Epson Projector Emp Dm1 User Manual

19
Quick Start
AInsert the disc into its slot by facing the 
disc label upward.
If you are using a dual-side disc, face the side you 
wish to play upwards.
Insert an 8-cm disc into the disc slot center 
position.
A short beep sounds and the power comes on.
Inserting the disc makes the Disc indicator light up 
green.
BStart playback.
The projection lamp lights up automatically, and 
projection begins. It takes approximately 30 
seconds from when the lamp lights up until the 
image is projected brightly....

20
Adjust the volume and image being projected.
Adjusting the projection position and volume
Fine-tuning the projection size 
(Zoom button)
Focusing (Focus ring)Volume control (Volume)
To increase the size, 
press the “W” side.To decrease the 
size, press the “T” 
side.
Using the main unit Using the 
remote control 

21
Quick Start
If you extend the foot and tilt the unit, the image will have keystone distortion.
Reshape the keystone distortion as follows:
If the unit is tilted by up to 15° degrees in an upward or downward orientation, you can correct the image shape.
However, it will be difficult to focus if the tilt angle is large.
Correcting keystone 
distortion of the image 
(Keystone)
To raise the position of the projected image on 
the screen, extend the front adjustable feet by 
turning them.
Adjust the feet...

22
Press .
 After 
stopping, when you press  , playback is 
resumed from the interrupted scene (resume).
AWhen you have played back a disc, 
press   to eject the disc from its slot.
BPress .
CIf the lamp was on, the lamp turns off 
and the Power indicator on the main unit 
flashes orange (during cool-down).
DThe confirmation buzzer beeps twice to 
indicate that cool-down has completed. 
Unplug the power cable from the 
electrical outlet.
If you only press   to turn off the power, 
electricity continues...

23
Quick Start
From here on, operations are explained primarily using the buttons of the remote control. You can also use the buttons 
with the same markings as those on the unit control panel to achieve the same effect.
Press   during playback.
•Press   on the operation panel. The play is 
paused and restarted each time you press  .
•To resume playback, press  .
Press   or   during playback.
•There are five levels of reverse/forward search 
speeds that change each time the buttons are 
pressed.
•Press...

24
Press   or   during playback or 
when paused.
 If you press   once 
during chapter/track playback, playback returns to 
the start of the chapter or track being played. After 
this, playback returns to the start of the previous 
chapter/track each time you press  . After this, 
playback returns to the start of the previous chapter/
track each time you press  .
Press   during paused playback.
•A single frame is advanced each time you press 
. This unit does not have a frame return 
function.
•Press   to...

25
Quick Start
The break function is useful if, in the middle of a 
movie, you want to get up or move around, get a drink, 
or some food, and so on. By simply pressing the   
button you can pause the disc being played until you 
can get up to turn the lights on in the room.
Press   during playback.
•The projection lamp remains lit, whilst the 
projected image disappears.   flashes in the 
lower right portion of the screen.
•The screen darkens after about five minutes if 
the unit is left in break mode...

26
Advanced 
Operations
Some   discs have the following kinds of original menus saved in 
them.
•Root Menu: When multiple titles (image and audio) have been 
recorded, this integrated disc information is displayed.
•Menu: Title-specific playback data (chapter, angle, audio, and subtitle 
menus) is displayed.
1Press   or   during playback.
2Press   and select the item you want to 
see.
You can also select the title number or chapter number directly using the 
numeric buttons. 
Becoming a playback expert...

27
Advanced Operations
3Press .
You can play a   disc by selecting the desired chapter from any of the 
following two menus.
•PBC (Playback control) function: If a Video CD with “PBC (playback 
control) enabled” specified on the disc or jacket is inserted into the 
disc slot, a menu screen is displayed. You can select the scene or 
information you wish to see interactively from this menu.
•Preview function: You can select the desired track or scene and play 
it back in the following three formats.
Track...

28
If you select “Others” from the settings menu and set “PBC” to “Off”, the 
disc is played directly without displaying the menu screen. PBC is “On” 
by default. sp. 52
To play using the Preview function
1If you press   while a video CD is playing, the following 
Preview menu is displayed.
•You can also use Track Digest and Disc Interval by pressing   when 
stopped.
2Select an item by pressing  , and press  .
•If a disc contains six or more tracks, you can press   to display 
the next or previous page...