Epson AcuLaser C8600 User Manual

Where to Find Information
Setup Guide (this manual)
Contains information on placing and assembling the printer, and
installing the printer driver.
User Guides
The CD-ROM shipped with your printer includes
the following guides as well as the printer driver.
Note:
Adobe
®Acrobat®Reader™ 4.0 or latermust be installed on your
computer to view the Reference Guide and the Administrator’s Guide.
Reference Guide (PDF)
❏
How to use the printer
❏
How to solve problems
❏
How to keep your printer in good condition...

ii
 

Color Laser Printer
Setup Guide
1 SafetyInstructions.....................1
2 AssemblingthePrinter.................10
3 InstallingOptions.....................18
4 Testing and Connecting the Printer . . . . . . . 28
5 InstallingthePrinterSoftware ...........32
6 PrintingyourOnlineGuides.............37
 

iv
All rights reserved. No part of this publication may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, mechanical, photocopying, recording,
or otherwise, without the prior written permission of SEIKO EPSON CORPORATION. No
patent liability is assumed with respect to the use of the information contained herein. Neither
is any liability assumed for damages resulting from the use of the information contained
herein.
Neither SEIKO EPSON CORPORATION nor its affiliates...

Safety Instructions1
1
Safety Instructions
Laser Printer Precautions
This printer uses laser technology. The following precautions
apply whenever you use the printer. Even if you are familiar with
other types of printers, be sure to follow these precautions
carefully to ensure safe, efficient operation.
❏
Because the printer weighs approximately 70 kg (154 lbs)
without the consumable or optional products installed, one
person should not lift or carry it. Four people should carry the
printer, lifting it...

2Safety Instructions
❏
Never force the printer’s components into place. Although the
printer is designed to be sturdy, rough handling can damage
it.
❏
When handling toner cartridges, always place them on a
clean, smooth surface.
❏
Do not attempt to modify toner cartridges or take them apart.
They cannot be refilled.
❏
Do not touch the toner. Keep the toner away from your eyes.
❏
Do not dispose of used toner cartridges, waste toner
collectors, or photoconductor units in fire, as they can explode
and cause...

Safety Instructions3
❏
Be sure not to scratch the surface of the photoconductor unit’s
drum. When you remove the photoconductor unit from the
printer, always set the unit on a clean, smooth surface. Also,
avoid touching the drum, since oil from your skin can
permanently damage its surface and may affect print quality.
❏
To get the best print quality, do not store the photoconductor
unit in an area subject to direct sunlight, dust, salty air, or
corrosive gases (such as ammonia). Avoid locations subject...

4Safety Instructions
❏
Connect your printer to an electrical outlet that meets the
power requirements of this printer. Your printer’s power
requirements are indicated on a label attached to the printer.
If you are not sure of the power supply specifications in your
area, contact your local power company or consult your
dealer.
❏
The interface connector for this printer is Non-LPS
(non-limited power source).
❏
If you are unable to insert the AC plug into the electrical
outlet, contact an electrician.
❏
Do...

Safety Instructions5
❏
Adjust only those controls that are covered by the operating
instructions. Improper adjustment of other controls may
result in damage that requires repair by a qualified service
representative.
❏
If you plan to use the printer in Germany, observe the
following:
To provide adequate short-circuit protection and
over-current protection for this printer, the building
installation must be protected by a 10 or 16 amp circuit
breaker.
Safety Information
Power cord
c
Caution:
Be sure the...

6Safety Instructions
w
Warning:
The use of controls, or the performance of procedures and
adjustments other than those specified in this guide may result in
hazardous radiation exposure.
Internal laser radiation
This is a Class IIIb Laser Diode Assembly that has an invisible
laser beam. The printer head unit is NOT A SERVICE ITEM.
Therefore, the printer head unit should not be opened under any
circumstances. An additional laser warning label is affixed to the
inside of the printer.
CDRH regulations
For...