Home > Heckler and Koch > Firearms > Heckler And Koch HK SL8-1 Operators Manual

Heckler And Koch HK SL8-1 Operators Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Heckler And Koch HK SL8-1 Operators Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 26 Heckler and Koch manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							41
    TROUBLESHOOTING GUIDE
    40TROUBLESHOOTING GUIDEStoppages and Malfunctions
    In the event of stoppages on the SL8-1, the weapon is to be considered
    loaded until the actual cause of the stoppage has been determined.
    During the elimination of stoppages, safety precautions are to be taken
    into account.
    If in the event of stoppages on the SL8-1, the cartridge fired from the
    SL8-1 is not ignited; the bolt assembly does not close completely; or the
    spent cartridge case is not ejected; then the following steps must be
    taken immediately
    1 • Put the SL8-1safety/selector lever on “Safe”
    2 • Remove the magazine
    3 • Unload the SL8-1
    4 • Ensure that barrel, cartridge chamber and receiver are free
    of obstacles
    5 • Determine and eliminate the cause of the stoppageStoppage, Fault Cause Remedy
    Cartridge is not ignited Ammunition fault (dud) Recock SL8-1 
    (dud round)
    Tip of firing pin damaged Contact HK for repair
    or broken
    Hammer spring damaged Contact HK for repair 
    or broken
    Bolt fails to open Cartridge case stuck in Unload: retract bolt to  
    after being fired chamber due to deform- eject cartridge case,
    ation or dirty chamber clean if fouled. If 
    required, contact HK 
    for repair
    Gas system fouled or Clean gas piston.
    defective  If required, contact HK 
    for repair
    Bolt does not close   Cartridge chamber dirty Clean chamber 
    completely, cartridge
    not properly seated Barrel extension dirty Clean barrel extension
    Cartridge damaged Replace cartridge
    Recoil spring worn Contact HK for repair
    Incomplete cocking Release cocking lever.
    movement Let it snap forward 
    without riding it forward.
    Stoppage, Fault Cause Remedy
    Cartridge case not  Chamber dirty Clean chamber
    extracted or ejected
    Extractor or or extractor Contact HK for repair
    spring broken
    Ejector or ejector  Contact HK for repair 
    spring damaged
    Insufficient bolt recoil Unload: Use cocking 
    lever to retract bolt.
    Remove cartridge case.
    Check for smooth 
    operation and check 
    chamber for fouling.
    If required, clean 
    chamber.
    No cartridge fed by bolt Magazine not properly  Insert magazine properly
    inserted or engaged.
    Magazine loose Check magazine catch 
    and lugs on magazine
    housing. If required, 
    contact HK for repair.
    Follower spring worn Replace or repair 
    magazine
    Magazine lips damaged Magazine housing 
    damaged. If required
    contact HK for repair.
    Magazine well damaged Return magazine well to 
    HK for repair
    Bolt does not stay open  Magazine follower Replace magazine
    after last shot spring worn follower, or springSL8-1 trigger cannot be Sear broken or  Contact HK for repair
    pulled with hammer compression spring 
    cocked wornMagazine stuck in  Magazine damaged Replace magazine
    magazine well
    Magazine catch Contact HK for repair
    defective 
    						
    							43
    PARTS LIST & EXPLODED DIAGRAM 
    42PARTS LIST & EXPLODED DIAGRAMItem Description Part Number
    Rifle, SL8-1 complete 219-477
    1 Housing 219-479
    Barrel, complete (2-5) 217 906
    2 Barrel 217 907
    3 Barrel retaining nut 205 378
    4 Gas block 217 919
    5 Roll pin, gas block 927 605
    6 Piston, complete 205 381
    7 Piston rod, complete 205 384
    8 Mounting Rail 217 947
    9 Flat Headed Screw (3x) 986-785
    10 Washer (3x) 214 112
    11 Threaded Washer 214  113
    Front sight, complete (12-14) 217 933
    12 Front sight 217 796
    13 Front sight base 217 795
    14 Roll pin, front sight 928 747
    15 Flat headed screw (4x) 988 428
    Rear sight complete (16-24) 217 925
    16 Roll pin, rear sight 987 695
    17 Rear sight guard 217 992
    18 Spring, elevation adjustment 217 504
    19 Rear sight housing 217 991
    20  Rear sight aperture 217 997
    21 Spring, windage adjustment 217 518
    22 Flat Spring 217 515
    23 Screw, elevation adjustment 217 505
    24 Screw, windage adjustment 217 517
    Bolt complete (25-42) 219 560
    Bolt head, complete (25-32) 219 561Item Description Part Number
    25 Bolt head 219 562
    26 Extractor axle 214 644
    27 Extractor 205 406
    28 Extractor spring 205 407
    29 Rubber pin for extractor 214 662
    30 Roll pin 928 389
    31 Ejector 205 408
    32 Spring, ejector 205-411
    Bolt head carrier complete (33-38) 217-909
    33 Spring, cocking handle 205 393
    34 Fork 205 394
    35 Bushing 205 473
    36 Cocking handle 205 395
    37 Rivet 205 210
    38 Bolt carrier 217 910
    39 Cam Pin 205 390
    Firing pin retainer, complete (40-41) 205 412
    40 Firing pin retainer 205 413
    41 O-ring, firing pin retainer 983 411
    42 Firing pin 205 391
    43 Recoil spring complete 205 445
    Buttstock assembly complete (44-76,79)219 535
    44 Screw for check rest (2x) 988 372
    45 Cheekpiece 217 948
    46 Cheekpiece spacer 217 916
    47 Buttstock 219 538
    48 Spacer, Buttplate 219 537
    49 Buttplate complete 219 539
    50 Allen Screw, Buttstock (4) 217 903
    51 Back plate 219 536
    Figure 45
    SL8-1 Rifle
    Caliber .223
    Item Description Part Number
    52 Buffer 205 452
    53 Hammer spring, right 205 428
    54 Hammer 217 936
    55 Hammer spring, left 205 429
    56 Notched disk 217 614
    57 Index plate 205 419
    58 Compression spring 205 418
    59 Sear complete 205 439
    59a Slide 219 411
    60 Sear spring 217 917
    61 Trigger spring 217 918
    62 Trigger 217 934
    63 Bolt catch spring 205 466
    64 Bolt catch 214 879
    Locking lever, complete 219 094
    65 Locking lever spring 214 616
    66 Locking lever 219 095
    67 Bolt 214 615
    68 Locking lever 214 613
    69 Elbow spring, right 217 946Item Description Part Number
    70 Elbow spring, left 205 201
    72 Safety lever, right 205 437
    73 Safety lever, left 217 945
    74 Recessed axle 205 202 
    75 Clamping pin 988 371
    76 Axle (3x) 205 469
    77 Actuator axle 205 424
    78 Magazine release spring 205 369
    79 Magazine release 205 368
    80 Axle 205 469
    81 Magazine well 219 478
    82 Locking pin, complete (2x) 214 125
    83 Hand guard complete 219 551
    Magazine complete (10 rounds) 219 472
    83 Magazine Housing 219 473
    84 Follower 219 474
    85 Follower spring 219 475
    86 Magazine floor plate 219 476
    HK Combination Tool 988 49  
    						
    							45
    FIREARM SERVICE RECORD
    44SL8-1 SPECIFICATIONS
    SL8-1 Rifle    Serial Number ___________________________________
    Number of Cumulative Total Maintenance & 
    Date Rounds Fired of Rounds Fired Users Name Remarks
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    ______________________________________________________________________________
    Caliber .223 Remington
    Operating Principle Gas operated, short stroke piston, rotary
    locking bolt
    Mode of Fire Semi-automatic
    Feed Device Single-stack polymer magazine, 
    10-round capacity
    Sights Adjustable iron sights. and detachable MIL-
    STD-1913 rail available for the attachment of
    accessory targeting devices
    Rifling 6X lands & grooves, right hand twist, 
    I turn in 7 inches
    Length (overall) 38.58 inches (980 mm) 
    Barrel Length 20.80 inches (528 mm)
    Sight Radius 17.65 inches (448 mm)
    Width (overall) 2.36 inches (60 mm)
    Height (overall) 9.84 inches (250 mm) with 10-rd magazine 
    Weights
    • Overall 8.60 pounds (3.9 kilograms with magazine)
    • Magazine 2.47 oz. (70 grams) 10-round, empty 
    						
    							In a world of compromise, some don’t.Heckler & Koch, Inc.
    21480 Pacific Blvd.
    Sterling, Virginia  20166-8903 
    United States of America
    Tel. (703) 450-1900
    Fax (703) 450-8160
    www.hecklerkoch-usa.comHeckler & Koch GmbH
    D-78722 Oberndorf/Neckar  
    Postfach 1329
    Germany
    Tel. 011-49-7423/79-0
    Fax 011-49-7423/2280
    www.heckler-koch.de
    HK USA #701475   5/00 
    ®
    Remember, firearms safety begins with you. Read and follow all safety information in the
    operators manual. Store all firearms in a safe and secure location. Keep firearms away from
    children. Always be a safe shooter. 
    						
    All Heckler and Koch manuals Comments (0)

    Related Manuals for Heckler And Koch HK SL8-1 Operators Manual