GGP Italy SPA Riding Mower 71503770 2 Operators Manual
Have a look at the manual GGP Italy SPA Riding Mower 71503770 2 Operators Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 893 GGP Italy SPA manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
LAYING ON ITS SIDE In order to easily reach beneath the machine, it can be turned onto its side after having removed the grass-catcher and completely emptied the fuel tank. Having put the machine onto a firm and flat surface, engage the parking brake, put the cutting deck into position «7», firmly grip the steering wheel and the seat, and turn the machine onto its right hand side so that it rests on the grass- catcher (as shown), taking care not to damage plastic parts. Make sure that the machine is stable before starting any work and do not carry out work that may cause it to fall. !DANGER! EN 40MAINTENANCE
EN 41 TROUBLESHOOTING 7. TROUBLESHOOTING PROBLEM SITUATION LIKELY CAUSE SOLUTIONS 1.Pilot lamp off 2.Starter motor not working 3.Engine does not startKey is in «ON» position, engine stopped Key in «START» posi- tion and pilot lamp on Key in «START» posi- tion and pilot lamp flashing Key in «START» posi- tionElectronic card in safety alert, due to: – badly connected battery – completely flat battery or eroded battery plates – battery terminals crossed – fuse blown – badly earthed – electronic card wet – earthed micro-switches – insufficiently charged battery – battery charger fuse blown – badly earthed – you are not ready for starting – no fuel supply – faulty ignitionPut the key in the «OFF» posi- tion and look for the cause of the problem: – check connections – recharge battery – connect properly – replace fuse (10 A) – check connections – dry by air – check connections – recharge battery (if the problem continues, consult a Licensed Service Centre) – replace fuse (25 A) – check connections – Check that the conditions allowing the start are met (see page 26/a) – check fuel level – open fuel stop-cock (where fitted) – check the wiring of the fuel open command (where fit- ted) – check fuel filter – check that spark plugs caps are firmly fitted – check that the electrodes are clean and have the cor- rect gap
EN 42TROUBLESHOOTING PROBLEM SITUATION LIKELY CAUSE SOLUTIONS 4.Starting is dif- ficult or the engine runs erratically 5.Weak engine performance during cutting 6.The engine stops but the light flashes 7.The engine stops and the light goes off 8.The engine stops but the light stays on 9.Uneven cut and poor grass collectionKey in «ON», engine running Key in «ON», engine running Key in «ON», engine running Key in «ON», engine running Key in «ON», engine running Key in «ON», engine running– fuel fault – forward speed too high in rela- tion to cutting height – the safety devices cut in Electronic card in safety alert, due to: – earthed micro-switches – flat battery – overload caused by the charge regulator – badly connected battery (poor contact) – engine badly earthed – problems in the engine – cutting deck not parallel to the ground – blade cutting badly – clean or replace the air filter – flush out the float chamber – empty fuel tank and refill with new fuel – check and, if necessary, replace fuel filter – reduce the forward speed and/or raise the cutting deck – check that the conditions allowing starting are met (see page 26/b) Put the key in the «OFF» posi- tion and look for the cause of the problem: – check connections – recharge battery – contact a Licensed Service Centre – check battery connections – check engine earth con- nection – contact a Licensed Service Centre – check tyre pressures – re-align the cutting deck to the ground – check that the blade is fit- ted properly – sharpen or replace the blade – check the tension of the belt
EN 43 TROUBLESHOOTING PROBLEM SITUATION LIKELY CAUSE SOLUTIONS 10.Unusual vibrations while workingKey in «ON», engine running– forward speed too high com- pared to height of grass – collector channel is obstructed – cutting deck full of grass – the blade is imbalanced – blade loose – fixing screws loose – cutting deck is obstructed– reduce forward speed and/or raise the cutting deck – wait for grass to dry – remove the grass-catcher and empty the collector channel – clean the cutting deck – balance or replace the damaged blade – check that the blade is firmly fitted – check and tighten all the fixing screws of engine and the machine – remove the grass-catcher, empty the collector channel and clean the inside of the cutting deck If problems continue after having carried out these operations, contact a Licensed Service Centre. Do not take on complicated repair work if you dont have the necessary equipment and the technical knowledge. The guar- antee is automatically revoked and the manufacturer declines all responsibility for any repairs which are badly done. !WARNING!
EN 44ACCESSORIES ON REQUEST 8. ACCESSORIES ON REQUEST 1. FRONT COUNTERWEIGHTS These improve stability at the front of the machine, particularly when being used on ground which is mostly sloping. 2. STONE-GUARD KIT For use in place of the grass-catcher when the cuttings are not to be collected. 3. “CB01” MAINTENANCE BATTERY-CHARGER This makes it possible to keep the battery in good working order when the machine is in storage, guaranteeing an optimum level of charge and a longer life to the battery. 4. KIT FOR “MULCHING” It finely chops the grass cuttings and leaves them on the lawn, instead of collecting them in the grass-catcher 2 1 3 4
EN 45 SPECIFICATIONS 9. SPECIFICATIONS Electrical system............................ 12 V Battery ......................................... 18 Ah Front tyres ............................... 11 x 4-4 Rear tyres ................................15 x 6-6 Front tyre pressure .....................1.5 bar Rear tyre pressure ..................... 1.0 bar Weight ............................. 159 ÷ 168 kg Inside turning circle (minimum diameter of uncut area ................. 1.4 m Cutting height ......................... 3 ÷ 8 cm Cutting width .............................. 71 cm Grass-catcher capacity ......... 170 litersFor mechanical drive models: Forward speed (approximate) at 3000 min –1: in 1st ............................... 1.5 km/h in 2nd ............................ 2.7 km/h in 3rd .............................. 4.0 km/h in 4th .............................. 4.5 km/h in 5th .............................. 6.8 km/h in Reverse ....................... 2.0 km/h For hydrostatic drive models: Forward speed (at 3000 min –1): in Forward drive ....... 0 ÷ 8.6 km/h in Reverse ................. 0 ÷ 3.2 km/h ➤ ➤ 706 1130750 1546760 1863 860 1100