Element Electronics ELEFC461 Digital Led Tv User Manual

							Operating Your Television
20 Show / Hide 
Allows you to show or hide the channels.
Use UP or DOWN button to highlight the “Show / Hide” item, then 
press RIGHT button to enter into the following menu.
Use UP and DOWN button to highlight the desired item, then press 
OK button to show or hide the highlighted channel. 
Channel No. 
Display the number of current channel.
Channel Label
Display the label of current channel.
DTV Signal:
Display the quality of current DTV signal.
50-1
50-2
50-3
Picture
Audio
Time
Setup
Lock
Channel
KOCE-HD
Press’OK’Change
Move Return
ChannelChannel NameFavorite
KOCE-SD
KOCE-LB 
						

							USB Multimedia Operation
21
Multimedia Operation: Music
USB
C:Photo MusicC:\MP3\
..
U01-1.mp3
U01-2.mp3
U01-3.mp3
U02-1.mp3
Play File  :0
Select Move Repeat001/005
Total size:3.8  GB
Unused size:3.7  GB..
Title:
Artist:
Album:
Year:
Bit Rate: 0kbps
Stop
00:00                         00:00
USB
C:Photo MusicC:\PICTURE\
..
2010100.jpg
2010101.jpg
2010102.jpg
2010103.jpg
Play File  :0
Select Move Repeat002/005
Total size:3.8  GB
Unused size:3.7  GB2010100.jpg1024 x686    229.0KB
Multimedia Operation: Photo
JPEG
rewind
selected with        buttons.p 
						

							22
Troubleshooting
If your television does not operate normally or does not turn on, please check the following
troubleshooting questions.  Remember to also check the other connected electronic devices, such as DVDs
or Blu-ray players to pinpoint any problem.  If the television still fails to operate normally, please contact
technical support (refer to Warranty page).
SYMPTOM POSSIBLE CAUSE REMEDY
Dead. No LED lit No power to the TV. Check all connections to the TV’s AC socket.
Dead. No LED lit red Set in standby mode.Press either the Power button or the Standby button
on the remote control.
Blue screenNo signal.
Press SOURCE button to select the correct source
Incorrect source selected.
Noisy, snowy, ghosting
picture (TV)Poor antenna signal.If using an indoor antenna, try adjusting the antenna
postion. Check antenna connections
No sound. F F O ” e t u M “ d n u o s n r u T . ” e t u M “ d n u o S
Volume set too low. Check volume settings.
External leads not connected
“if used”.Check that all external leads are connected properly. 
						

							23
Troubleshooting
Before contacting the service technician, perform the following simple checks. If any problem still persists,
unplug the LED TV and call for assistance.
PROBLEM POSSIBLE SOLUTION
No sound and picture - Check that the main plug has been connected to a wall
outlet
- Check that you have pressed the POWER button on the 
front of the TV set
- Check the picture contrast and the brightness setting
Red LED indicator light Set in standby mode.  Press either the POWER button or 
the Standby button on the remote control
Normal picture but no sound - Check the volume
- Sound muted?  Press the MUTE button
- Try another channel, the problem may be with the 
broadcast
- Are the audio cables installed properly?
The remote control does not work  - Check to see if there are any objects between the TV 
and remote control causing obstruction
- Are batteries installed with correct polarity (+ / -)
- Correct remote operating mode set:  TV, VCR, etc?
- Install new batteries
Power suddenly turns off - Is the sleep timer set?
- Check the power control settings. Power may be 
interrupted
- No broadcast on the station tuned
Picture appears slowly after switching on - This is normal, the image is muted during the product
start up process.  Please contact a service provider if 
the picture has not appeared after 5 minutes
Poor Color or picture - Adjust the color in Menu option
- Keep a sufficient distance between the product and the 
VCR
- Try another channel, the problem may be with the 
broadcast
- Are the VIDEO cables installed properly?
- Activate any function to restore the brightness of the 
picture
Horizontal/vertical bars or picture shaking - Check for local interference, such as an electrical 
appliance or power tool
Blue Screen - Press SOURCE button to select correct source
Poor reception on some channels - Station or cable experiencing problems. Tune to
another station
- Station signal is weak, reorient antenna to receive better
reception
- Check for sources of possible interference
Lines or streaks in pictures - Check the antenna (change the direction of the 
antenna)
No output from one of the speakers - Adjust balance in the Menu option 
						

							24
Troubleshooting
NOTE:  When there is a problem in VGA mode (only when VGA mode is applied)
PROBLEM POSSIBLE SOLUTION
The signal is out of range - Adjust resolution, horizontal frequency, or vertical
frequency
- Check whether the signal cable is connected or loose
- Check the input source
Vertical bar or stripe on background, horizontal noise and 
incorrect positionSet the auto configure or adjust clock, phase or H/V 
position
Screen Color is unstable or is a single Color - Check the signal cable
- Re-install the PC video card
Maintenance
Early malfunctions can be prevented.  Careful and regular cleaning can extend the amount of time you will 
have with your new TV.  Be sure to turn the power off and unplug the power cord before you begin any
cleaning.
Cleaning the screen
1. A great tip to dust off your screen. Wet a soft cloth in a mixture of lukewarm water and a little fabric
softener or dish washing detergent. Wring the cloth until it’s almost dry, and then use to wipe the 
screen.
2. Make sure the excess water is off the screen, then let air-dry before you turn on the TV.
Cleaning the Cabinet 
To remove dirt or dust, wipe the cabinet with a soft, dry, lint-free cloth.  Please be sure not to use a wet
cloth.
Extended Absence
If you expect to leave your TV dormant for a long time (such as a vacation), it is a good 
idea to unplug the power cord to protect against possible damages from lightning or 
power surges. 
						

							25
The FCC Wants You To Know
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed or 
used in accordance with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the  equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:  1) reorient or relocate the receiving an-
tenna; 2) increase the separation between the equipment and the receiver; 3) connect  the equip-
ment to an outlet on a circuit different from that to which the receiver is connected;
4) consult the dealer or an  experienced radio/TV technician for additional 
suggestions.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority  to operate the equipment. Where shielded interface cables have
been provided with the product or specified additional components or accessories elsewhere de-
fined to be used with the installation of the product, they must be used in order to ensure com-
pliance  with FCC regulation.
Canadian DOC statement
Standard Television Receiving Apparatus Canada BETS-7
This Class B digital apparatus complies with Canadian ICES-003.
Specifications
y l l a n o g a i d s e h c n i
46 e z i S l e n a P
D E L e p y T y a l p s i D
T F T y g o l o n h c e T l e n a P
z H 60 z H 0 2 1 s v z H 0 6 l e n a P
P 0 8 0 1 n o i t u l o s e R y a l p s i D
p 0
8 0 1 o t p u e l b i t a p m o C D H
1080 x 1920 n o i t u l o s e R l e n a P
9 : 6 1 o i t a R t c e p s A
4,000:1 l e n a p - Dynamic Contrast Ratio
Brightness (Centre Typ.) cd/m2 400
8 ms ) G o t G ( e m i T e s n o p s e R
s r u o h 0 0 0 0, 3 ) s r u o H . p y T (
e f i L p m a L
Horizontal Viewing Angle (At CR>10) 178
Vertical Viewing Angle (At CR>10) 178 
						

							This product contains electrical or electronic materials. The presence of these materials may, if not disposed of properly, have potential 
adverse effects on the environment and human health.
Presence of this label on the product means it should not be disposed of as unsorted waste and must be collected separately. As a 
consumer, you are responsible for ensuring that this product is disposed of properly.  To find out how to properly dispose of this product,
please go to www.elementelectronics.com and click on Sustainability.
This TV incorporates High-Definition Multimedia Interface (HDMI ) technology. HDMI, the HDMI  logo and High-Definition Multimedia 
Interface are trademarks or registered trademarks of HDMI Licensing LLC.
TM
JBL, the JBL logo, and harman kardon, are trademarks of Harman international industries, incorporated, registered in the united states 
and/or other countries.