Getnet Router GA-121A User Manual

							
GA-121A User Manual 
 
 
The following table describes the parameters and buttons in this page: 
Field Description 
Host Enter the IP address. 
PING Click it to begin to Ping the host address. 
 
3.8.2   ATM Loopback 
Choose Diagnostic  > ATM Loopback . The page shown in the following figure 
appears. In this page, you can use VCC loopback function to check the 
connectivity of the VCC. 
 
3.8.3   ADSL 
Choose Diagnostic  > ADSL . The page shown in the following figure appears. It 
is used for ADSL tone diagnostics. 
58  
						

							
GA-121A User Manual 
 
 
Click Start to begin ADSL tone diagnostics. 
3.8.4   Diagnostic Test 
Choose Diagnostic > Diagnostic Test . The page shown in the following figure 
appears. In this page, you can test the DSL connection. 
  
Click  Run Diagnostic Test  to begin testing. 
 
59  
						

							
GA-121A User Manual 
60 
Appendix A  USB Software Setup 
Step 1 Install Setup.exe  to execute the USB software setup. The page shown 
in the following figure appears. 
 
Step 2  Click Next. The page displays the rate of progress.  
						

							
GA-121A User Manual 
 
Step 3 After finishing the setup, the page shown in the following figure 
appears: connect or disconnect your ADSL modem to PC . 
 
Before installing the driver program, you must ensure the ADSL router has been 
connected to PC through the USB slot. When the PC is powered on, Windows 
detects a new device. The PC gives a message finding new hardware. 
61  
						

							
GA-121A User Manual 
 
Step 4 Select No, not this time and click  Next. The page shown in the 
following figure appears. 
 
62  
						

							
GA-121A User Manual 
Step 5 Select Install the software automatically (Recommended)  and click 
Next . Windows will search and find the USB driver and automatically 
install the driver. The page shown in the following figure appears. 
 
Step 6  Wait for a few seconds, the page shown in the following figure appears. 
Click  Finish  to close the wizard. The USB driver installation is finished. 
 
63