Flir ThermovisionBTS Scout Operators Manual

							Scout Bi-Ocular Operator’s Manual 3—Operating Your Camera
 431-BTS0-00-10, Revision 110 25
3–11 Bayonet Lens Mounting System
The Scout Bi-Ocular camera is equipped with a robust bayonet 
mounting system to allow for field-interchangeable optics options and 
future accessories.   As shipped, the Scout Bi-Ocular camera comes 
with a lens-cover assembly mounted on the bayonet mount.
Caution!
Removing and Installing Lenses
1.  Remove the lens-cover assembly by 
rotating it clockwise (approximately 
45°) and pulling straight off 
2.  Line up the key on the lens (red dot) 
at approximately 45°.
3.  Install lens by inserting and rotating 
it counter-clockwise. 
4.  Remove lens by releasing latch and rotating lens clockwise 
(approximately 45°) and pulling straight off.
Always keep the camera window covered. A lens or the lens cover 
should always be installed on the camera to protect the window.
Clockwise
to Remove
Counter-Clockwise
to InstallRelease latch 
to Remove
Line up
key
431-BTS0-00-10 Scout Bi-Oc Ops Manual.book  Page 25  Thursday, March 29, 2012  1:27 PM 
						

							3—Operating Your Camera Scout Bi-Ocular Operator’s Manual
26 March 2012
3–12 Installing Software Upgrades
Your Scout Bi-Ocular camera may require software upgrades during 
it’s lifetime. The upgrade process requires an SD card loaded with the 
upgrade file. After receiving the upgrade file from FLIR Commercial 
Systems, Inc., load it onto your SD card.
Caution!
Use the following procedure to install the upgrade:
1.  Ensure that the camera battery is fully charged. (The software 
installation will not start if the battery charge is less than 50%.)
2.  With the camera off, install the SD card loaded with the upgrade 
file. Refer to “SD Card Door” on page 21.
3.  Install the Hot Shoe and connect to a power source. Refer to “The 
Hot Shoe” on page 24.
4.  Turn on the camera. During its Bootup process, the camera will 
check the SD card for a valid upgrade file.
5.  Watch the display. When a valid file is found, a message will be 
shown for about ten seconds directing you to 
“Press and hold Capture button for 2 seconds to initiate update.”
If you ignore the message, the camera will resume normal 
operation and enter the On state.
6.  While the message is displayed, press and hold the Capture 
button for two seconds.The software upgrade takes about 
four minutes. When finished you will see this prompt to restart 
the camera. SW Upgraded: Please Shutdown & Restart now
During a software installation, the camera must remain powered 
on. Turning off the camera, or losing power for any reason, may 
damage the system files and require that the camera be returned 
to the factory for repair.
431-BTS0-00-10 Scout Bi-Oc Ops Manual.book  Page 26  Thursday, March 29, 2012  1:27 PM 
						

							Scout Bi-Ocular Operator’s Manual 3—Operating Your Camera
 431-BTS0-00-10, Revision 110 27
7.  To check the current installed version of software, place the 
camera in standby, then turn on while looking in the upper right 
corner of the display for the software version number, as shown 
below.
431-BTS0-00-10 Scout Bi-Oc Ops Manual.book  Page 27  Thursday, March 29, 2012  1:27 PM 
						

							3—Operating Your Camera Scout Bi-Ocular Operator’s Manual
28 March 2012
431-BTS0-00-10 Scout Bi-Oc Ops Manual.book  Page 28  Thursday, March 29, 2012  1:27 PM 
						

							 431-BTS0-00-10, Revision 110 29
4Technical Data
4–1 Scout Bi-Ocular Camera Model Features
4–2 Power
4–3 Environmental
BTS-X Pro  Scout Bi-Ocular Handheld Thermal Camera (with choice of lens) 
and accessory kit. 
Includes the image save function, video save function with real-
time stamp, USB2 port, and hard carrying case. BTS-XR Pro 
Accessory Kit Hot Shoe Charging & Video Output Attachment, four Recharge-
able AA Batteries, AC Power Adapter/Charger, Neck Lanyard, 
SD card, USB Cable, and Video Output Cable.
Start up from stand-by 
						

							4—Technical Data Scout Bi-Ocular Operator’s Manual
30 March 2012
4–4 Physical
4–5 Additional Features
4–6 Field of View
Weight (without lens) 2.20 lb. (1 kg) with batteries
Size (L 
× W × H) 11.0” × 6.5” × 2.63” (28 × 16.5 × 6.7 cm)
Still Image Storage, 
FormatSD, SDHC card,
JPEG
Video Storage,
FormatSD, SDHC card, 
AVI
QD35
Field of View (FoV) BTS-X Pro
13° × 10°
FoV BTS-XR Pro
18° 
× 13°
Minimum Focus Distance 3 meters
QD65
FoV BTS-X Pro
7° × 5°
FoV BTS-XR Pro
10° 
× 8°
Minimum Focus Distance 3 meters
QD100
FoV BTS-X Pro
5° × 3°
FoV BTS-XR Pro
6° 
× 4°
Minimum Focus Distance 4 meters
431-BTS0-00-10 Scout Bi-Oc Ops Manual.book  Page 30  Thursday, March 29, 2012  1:27 PM 
						

							Scout Bi-Ocular Operator’s Manual 4—Technical Data
 431-BTS0-00-10, Revision 110 31
4–7 Range Detection
Actual range may vary depending on camera set-up, environmental 
conditions, and user experience.
QD35
FoV
13° × 10°
18° × 13° Detect Man
(1.8 m × 0.5 m)2,559’ (780 m) BTS-X Pro
3,740’ (1140 m) BTS-XR Pro
Recognize
Man623’ (190 m) BTS-X Pro
919’ (280 m) BTS-XR Pro
Detect Vehicle
(2.3 m × 2.3 m)7,054’ (2150 m) BTS-X Pro
8,366’ (2550 m) BTS-XR Pro
Recognize
Vehicle1,837’ (560 m) BTS-X Pro
2,231’ (680 m) BTS-XR Pro
QD65
FoV
7° × 5°
10° × 8° Detect Man
(1.8 m × 0.5 m)4,757’ (1450 m) BTS-X Pro
6,234’ (1900 m) BTS-XR Pro
Recognize
Man1,214’ (370 m) BTS-X Pro
1,608’ (490 m) BTS-XR Pro
Detect Vehicle
(2.3 m × 2.3 m)2.42 miles (3900 m) BTS-X Pro
2.98 miles (4800 m) BTS-XR Pro
Recognize
Vehicle3,412’ (1040 m) BTS-X Pro
4,429’ (1350 m) BTS-XR Pro
QD100
FoV
5° × 3°
6° × 4° Detect Man
(1.8 m × 0.5 m)6,808’ (2075 m) BTS-X Pro
8038’ (2450 m) BTS-XR Pro
Recognize
Man1,772’ (540 m) BTS-X Pro
2,133’ (650 m) BTS-XR Pro
Detect Vehicle
(2.3 m × 2.3 m)3.29 miles (5300 m) BTS-X Pro
3.73 miles (6000 m) BTS-XR Pro
Recognize
Vehicle4,921’ (1500 m) BTS-X Pro
5,742’ (1750 m) BTS-XR Pro
431-BTS0-00-10 Scout Bi-Oc Ops Manual.book  Page 31  Thursday, March 29, 2012  1:27 PM 
						

							4—Technical Data Scout Bi-Ocular Operator’s Manual
32 March 2012
431-BTS0-00-10 Scout Bi-Oc Ops Manual.book  Page 32  Thursday, March 29, 2012  1:27 PM 
						

							431-BTS0-00-10 Scout Bi-Oc Ops Manual.book  Page i  Thursday, March 29, 2012  1:27 PM 
						

							www.flir.com
Santa Barbara Portland
FLIR Commercial Systems, Inc.
World Headquarters
FLIR Systems, Inc.
70 Castilian Dr.
Goleta, CA 93117
USA
PH: +1.888.747.FLIR
     (+1.888.747.3547)FLIR Corporate Headquarters
FLIR Systems, Inc.
27700A SW Parkway Ave.
Wilsonville, OR 97070
USA
Europe
CVS Eurasian Headquarters
FLIR Commercial Systems B.V.
Charles Petitweg 21
4847 NW Teteringen - Breda
The Netherlands
PH: + 31 (0) 765 79 41 94
FX: + 31 (0) 765 79 41 99
[email protected]
431-BTS0-00-10 Scout Bi-Oc Ops Manual.book  Page ii  Thursday, March 29, 2012  1:27 PM