Ford Fiesta Owners Manual

ENGINE OIL DIPSTICK - 1.0L
ECOBOOST™
MinimumA
MaximumB
ENGINE OIL DIPSTICK - 1.25L
DURATEC-16V (SIGMA)
MinimumA
MaximumB
ENGINE OIL DIPSTICK - 1.4L
DURATEC-16V (SIGMA)
MinimumA
MaximumB
ENGINE OIL DIPSTICK - 1.6L
DURATEC-16V TI-VCT (SIGMA)
MinimumA
MaximumB
159Fiesta (CCN)Maintenance 

ENGINE OIL DIPSTICK - 1.6L
ECOBOOST™
MinimumA
MaximumB
ENGINE OIL DIPSTICK - 1.5L
DURATORQ-TDCI
MinimumA
MaximumB
ENGINE OIL DIPSTICK - 1.6L
DURATORQ-TDCI (DV) DIESEL
MinimumA
MaximumB
ENGINE OIL CHECK
1.Make sure that your vehicle is on levelground.
2.Switch off the engine and wait 10minutes for the oil to drain into the oilpan.
3.Remove the dipstick and wipe it witha clean, lint free cloth. Replace thedipstick and remove it again to checkthe oil level.
If the oil level is at the minimum mark, addoil...

Adding Oil
WARNINGS
Only add oil when the engine is cold.If the engine is hot, wait 10 minutesfor the engine to cool down. Failureto take care may result in personal injury.
Do not remove the filler cap whenthe engine is running. Failure to takecare may result in personal injury.
1.Remove the filler cap.
2.Add oil that meets Ford specifications.See Technical Specifications (page177).
3.Replace the filler cap. Turn it until youfeel a strong resistance.
Note:Do not add oil further than themaximum mark. Oil...

BRAKE AND CLUTCH FLUID
CHECK
WARNINGS
Do not use any fluid other than therecommended brake fluid as this willreduce brake efficiency. Use ofincorrect fluid could result in the loss ofvehicle control, serious personal injury ordeath.
Only use brake fluid from a sealedcontainer. Contamination with dirt,water, petroleum products or othermaterials may result in brake systemdamage or failure. Failure to adhere to thiswarning could result in the loss of vehiclecontrol, serious personal injury or death.
Do not...

Note:You must reset the bounce-backfeature for the power windows. See PowerWindows (page 54).
Make sure that you dispose ofold batteries in anenvironmentally friendly way.
Seek advice from your local authorityabout recycling old batteries.
CHECKING THE WIPER
BLADES
Run the tip of your fingers over the edge ofthe blade to check for roughness.
Clean the wiper blades with washer fluidor water applied with a soft sponge orcloth.
CHANGING THE WIPER
BLADES
Windshield Wiper Blades
Changing the Windshield Wiper...

2.Remove the screws.
3.Disconnect the electrical connector.
4.Remove the headlamp.
Note:When fitting the headlamp, makesure that you reconnect the electricalconnector correctly.
Note:When fitting the headlamp, makesure that you fully engage the headlamp inthe retaining clips.
CHANGING A BULB - VEHICLES
WITH: 3-DOOR
WARNINGS
Switch the lamps and the ignition off.
Let the bulb cool down beforeremoving it.
Note:Only fit bulbs of the correctspecification.
Note:The following instructions describehow to remove...

2.Remove the cover.
3.Disconnect the electrical connector.
4.Release the clip and remove the bulb.
Note:Do not touch the glass of the bulb.
Headlamp High Beam
1.Remove the headlamp. SeeRemoving a Headlamp (page 163).
2.Remove the cover.
3.Turn the bulb counterclockwise andremove it.
Note:Do not touch the glass of the bulb.
Side Lamp
1.Remove the headlamp. SeeRemoving a Headlamp (page 163).
2.Remove the cover.
3.Remove the bulb holder.
4.Remove the bulb.
Direction Indicator
1.Remove the headlamp....

3.Gently press the bulb into the bulbholder, turn it counterclockwise andremove it.
Daytime Running Lamps
Note:These are not serviceable items, seean authorized dealer if they fail.
Side Repeater
1.Press the side of the cover to releasethe clips.
2.Remove the cover.
3.Remove the bulb holder. Remove thebulb.
Front Fog Lamps
1.Remove the retaining clips to gainaccess to the lamp assembly.
166Fiesta (CCN)Maintenance 

Note:You cannot separate the fog lampbulb from the bulb holder.
2.Using a suitable implement, removethe cover.
3.Remove the screws.
4.Remove the lamp.
5.Disconnect the electrical connector.
6.Turn the bulb holder counterclockwiseand remove it.
Rear Lamps
1.Remove the screws.
2.Lift up the luggage compartment seal.
167Fiesta (CCN)Maintenance 

3.Remove the carpet.
4.Remove the wing nut.
5.Disconnect the electrical connector.
6.Turn the bulb holder counterclockwiseand remove it.
7.Gently press the bulb into the bulbholder, turn it counterclockwise andremove it.
A.Indicator
B.Tail and brake
C.Reverse
Central High Mounted Brake Lamp
Note:These are not serviceable items, seean authorized dealer if they fail.
License Plate Lamp
1.Carefully release the spring clip.
2.Remove the lamp.
3.Remove the bulb.
168Fiesta (CCN)Maintenance