GGP Italy SPA Engine Sv200 07 Instructions Manual

71520130/1 Realizzazione: EDIPROM / bergamo
GGP ITALY 
SPA
Via del Lavoro, 6
I-31033 Castelfranco Veneto (TV) ITALY
FR
MANUEL D’UTILISATION
OPERATOR’S MANUAL
GEBRAUCHSANWEISUNG
MANUALE DI ISTRUZIONI
GEBRUIKERSHANDLEIDING
MANUAL DE INSTRUCCIONES
MANUAL DE INSTRUÇÕES
∂°Ã∂πƒπ¢π√ √¢∏°πø¡
KULLANIM KILAVUZUУПАТСТВА ЗА УП\bТРЕБАINSTRUKSJONSBOK
BRUKSANVISNING
BRUGSANVISNING
KÄYTTÖOHJEET
NÁVOD K POUŽITÍ
INSTRUKCJE OBSŁUGI
HASZNÁLATI UTASÍTÁS
êìKéÇéÑëíÇé èé ùKëèãì\
ÄíÄñàà
PRIRUČNIK ZA UPORABO
PRIROČNIK ZA UPORABU...

312
4
56
7
8
3.1
SLOW
1
CHOKE
F AST3.2
2
1
MAX
MIN 2
5.1.1
1
2
3
5.1.2
12
3
5.1.3
1
2
5.1.4
3
2
1
4
5.2-3
2
1
4
3
5.5-6
1
MAXMIN2
3
4
6.3
4
213
6.4
1
3
2
3
4
5
6.5
0,6-0,8
mm
3
11
4
12
6.6
4
1
2
3
6.7 

1EN
READING AND UNDERSTANDING THE
MANUAL
Some paragraphs in the manual containing infor-
mation of particular importance for safety and
operation are highlighted at various levels of
emphasis, and signify the following:
or   
These give details or further information on
what has already been said, and aim to prevent
damage either to the engine or other damages.
Non-observance will re-
sult in the risk of injury to oneself or others.
Non-observance will re-
sult in the risk of serious injury or death to...

engine is hot;
–if fuel is spilled, do not attempt to start the
engine but move the lawnmower away
from the area of spillage and avoid creating
any source of ignition until the fuel has
evaporated and fuel vapours have dissipat-
ed;
–always put the tank and fuel container caps
back on and tighten well. 
4) Replace faulty silencers and the guard, if
damaged.
C) OPERATION
1) Do not operate the engine in a confined
space where dangerous carbon monoxide
fumes can collect.
2) Do not use starting fluids or...

The engine performance, reliability and life are
influenced by many factors, some external and
some strictly associated with the quality of the
products used and with the scheduled mainte-
nance. 
The following information allow a better under-
standing and use of your engine.
ENVIRONMENTAL CONDITIONS
The operation of a four-stroke endothermic
engine is affected by:
a) Temperature:
–Working in low temperatures could lead to a
difficult cold starting.
–Working in very high temperatures could lead
to a...

BEFORE EVERY USE
Before every use, perform the following checking
procedures in order to assure a regular opera-
tion.
Check oil level
See the specific chapter (8.1) for the oil to be
used. 
a)Place engine level.
b)Clean around oil fill.
c)Unscrew the cap (1), clean the end of the dip-
stick (2) and insert it, as illustrated, without
screwing it down.
d)Remove the cap with the dipstick and check
the oil level that must be between the “MIN”
and “MAX” marks.
e)If oil is required, add oil of the same kind...

STARTING THE ENGINE (hot starting)
•)Follow the whole cold-starting procedure
with throttle control (1) in “FAST” position.
USE OF THE ENGINE IN OPERATION
When mowing, use the engine at its max rpm by
moving the throttle control to “FAST” position.
Keep your hands away
from the silencer and surrounding areas
that can become extremely hot. With the
engine running, do not get loose-fitting
clothing (ties, scarves, etc.) or hair closer to
the top part of the engine.
Do not operate on over 20°
inclines to...

SAFETY RECOMMENDATIONS
Remove the spark plug
cap and read instructions before carrying
out any cleaning, repair or maintenance
operation. Wear proper clothing and work-
ing gloves whenever your hands are at risk.
Do not perform maintenance or repair oper-
ations without the necessary tools and
technical knowledge.
Never get rid of used oil, fuel
or other pollutants in unauthorised  places.
If necessary, you can lift the
front side of your lawnmower or you can tip it
on its right side only, making sure...

a)Clean around the filter cover (1).
b)Release the rear clip (2); remove the cover (1)
and the foam element (3).
c)Block the intake pipe (5) with a cloth to pre-
vent dirt from entering.
d)Wash the foam element in liquid detergent
and water. Squeeze dry in a clean cloth.
e)Saturate the foam element with 2 table-
spoons of clean engine oil and squeeze it a
few times to distribute the oil evenly.
f)Remove excess oil with a clean cloth.
g)Clean the interior of the air cleaner housing
(4) from any dust and...

8EN
REFILLING AND OPERATION MATERIALS
Fuel  .......................................................................................... Unleaded gasoline, minimum 90 octane
Tank capacity  .............................................................................................................................. 1.2 liter
Engine oil:  from 5 to 35 °C ......................................................................................................... SAE 30
from -15 to +5 °C...