the main picture can be frozen.
Zoom Modes
Zoom mode can be changed by pressing
the
button. You can change the screen
size according to the picture aspect ratio. Se-
lect the optimum one from the following
ZOOM modes.
Note:You can only choose 4:3 and FULL in PC
mode.
Auto:
W hen a WSS (Wide Screen Signalling) sig-
nal, which shows the...

-19-
Teletext
Teletext is an information system that dis-
plays text on your TV screen. Using the Tele-
text information system you can view a page
of information on a subject that is available
in the list of contents (index).
To Operate Teletext
• Select a TV station where Teletext is beingtransmitted.
• Press the
button.Usuallythelistofcon-
tents (index) is displayed on the screen.
To Select A Page Of Teletext
• Press the appropriate digit buttons for the required Teletext page number.
The selected...