European American Armory Over And Under Shotgun Izh27 Instructions Manual

11 the barrel removed pull the triggers to release the hammer springs from their
compressed state.
There is no excuse for not being careful.....
W A R N I N G
Never load a cartridge into the chamber until
you are ready to fire the shotgun...
To Fire Shotgun:
W A R N I N G
Do not disengage the trigger block safety until the shotgun is pointed in a safe
direction and you are ready to fire.
If a cartridge does not fire and the trigger has been pulled and the trigger block
safety is disengaged...Stop! and do...

12 4)  Visually check that the barrels are free of obstructions and then close the
shotgun action.
5)  We suggest that you remove the hammers spring compression by pulling
each trigger or in the case of a single trigger gun pulling the trigger for each
barrel.
6)  Engage the trigger block safety after the shotgun action is closed
To Disassemble The Shotgun:
1)  Make sure the shotgun is unloaded (FOLLOW UNLOADING
INSTRUCTIONS) and pointed in a safe direction.
2)  Make sure the trigger block safety is...

13 or exposure to such chemicals.
There is no excuse for not being careful.....
D)  Using the bore brush with powder solvent scrub the barrel and chamber to
remove any powder and lead residue in the bore.  Always and lastly, swab with
cotton patch with gun oil to coat and protect the bore and chambers from rust
and corrosion.
E)  Any powder fowling on the firing wall, barrel, etc. can be easily cleaned with
a brush and powder solvent.
F)  All external surfaces should be wiped down with a light coat of...

14 nearby.  Do not spray or apply lubricants directly on ammunition.  If the powder
charge of a cartridge is affected by the lubricant, it may not be ignited, but the
energy from the primer may be sufficient to push the bullet into the bore where it
may become lodged.  Firing a subsequent bullet into the obstructed bore will
damage the shotgun and may cause injury to the shooter and those nearby.  Use
lubricants properly.  You are responsible for the proper care and maintenance of
your firearm and...

15 Always keep this manual with your firearm.  Make sure you understand all the
warnings, operation instructions and safety procedures.  When you lend, give
or sell the firearm, be sure this manual goes with it.  You can get a copy of this
manual from European American Armory on request.
ALL PARTS ORDERS ARE SUBJECT TO A $10.00 CHARGE FOR SHIPPING
AND HANDLING.  Please state Model, Caliber, Serial Number, and Finish
Color when ordering.  For parts, information and service contact: European
American...

161.barrel assembly
2.ejector
3.screw
4.front sight
5.swivel ring
6.rin
7.hinge assembly
8.fore grip
9.screw
10.bush
11.catch casing
12.fore grip catch
13.pin
14.spring
15.housing
16.locking lever
17.screw
18.locking lever axle
19.locking strip
20.recoil spring
21.top striker
22.bottom striker
23.striker spring
24.right-hand hammer
assemblyFig. 1 - IZH27 Exploded View
25.left-hand hammer
assembly
26.pin
27.mainspring pivot
28.mainspring
29.right-hand sear
30.left-hand sear
31.pin
32.spring
33.right-hand...

17Fig. 3
1.carrier
2.locking strip
3.right-hand sear
4.left-hand sear
5.inertia-type tripping lever
6.intercepter
7.base plate
8.trigger
9.selector lever
10.selector lever spring
11.selector lever pin
12.trigger bar
13.tripping lever spring
14.trigger bar spring
15.tripping lever pin
16.trigger bar pin
17.trigger spring
18.change lever spring screw
19.intercepter spring 

18 Screw in Chokes Symbols / Markings (This is an option not all IZH27
shotguns have this feature)
The end of the chokes are marked with slashes to determine choke
/- Full
//- Improved Modified
///- Modified
////- Improved Cylinder
Cl- Cylinder
Make sure that you fully install the choke tube before you fire the shotgun. The
chokes are right hand thread. Make sure that you do not cross thread the chokes
and after use remove the choke tube and clean the choke tube threads and location
in the barrel where...