Electrolux Ews 1030 Instruction Booklet

	
	
	



	
	



	







	


		



 

ENGLISH
Temperatures 81
Before loading the laundry 81
Maximum loads 81
Laundry weights 81
Removing stains 81
Detergents and additives 82
International wash code symbols 83
Operating sequence 84-86
Washing programmes 87
Maintenance 88
Door seal 88
Bodywork 88
Detergent dispenser drawer 88
Drain pump 88-89
Water inlet filter 89
Emergency emptying out 89
Frost precautions 89
Something not working? 90-91
Service Centre List 92 Warnings 72
Disposal 73
Tips for environmental protection 73
Technical...

Installation
• All internal packing must be removed before using
the appliance. Serious damage may be caused to
the machine or adjacent furniture if the protective
transit devices are not removed or are not
completely removed. Refer to the relevant
paragraph in the instruction book.
 Any electrical work required to install this appliance
must be carried out by a qualified electrician.
 Any plumbing work required to install this appliance
must be carried out by a qualified plumber.
 After having installed...

ENGLISH
73
Disposal
Tips for environmental protection
Packaging materials
The materials marked with the symbol  are
recyclable.
>PEPSPP

74
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the three
rear bottom screws.
2. Slide out the three plastic pins.
3. Very carefully slide out the left polythene bag,
removing it towards the right and then
downwards..



Positioning
Install the machine on a flat hard floor.
Make sure that air...

ENGLISH
75 The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks
The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially
designed for this type of use.
Water drainage
The end of the drain hose can be positioned in three
ways:
Hooked over the edge of a sink using the...

76 1 Detergent dispenser drawer
2 Control panel
3 Door handle
4 Drain pump
5 Adjustable feet
Detergent dispenser drawer
Prewash
Main wash
Fabric softener, starch
Description of the appliance




	



	



	

	

 	
	


 
 
 
! 


	#$
##
%&&&!	
!(
)*#$+
,-+
	

	

.
(!	
#!
!


 

ENGLISH
77
Use
Control panel
Maximum temperatures are 90°C for cotton, 60°C for
synthetic fabrics, 40°C for delicate fabrics, wool and
fabrics to be hand-washed.
Position “
Kalt/Froid”corresponds to cold wash.
5 SPIN SPEED button 
Press this button repeatedly to change the spin
speed, if you want your laundry to be spun at a
speed different from the one proposed by the
washing machine. The relevant light will light up.
Maximum speeds are:


washed: 900 rpm;

RINSE HOLD position (Spülstopp/A.C.P): when...

the spin speed by means of  button and then depress
Start/Pause .
Important! If you accidentally press the  button
more than once, the display will show three blinking
dashes. To drain the water, select any washing
programme by means of the  button, then press
three timesin order to select the DRAIN position
(only the DRAIN light will remain lit).
6 OPTION button
Press these buttons to select the following options:
PREWASH (Vorwäsche/Prélavage): select this
option if you wish your laundry to be...

ENGLISH
Delay start, a time value indicated in hours and
selected by means of the relevant button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the  button, the
countdown begins, and the delay time value
decreases by one unit every hour.
You can delay the start of the selected programme
by up to 23 hours in one hour intervals.
An incorrect option selection has been made: this
is indicated by the messageErrwhen a function...