Epson AcuLaser 2600N User Manual

1
Color Laser Printer
Copyrights
No part of this publication may be reproduced, stored in a retrieval system, or transmitted 
in any form or by any means, mechanical, photocopying, recording, or otherwise, without 
the prior written permission of Seiko Epson Corporation. No patent liability is assumed with 
respect to the use of the information contained herein. Neither is any liability assumed for 
damages resulting from the use of the information contained herein.
Neither Seiko Epson Corporation nor...

2
CG Times and CG Omega are trademarks of Agfa Monotype Corporation and may be 
registered in certain jurisdictions.
Arial, Times New Roman and Albertus are trademarks of The Monotype Corporation and 
may be registered in certain jurisdictions.
ITC Avant Garde Gothic, ITC Bookman, ITC Zapf Chancery and ITC Zapf Dingbats are 
trademarks of International Typeface Corporation and may be registered in some 
jurisdictions.
Antique Olive is a trademark of Fonderie Olive.
Helvetica, Palatino, Times, Univers,...

Safety Instructions3
Safety Instructions
Safety
Warnings, Cautions, and Notes
w
Warnings
must be followed carefully to avoid bodily injury.
c
Cautions
must be observed to avoid damage to your equipment.
Notes 
contain important information and useful tips on the operation of your 
printer.
Safety precautions
Be sure to follow the precautions carefully to ensure safe, efficient 
operation:
 

4Safety Instructions ❏Because the printer weighs approximately 37 kg (81.5 lb) with 
consumable products installed, one person should not lift or 
carry it. Two people should carry the printer, lifting it by the 
correct positions as shown below.
* Do not lift the printer by these areas.
*
 

Safety Instructions5
❏Be careful not to touch the fuser, which is marked CAUTION 
HIGH TEMPERATURE, or the surrounding areas. If the printer 
has been in use, the fuser and the surrounding areas may be 
very hot. If you must touch one of these areas, wait 30 minutes 
to allow the heat to subside before doing so.
1. Do not insert your hand deep into the fuser unit.
2. CAUTION HIGH TEMPERATURE
❏Do not insert your hand deep into the fuser unit as some 
components are sharp and may cause injury.
❏Avoid...

6Safety Instructions ❏Do not attempt to modify a toner cartridge or take it apart. 
They cannot be refilled.
❏Do not touch the toner. Keep the toner away from your eyes.
❏Do not dispose of used toner cartridge, photoconductor units, 
fuser units, or waste toner collector in fire, as they can explode 
and cause injury. Dispose of them according to local 
regulations.
❏If toner is spilled, use a broom and dustpan or a damp cloth 
with soap and water to clean it up. Because the fine particles 
can cause a...

Safety Instructions7
❏Be sure to keep consumable components out of the reach of 
children.
❏Do not leave jammed paper inside the printer. This can cause 
the printer to overheat.
❏Avoid sharing outlets with other appliances.
❏Use only an outlet that meets the power requirements of this 
printer.
Important Safety Instructions
Read all of the following instructions before operating your 
printer:
When choosing a place and power source for the printer
❏Place the printer near an electrical outlet where you...

8Safety Instructions ❏Connect your printer to an electrical outlet that meets the 
power requirements of this printer. Your printer’s power 
requirements are indicated on a label attached to the printer. 
If you are not sure of the power supply specifications in your 
area, contact your local power company or consult your 
dealer.
❏If you are unable to insert the AC plug into the electrical 
outlet, contact an electrician.
❏Avoid using outlets that other appliances are plugged into.
❏Use the type of...

Safety Instructions9
When using the printer 
❏Follow all warnings and instructions marked on the printer.
❏Unplug this printer from the wall outlet before cleaning.
❏Use a well-wrung cloth for cleaning and do not use liquid or 
aerosol cleaners.
❏Avoid touching the components inside the printer unless 
instructed to do so in the printer’s documentation.
❏Never force printer components into place. Although the 
printer is designed to be sturdy, rough handling can damage 
it.
❏Be sure to keep consumables...

10Safety Instructions ❏Never push objects of any kind through cabinet slots as they 
may touch dangerous voltage points or short out parts that 
could result in a risk of fire or electric shock.
❏Never spill liquid of any kind on the printer.
❏Except as specifically explained in the printer’s 
documentation, do not attempt to service this product 
yourself. Opening or removing those covers that are marked 
Do Not Remove may expose you to dangerous voltage points 
or other risks. Refer all servicing in...