Haier Esa408k-l User Manual

No.0010529626
ROOM AIR  CONDITIONER
Use & Care Guide
ACONDICIONADOR DE AIRE  PARA HABITACIÓN
Manual de Uso y Cuidado
CLIMATISEUR DE PIÈCE
Guide d’utilisation et d’entretien
Model: 
ESA406K  ESA406K-L  ESA406K-T
ESA408K  ESA408K-L  ESA408K-T
ESA410K  ESA410K-L  ESA410K-T
ESA412K  ESA412K-L  ESA410K-E
ESA408K-E
For questions about features, operation/performance, parts,  
accessories or service call: 1-877-337-3639
Si tiene preguntas respecto a las características, funcionamiento, 
rendimiento, partes,...

TABLE OF CONTENTS
ÍNDICE
TABLE DES MATIÈRES
SEGURIDAD DEL ACONDICIONADOR DE AIRE......................17
REQUISITOS DE INSTALACIÓN.................................................17
   Herramientas y piezas................................................................17
   Requisitos de ubicación.............................................................18
   Requisitos eléctricos..................................................................18
INSTRUCCIONES DE...

AIR CONDITIONER SAFETY
INSTALLATION REQUIREMENTS
Tools and Parts
You can be killed or seriously injured if you don't immediately 
 
You can be killed or seriously injured if you don't follow 
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others is very important.
We have provided many important safety messages in this manual and on your...

Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Check the location where the air conditioner will be installed.
Make sure you have everything necessary for correct installation.
The location should provide:
■    Grounded electrical outlet within 4 ft (122 cm) of where the
     power cord exits the air conditioner.
     (For model ESA406K,ESA408K,ESA406K-L,ESA408K-L,
     ESA406K-T,ESA408K-T,ESA408K-E electrical outlet can be     
     grounded within 6 ft (183 cm))
     NOTE:...

NOTE: Your air conditioner’s device may differ from the one
shown.
This room air conditioner is equipped with a power supply cord
required by UL. This power supply cord contains state-of-the-art
electronics that sense current leakage. If the cord is crushed, the
electronics detect current leakage and power will be
disconnected in a fraction of a second.
Remove Packaging Materials
■    Remove and dispose of/recycle packaging materials. Remove 
tape and glue residue from surfaces before turning on the air...

B
B
A
A
B
NOTE: Your model may differ from the one shown.
NOTE: Attach curtains to the air conditioner before placing the air
conditioner in window.
1.      Place the tabbed side of the side curtain in the track on the 
right-hand side of the air conditioner cabinet.3.     Slide the side curtain frame into the top channel on the top 
of the air conditioner and the track on the bottom of the air  
conditioner.
4.     Slide the side curtain frame as close to the air conditioner 
as necessary to lock the...

3.    Slide the side bracket over the screw.
4.     Tighten the screw. The side bracket should be resting on the 
windowsill.
5.     Use 1⁄8” drill bit to drill a starter hole through the holes in the 
side bracket and windowsill.
6.     Using two 31⁄32” screws, attach the side bracket to the  
windowsill.
7.     Repeat for side bracket installation on the left-hand side of 
the air conditioner.
AB
C
NOTES:
■    Handle the air conditioner gently.
■     Be sure your air conditioner does not fall out of...

A
B
Top View
Bottom View
Complete Installation
1.     Insert the foam seal behind the top of the lower window sash 
and against the glass of the upper window.
A. Top of lower window sash
B. Foam seal
2.    Place the window lock bracket as shown. Use a 1⁄8” drill bit to 
drill a starter hole through the hole in the window lock bracket 
and into the upper window.
3.    Attach the window lock bracket to the upper window with one 
31⁄32” screw to secure the window in place.4.    Plug into a grounded 3 prong...

1.   Remove the clear plastic film from the control panel.
2.    Press POWER to turn on the air conditioner. The Power  
indicator light will turn on.
NOTE: When the air conditioner is plugged in, the LED display will 
show “88” for 3 seconds. After the air conditioner is turned on for 
the first time, the display will show the current room temperature 
and the fan is set to Low speed.
After the unit is plugged in, but before the unit is turned  on,  
press and hold the POWER button for 5 seconds to...

■    Press the TEMP/TIME up arrow button to raise the  
temperature. Each time you press or hold the TEMP/TIME up 
arrow button, the temperature will go up 1ºF  until it reaches 
86°F (30°C).
      NOTE: After 5 seconds, the display will show the current room    
 temperature.
■    Press the TEMP/TIME down arrow button to lower the  
temperature. Each time you press or hold the TEMP/TIME 
down arrow button, the temperature will go down 1ºF  until it 
reaches 61°F (16°C).
      NOTE: After 5 seconds, the...