Electrolux Ewx 12550 W User Manual

If you intend to drain the hose from the
machine into a sink, make sure that the
sink is empty and the plug hole is not
blocked. Use the plastic “U -Piece”
supplied.
Important!
Before connecting up the machine to
new pipework or to pipework that has
not been used for some time, run off a
reasonable amount of water to flush
out any debris that may have collected
in the pipes.
Special conditions
If the floor is carpeted or covered with
crumbly or soft material, insert a rigid
support base under the feet to...

42electrolux installation
Electrical connection
Any electrical work required to install
this appliance should be carried out by
a qualified electrician or competent
person.
Warning!
THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any lia-
bility should this safety measure
not be observed.
Before switching on, make sure the
electricity supply voltage is the same
as that indicated on the appliance’s
rating plate. 
Important!
Information on the electrical
connection is given on the rating
plate on...

Permanent connection
In the case of permanent connection it
is necessary that you install a double
pole switch between the appliance and
the electricity supply (mains), with a
minimum gap of 3mm between the
switch contacts and of a type suitable
for the required load in compliance with
the current electrical regulations.
The switch must not break the yellow
and green earth cable at any point.
Building-in
This appliance has been designed to
be built into the kitchen furniture. The
recess should have the...

44electrolux installation
The required dimensions are given in
the picture C.
The hinges will be fixed to the door by
means of screws for wood (2-Fig. B)
supplied with the appliance.
c) Mounting the door
Fix the hinges (1) to the machine by
means of the M5x15 screws (3-Fig. B).
The hinges can be adjusted to com-
pensate for possible uneven thickness
of the door.
To align the door perfectly it is neces-
sary to loosen the screw (3-Fig. B),
adjust the door and tighten the screw
again.
d) Counter-magnet...

Drill four fixing holes see Fig. G.
Position the base into the recess with
its front edge as far forward as the
adjoining plinth line will allow. 
The reason for placing the base in
this position is to allow a small
strip of beading to be fitted in front
of the appliance feet.
Fix the base firmly to the floor using
four appropriate countersunk screws
(see Fig. H).
With the appliance installed adjust all
four feet ensuring the machine is sta-
ble, and a clearance of approximately 5
mm is left between the...

46electrolux environment concerns
Environment concerns
Packaging materials
The materials marked with the symbol
are recyclable.
>PEPSPP

132962570.qxd  29/07/2008  10.02  Pagina  47
 

ANC number: 132 962 570-00-322008
www.electrolux.co.uk
132962570.qxd  29/07/2008  10.02  Pagina  48