Electrolux Ews 10570 W User Manual

user manual
Washing Machine
EWS 10570 W
 

Electrolux. Thinking of you.
Share more of our thinking at www.electrolux.com
Contents
Safety information    2
Product description    4
Control panel    5
First use    7
Personalisation    8
Daily use    8
Helpful hints and tips    11
Washing programmes    13Care and cleaning    17
What to do if...    21
Technical data    23
Consumption values    23
Installation    24
Electrical connection    27
Environment concerns    27
  Subject to change without notice
 Safety information
Important! Read carefully &...

Installation
• This appliance is heavy. Care should be
taken when moving it.
• When unpacking the appliance, check that
it is not damaged. If in doubt, do not use it
and contact the Service Centre.
• All packing and transit bolts must be re-
moved before use. Serious damage can
occur to the product and to property if this
is not adhered to. See relevant section in
the user manual.
• After having installed the appliance, check
that it is not standing on the inlet and drain
hose and the worktop is not...

Product description
Your new appliance meets all modern requirements for effective treatment of laundry
with low water, energy and detergent consumption. Its new washing system allows total
use of detergent and reduces water consumption so saving energy.
12
3
4
5
6
1Detergent dispenser drawer
2Control panel
3Door opening handle
4Rating Plate
5Drain pump
6Adjustable feet
Detergent dispenser drawer
 Compartment for detergent used for pre-
wash and soak phase or for stain remover
used during the stain...

Programme Chart
Various programme charts in different lan-
guages are supplied with the appliance. One
is on the front side of the detergent dispenser
drawer and the others are attached into theuser manual assy. The chart in the drawer
can be replaced easily: remove the chart
from the drawer by pulling it towards the right
and insert the chart with the language re-
quired.
Control panel
Below is a picture of the control panel. It shows the programme selector dial as well as
the buttons, pilot light and...

machine will perform some additional rinses
in some programmes. On cotton pro-
grammes the maximum spin speed is re-
duced automatically.
Extra Rinse
This appliance is designed for saving energy.
If it necessary to rinse the laundry using an
extra quantity of water (extra rinse), select
this option. Some additional rinses will be
performed. This option is recommended for
people who are allergic to detergents, and in
areas where the water is very soft.
Delay Start
The programme can be delayed from 30 min...

•End of programme
When the programme  has finished three
flashing zeros are displayed, the pilot light
9  and the pilot  light of button  8 go out and
the door can be opened.
7.2:   Washing programme phase icons
• Wash 
•Rinses 
•Drain 
•Spin 
By selecting the wash  programme, the pro-
gramme phase icons corresponding to the
various phases making up the programme
are shown in the bottom  part of the display.
After having pressed button  8 only the icon
of the running phase stays on. 7.3: 
 Heating...

• Before the first wash, run a cotton cy-
cle at the highest temperature without
any laundry in the machine, to remove
any manufacturing residue from thedrum and tub. Pour 1/2 a measure of
detergent into the main wash com-
partment and start the machine.
Personalisation
Acoustic signals
The machine is provided with an acoustic
device, which sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultane-
ously for about 6 seconds , the acoustic...

Select the required programme by
turning the programme selector dial (1)
Turn the programme selector dial to the re-
quired programme. The washing machine
will propose a temperature and automatically
select the maximum spin value provided for
the programme you have chosen. You can
change these values by operating the corre-
sponding buttons. The green pilot light of the
button 8 starts to flash.
The selector dial can be turned either clock-
wise or counterclockwise. Turn to position
 to reset...

1. Set the washing machine to PAUSE by
pressing button 8 .
2. Press button 6 once until the symbol 0’ is
displayed
3. Press button 8 again to start the pro-
gramme.
Important! The selected delay can be
changed only after selecting the washing
programme again.
The Delay Start can not be selected with
DRAIN programme.
Start the programme by pressing button
8
To start the selected programme, press the
button 8 , the green pilot light of the button
8 stops blinking.
To interrupt a programme which is...