Home > Electrolux > Washing Machine > Electrolux Ews 1051 User Manual

Electrolux Ews 1051 User Manual

Here you can view all the pages of manual Electrolux Ews 1051 User Manual. The Electrolux manuals for Washing Machine are available online for free. You can easily download all the documents as PDF.

Page 11

After each wash, keep the door open for a
while to prevent mould and to let unpleas-
ant smells go out.
Drum
Regularly examine the drum to prevent
limescale and rust particles.
Only use special products to remove rust
particles from the drum.
To do this:
• Clean the drum with special product for
stainless steel.
• Start a short programme for cotton at the
maximum temperature with a small quan-
tity of detergent.
Door seal
Regularly examine the seal and remove all
objects from the inner part.
Detergent...

Page 12

1. Open the pump door.
2. Put a container below the recess of the
drain pump to collect the water that
flows out.
3. Unscrew the filter to let the water flow
out.
4. When the container is full of water,
screw the filter again and empty the
container. Do steps 3 and 4 again and
again until no more water flows out
from the drain pump.
5. Unscrew the filter and remove it.
1
2
6. Remove fluff and objects from the
pump.
7. Make sure that the impeller of the
pump can turn. If this does not occur,
contact the...

Page 13

3. Clean the filter in the valve with a stiff
brush or a towel.
       
4. Install again the inlet hose. Make sure
that the couplings are tight to prevent
leakages.
5. Open the water tap.
Emergency drain
Because of a malfunction, the appliance
cannot drain the water.If this occurs, do steps (1) through (5) of To
clean the drain pump.
If necessary, clean the pump.
When you drain the water with the emer-
gency drain procedure, you must activate
again the drain system:
1. Put 2 litres of water in the main...

Page 14

ProblemPossible causePossible solution
 The programme knob is not in
the correct position.Turn the programme knob in the correct
position.
 The delay start is set.
It is available only for models
with the Delay start.To start immediately the programme,
cancel the delay start.
The appliance does not
fill with water.The water tap is closed.Open the water tap.
 The water inlet hose is dam-
aged.Make sure that the water inlet hose has
no damages.
 The filter in the water inlet
hose is blocked .Clean the...

Page 15

ProblemPossible causePossible solution
The appliance fills with
water and drain imme-
diately.The end of the drain hose is
too low.Make sure that the drain hose is in the
correct position. Refer to Installation.
The washing results
are not satisfactory.The detergent you used was
not sufficient or correct.Increase the detergent quantity or use a
different one.
 You did not remove the stub-
born stains before you wash
the laundry.Use special products to remove the
stubborn stains.
 Incorrect temperature...

Page 16

3. Remove the internal film.
4. Open the door and remove all the items
from the drum.
5. Put the front piece on the floor behind
the appliance. Carefully put down the
appliance with the rear side on it. Make
sure not to damage the hoses.
6. Remove the polystyrene protection
from the bottom.
1
2
7. Install the plastic cover (A), removed
from the top of the packaging, to the
bottom of the appliance. Remove the
adhesive strip and close the bottom of
the appliance. Attach permanently the
plastic cover to the...

Page 17

10. Replace the plastic spacers with the
large plastic caps. You can find these
large caps in the user manual bag.
Warning! Remove all the packaging
and the transit bolts before you install
the appliance.
We recommend that you keep the
packaging and the transit bolts for
when you move the appliance.
Positioning and levelling
• Install the appliance on a flat hard floor.
• Make sure that carpets do not stop the
air circulation below the appliance.
• Make sure that the appliance does not
touch the wall or...

Page 18

With the plastic hose guide.
•
• On the edge of a sink.
Make sure that the plastic guide cannot
move when the appliance drains. Attach
the guide to the water tap or the wall.
• To a stand pipe with vent-hole.
Refer to the illustration. Directly into a
drain pipe at a height of not less than 60
cm and not more than 90 cm. The end of
the drain hose must always be ventila-
ted , i.e. the inner diameter of the drain-
pipe must be larger than the external di-
ameter of the drain hose.
Without the plastic hose...

Page 19

electrolux 19
 

Page 20

155219000-A-182011
 www.electrolux.com/shop
   
 
Start reading Electrolux Ews 1051 User Manual

Related Manuals for Electrolux Ews 1051 User Manual

All Electrolux manuals