Electrolux Ews 106410 S User Manual

ProblemPossible cause/Solution
There is water on the floor:
Too much detergent or unsuitable detergent (creates too much
foam) has been used.
• Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the inlet hose fit-
tings. It is not always easy to see this as the water runs down the
hose; check to see if it is damp.
• Check the water inlet hose connection.
The drain or inlet hose is damaged.
• Replace it with a new one.
The cap on the emergency emptying hose...

If you are unable to identify or solve the
problem, contact our service centre. Before
telephoning, make a note of the model, se-
rial number and purchase date of your ma-
chine: the Service Centre will require this
information.
Mod. ... ... ...
Prod. No. ... ... ...
          Ser. No. ...
Brand logoElectrolux
Name of the distribu-
torElectrolux Lehel Kft
1142 Budapest
Erzsébet kir.né útja 87
Model denominationEWS 106410 WEWS 106410 SEWS 126410
W
 Measure unitValues
Energy class(on scale from A
+++ to D,...

Spinning noisedB/A767677
CONSUMPTION VALUES
Programme1)Energy consumption
(KWh)2)Water consumption
(litre)2)
White Cottons 90 °C2.1062
Cottons 60 °C1.3059
Cottons 40 °C0.7559
Synthetics 40 °C0.5045
Delicates 40 °C0.5555
Wool/ Handwash 30 °C0.3050
1) Refer to the display for the programme time.
2) The consumption information shown in this chart is indicative. It can vary depending on the quantity and the type
of laundry, on the temperature of the water supply and on the ambient temperature.
Standard...

3. Unscrew the three bolts.
4. Slide out the relevant plastic spacers.
5. Fill the smaller upper hole and the two
large ones with the corresponding plas-
tic plug caps supplied in the bag con-
taining the instruction booklet.
POSITIONING
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or other kitchen units. Level
the washing machine by raising or lowering
the feet. The feet may...

2. The other end of the inlet hose which
connects to the machine can be turned
as showed in the picture.
Do not place the inlet hose downwards.
Angle the hose to the left or right de-
pending on the position of your water
tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose...

also taking into account any other applian-
ces in use.
Connect the machine to an earthed
socket.
The manufacturer does not accept
any responsibility for damage or
injury through failure to comply
with the above safety precaution.
The power supply cable must be
easily accessible after installing the
machine.
Should the appliance power supply
cable need to be replaced, this
must be carried out by a Service
Centre.
ENVIRONMENT CONCERNS
The symbol  on the product or on its
packaging indicates that this...

electrolux 27
 

132949561-A-362011
 www.electrolux.com/shop