Electrolux Eww 12470 W User Manual

What to do if...
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the redpilot light of button flashes,
one of the following alarm codes appears on the display and at the same some
acoustic signals sound every 20 seconds to indicate that the machine is not working:
●E10: problem with the water...

32  electrolux  What to do if...
MalfunctionPossible causeSolution
The machine does not
empty and/or does not spin:●The drain hose is squashed
or kinked.
E20
●The drain filter is clogged.
E20
●The option or has
been selected.
●The laundry is not evenly
distributed in the drum.
●Check the drain hose
connection.
●Clean the drain filter.
●Select the programme Spin
or Drain
. 
●Redistribute the laundry.
The door will not open:●The programme is still
running.
●The door lock has not been
released.
●There is...

What to do if...electrolux 33
The machine vibrates or is
noisy:●The transit bolts and
packing have not been
removed.
●The support feet have not
been adjusted.
●The laundry is not evenly
distributed in the drum.
●Maybe there is very little
laundry in the drum.
●Check the correct
installation of the appliance.
●Check the correct levelling
of the appliance.
●Redistribute the laundry.
●Load more laundry.
The machine does not dry or
does not dry properly●The drying time or the
dryness degree has not
been...

34  electrolux What to do if...
If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase
date of your machine: the Service
Centre will require this information.

	

	









Spinning starts late or the
machine does not spin:●The electronic unbalance
detection device has cut in
because the laundry is...

Technical data
Dimensions Width 60 cm
85 cm
63 cm Height
Depth
Water supply pressure Minimum 0,05 MPa
0,8 MPa Maximum
CottonMaximum Load 6  kg
MaximumSpin Speed1200 rpm
Electrical connection Voltage
- Overall power - FuseInformation on the electrical connection is given on
the rating plate on the inner edge of the appliance
door
technical data  electrolux 35
Cotton
SyntheticsMaximum Dry Load 3 kg
2 kg
132964080.qxd  14/02/2008  10.50  Pagina  35
 

36  electrolux consumption value
Consumption values
Water
consumption 
(in litres)Programme Energy
consumption 
(in kWh)Programme
duration 
(in minutes)
Cottons 90 ° 2.061
Cottons + Prewash 60° 1.4568
Synthetics 60° 1.054
Delicates 40°0.55 60
For the duration of
the programmes,
please refer to the
display on the
control panel.Cottons Eco 60°
1.14 58 Wool 40° 0.453
The consumption data shown on this
chart is to be considered purely
indicative, as it may vary depending on
the quantity and type of laundry,...

Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit
devices so that they can be refitted if the
machine ever has to be transported
again.
1. After removing all the packaging,
carefully lay machine on it’s back to
remove the polystyrene base from the
bottom.
2. Remove the power supply cable and
the draining hose from the hose
holders on the rear of the appliance.
3. With a suitable spanner unscrew and
remove the central rear...

38electrolux installation
6. Open the porthole, take out the inlet
hose from the drum and remove the
polystyrene block on the door seal.
7. Fill the smaller upper hole and the two
large ones with the corresponding
plastic plug caps supplied in the bag
containing the instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around
the machine is not impeded by
carpets, rugs etc. Check that the
machine does not touch the wall or
other kitchen units. Level the...

3. Set the hose correctly by loosening
the ring nut. 
After positioning the inlet hose, be
sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance. 
The inlet hose must not be lengthened. If
it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
Water drainage
The end of the drain hose can be
positioned in three ways:
Hooked over...

40electrolux installation
The appliance is supplied with a
13amp plug fitted. In the event of
having to change the fuse in the plug
supplied, a 13amp ASTA approved
(BS1363/A) fuse must be used.
Should the plug need to be replaced
for any reason, proceed as described
below.
The wires in the mains lead are
coloured in accordance with the
following code:
Green and Yellow ......................- Earth
Blue ..........................................-
Neutral
Brown ......................................- Live...