Electrolux Ews 10470 W User Manual

ProblemPossible cause/Solution
The machine does not start:
The door has not been closed. E40
•Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the button 8 has not
been pressed.
• Please turn the selector dial and press the button 8 again.
The delay start...

ProblemPossible cause/Solution
The door will not open:
The programme is still running.
• Wait the end of washing cycle.
The door lock has not been released.
• Wait until the pilot light 9  goes off.
There is water in the drum.
• Select drain or spin programme to empty out the water.
The machine vibrates is
noisy:
The transit bolts and packing have not been removed.
• Check the correct installation of the appliance.
The support feet have not been adjusted
• Check the correct levelling of the appliance....

Technical data
DimensionsWidth
Height
Depth
Depth (Overall dimensions)60 cm
85 cm
45 cm
48 cm
Electrical connection
Voltage - Overall power - FuseInformation on the electrical connection is given on the rating plate,
on the inner edge of the appliance door.
Water supply pressureMinimum
Maximum0,05 MPa
0,8 MPa
Maximum LoadCotton6 kg
Spin SpeedMaximum1000 rpm
Consumption values
ProgrammeEnergy consumption
(KWh)Water consumption
(litres)Programme duration
(Minutes)
White Cottons 90°2.669
For the duration...

2. Remove the power supply cable and the
draining and inlet hose from the hose
holders on the rear of the appliance.
3. Unscrew the three bolts.4. Slide out the relevant plastic spacers.
5. Fill the smaller upper hole and the two
large ones with the corresponding plastic
plug caps supplied in the bag containing
the instruction booklet.
24  electrolux
 

Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine
is not impeded by carpets, rugs etc. Check
that the machine does not touch the wall or
other kitchen units. Level the washing ma-
chine by raising or lowering the feet. The feet
may be tight to adjust as they incorporate a
self locking nut, but the machine MUST be
level and stable. If necessary, check the set-
ting with a spirit level. Any necessary adjust-
ment can be made with a spanner. Accurate...

Water drainage
The end of the drain hose can be positioned
in three ways.
•Hooked over the edge of a sink using
the plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the ma-
chine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.•
In a sink drain pipe branch. This branch
must be above the trap so that the bend is
at least 60 cm above the ground.
•Directly into a drain pipe at a height of
not...

Warning! The appliance is supplied with
a 13amp plug fitted. In the event of
having to change the fuse in the plug
supplied, a 13amp ASTA approved
(BS1363/A) fuse must be used.
The manufacturer does not accept
any responsibility for damage or
injury through failure to comply with
the above safety precaution.
Should the appliance power supply
cable need to be replaced, this
MUST be carried out by a Service
Centre.
The power supply cable must be
easily accessible after installing the
machine.
Environment...

132952390 - 00 -242009
www.electrolux.com
web portal 1
web portal 2