Home > Honda > Engines > Engine Honda GSV160, GSV190 French Version Manual

Engine Honda GSV160, GSV190 French Version Manual

Here you can view all the pages of manual Engine Honda GSV160, GSV190 French Version Manual. The Honda manuals for Engines are available online for free. You can easily download all the documents as PDF.

Page 1

1E
INTRODUCTION
Thank you for purchasing a Honda engine. We want to help you to get 
the best results from your new engi ne and to operate it safely. This 
manual contains information on how to  do that; please read it carefully 
before operating the engin e. If a problem should arise, or if you have 
any questions about your engine,  consult an authorized Honda 
servicing dealer.
All information in this  publication is based  on the latest product 
information available at the time  of printing....

Page 2

2E
COMPONENT & CONTROL LOCATION
The engine control area differs based on the engine type. Refer to the 
individual diagrams below to determine your engine control type when 
reading the Operation section and other sections in the manual.
BEFORE OPERATION CHECKS 
IS YOUR ENGINE READY TO GO?
For your safety, and to maximize the service life of your equipment, it 
is very important to take a few moments before you operate the 
engine to check its condition. Be sure to take care of any problem you 
find, or...

Page 3

3E
2. See equipment manual and 
position the throttle control 
so the choke/throttle lever 
moves to the CHOKE 
position.
3. See equipment manual 
and position the flywheel 
brake control so the 
flywheel brake lever is in 
the RUN position.
4. Pull the starter grip lightly until 
resistance is felt, then pull briskly.
NOTICE
Do not allow the starter grip to snap 
back against the engine. Return it 
gently to prevent damage to the 
starter.
5. If the choke was used to start the 
engine, move the...

Page 4

4E
Starting A Warm Engine
1. Move the flywheel brake lever to the RUN position.
2. Pull the starter grip lightly until resistance is felt, then pull briskly 
(see page 3).
Stopping The Engine
1. Release the flywheel brake lever to stop the engine.
2. Turn the fuel valve to the OFF position (see page 2).
TYPE 4 (AUTOMATIC CHOKE RETURN/FIXED THROTTLE)
Starting A Cold Engine
1. Turn the fuel valve to the ON 
position (see page 2).
2. Move the choke lever to the 
choke position ().
3. Move the flywheel...

Page 5

5E
SERVICING YOUR ENGINE 
THE IMPORTANCE OF MAINTENANCE 
Good maintenance is essential for safe, economical and trouble-free 
operation. It will also help reduce pollution.
To help you properly care for your engine, the following pages include 
a maintenance schedule, routine inspection procedures, and simple 
maintenance procedures using basic hand tools. Other service tasks 
that are more difficult, or require special tools, are best handled by 
professionals and are normally performed by a Honda...

Page 6

6E
ENGINE OIL 
Recommended Oil 
Use 4-stroke motor oil that meets 
or exceeds the requirements for 
API service classification SH, SJ, 
or equivalent. Always check the 
API service label on the oil 
container to be sure it includes the 
letters SH, SJ, or equivalent.
SAE 10W-30 is recommended for general use. Other viscosities 
shown in the chart may be used when the average temperature in 
your area is within the indicated range.
Oil Level Check 
1. Check the oil with the engine stopped and level.
2....

Page 7

7E
1. Disconnect the cap from the spark 
plug, and remove any dirt from the 
spark plug area. 
2. Use the proper size spark plug 
wrench to remove the spark plug.
3. Inspect the spark plug. Replace it 
if damaged, badly fouled, if the 
sealing washer is in poor condition, 
or if the electrode is worn. If the 
spark plug is to be reused, clean it 
with a wire brush.
4. Measure the electrode gap with a 
suitable gauge. The correct gap is 
0.028 – 0.031 in (0.70 – 0.80 mm). 
If adjustment is needed, correct...

Page 8

8E
Fuel system damage or engine performance problems resulting from 
neglected storage preparation are not covered under your engine 
warranty (see last page).
You can extend fuel storage life by adding a gasoline stabilizer that is 
formulated for that purpose, or you can avoid fuel deterioration 
problems by draining the fuel tank and carburetor.
ADDING A GASOLINE STABILIZER TO EXTEND FUEL 
STORAGE LIFE
When adding a gasoline stabilizer, fill the fuel tank with fresh gasoline. 
If only partially...

Page 9

9E
TECHNICAL & CONSUMER INFORMATION
TECHNICAL 
INFORMATION
Serial Number and 
Type Location
Record the engine serial 
number and type in the 
space below. You will 
need this information 
when ordering parts and 
when making technical or 
warranty inquiries. 
Engine serial number: __ __ __ __ __ – __ __ __ __ __ __ __
   Engine type: __ __ __ __
Carburetor Modifications for High Altitude Operation
At high altitude, the standard carb uretor air-fuel mixture will be too 
rich. Performance will decrease,...

Page 10

10E
Wiring Diagram
CONSUMER INFORMATION   
Honda Publications
These publications will give you additional information for maintaining 
and repairing your engine.You may order them from an authorized 
Honda engine servicing dealer.
Shop ManualThis manual covers complete maintenance and overhaul 
procedures. It is intended to be used by a skilled 
technician.
Parts CatalogThis manual provides complete, illustrated parts lists.
IGNITION 
COIL SPARK 
PLUGENGINE STOP 
SWITCH 
Start reading Engine Honda GSV160, GSV190 French Version Manual

Related Manuals for Engine Honda GSV160, GSV190 French Version Manual

All Honda manuals