Electrolux Ews 126510 W User Manual
Have a look at the manual Electrolux Ews 126510 W User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 208 Electrolux manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
ProblemPossible cause/Solution The machine vibrates is noisy: The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The support feet have not been adjusted • Check the correct levelling of the appliance. The laundry is not evenly distributed in the drum. • Redistribute the laundry. Maybe there is very little laundry in the drum. • Load more laundry. Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redis- tributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distrib- uted in the drum, the machine will not spin. In this case, redistrib- ute the load manually and select the spin programme. • Redistribute the laundry. The load is too small. • Add more items, redistribute the load manually and then select the spinning programme. The machine makes an un- usual noise:The machine is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor en- sures a softer start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the machine. No water is visible in the drum:Machines based on modern technology operate very economically using very little water without affecting performance. If you are unable to identify or solve the problem, contact our service centre. Before telephoning, make a note of the model, se- rial number and purchase date of your ma- chine: the Service Centre will require this information. Mod. ... ... ... Prod. No. ... ... ... Ser. No. ... TECHNICAL DATA DimensionsWidth Height Depth60 cm 85 cm 44 cm Electrical connection Voltage - Overall power - FuseInformation on the electrical connection is given on the rating plate, on the inner edge of the appliance door. Water supply pressureMinimum Maximum0,05 MPa 0,8 MPa Maximum LoadCotton6 kg Spin SpeedMaximum1200 rpm electrolux 21
CONSUMPTION VALUES Programme1)Energy consumption (KWh)2)Water consumption (litre)2) White Cottons 90 °C2.162 Cottons 60 °C1.359 Cottons 40 °C0.7559 Synthetics 40 °C0.545 Delicates 40 °C0.5555 Wool/ Handwash 30 °C0.350 1) Refer to the display for the programme time. 2) The consumption information shown in this chart is indicative. It can vary depending on the quantity and the type of laundry, on the temperature of the water supply and on the ambient temperature. Standard programmes for the Energy Label consumption values The cotton 60 °C economy and cotton 40 °C economy are the standard cotton pro- grammes for normally soiled cotton laundry. They are suitable to clean normally soiled cotton laundry and they are the most effi- cient programmes in terms of combinedenergy and water consumption for washing that type of cotton laundry. They agree with EN60456. The actual water temperature may dif- fer from the declared cycle tempera- ture. INSTALLATION UNPACKING All transit bolts and packing must be re- moved before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1. After removing all the packaging, care- fully lay machine on it’s back to remove the polystyrene base from the bottom.2. Remove the power supply cable and the draining hose from the hose holders on the rear of the appliance. 3. Unscrew the three bolts. 1 2 22 electrolux
4. Slide out the relevant plastic spacers. 5. Fill the smaller upper hole and the two large ones with the corresponding plas- tic plug caps supplied in the bag con- taining the instruction booklet. POSITIONING Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. If nec- essary, check the setting with a spirit level. Any necessary adjustment can be made with a spanner. Accurate levelling prevents vibration, noise and displacement of the machine during operation. Caution! Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. WATER INLET An inlet hose is supplied and can been found inside the machine drum. Do not use the hose from your previous machine to connect to the water supply. Important! This appliance must be con- nected to a cold water supply. 1. Open the porthole and extract the inlet hose. 2. Connect the hose with the angled con- nection to the machine. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. 3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. 45° 35° electrolux 23
4. Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. WATER-STOP DEVICE The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in the window «A». Should this occur, turn the water tap off and refer to your Service Cen- tre to replace the hose. A WATER DRAINAGE The end of the drain hose can be posi- tioned in three ways. •Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the ma- chine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. •In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground. •Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. The end of the drain hose must always be ventilated, i.e. the inside diam- eter of the drain pipe must be larger than the outside diameter of the drain hose. The drain hose must not be kinked. 24 electrolux
The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre. ELECTRICAL CONNECTION Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domestic electrical installa- tion can take the maximum load required, also taking into account any other applian- ces in use. Connect the machine to an earthed socket. The manufacturer does not accept any responsibility for damage orinjury through failure to comply with the above safety precaution. The power supply cable must be easily accessible after installing the machine. Should the appliance power supply cable need to be replaced, this must be carried out by a Service Centre. ENVIRONMENT CONCERNS The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. PACKAGING MATERIALS The materials marked with the symbol are recyclable. >PEPSPP