Electrolux Ewp 106100 W User Manual
Have a look at the manual Electrolux Ewp 106100 W User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 208 Electrolux manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maxi- mum Fabrics Load - Type of LaundryOptionsDetergent Compart- ment JEANS 60°- (Cold) Main wash - Rinses - Maximum spin speed: 800 rpm for EWP86100W, 1000 rpm for EWP106100W, 1200 rpm for EWP126100W Max. load 3 kg Trousers, shirts or jackets in denim and jersey realized with hi-tech materials. The Extra Rinse option is activated automatically. SPIN REDUCTION, RINSE HOLD, DELAY START 1) If you select the SUPER QUICK option by pressing button 4 , we recommend that you reduce the maximum load as indicated. Full loading is possible however with somewhat reduced cleaning results. 2) Available with EWP86100W only. CONSUMPTION VALUES ProgrammeEnergy consumption (KWh)Water consumption (litres)Programme duration (Minutes) White Cottons 95°2.1078175 Cottons 60°1.2072170 Cotton ECO 60° 1)1.0249180 Cottons 40°0.7572145 Synthetics 40°0.605795 Delicates 40°0.606575 Wool/ Handwash 30°0.304855 1) «Cottons Eco» at 60°C with a load of 6 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards. The consumption data shown on this chart is to be considered purely indicative, as it may vary depending on the quantity and type of laundry, on the inlet water tempera- ture and on the ambient temperature. CARE AND CLEANING Warning! Switch the appliance off and re- move the mains plug from the socket be- fore any cleaning action. Maintenance Wash With the use of low temperature washes it is possible to get a build up of residues in- side the drum. We recommend that a maintenance wash be performed on a regular basis. To run a maintenance wash: • The drum should be empty of laundry. • Select the hottest cotton wash pro- gramme.• Use a normal measure of detergent, must be a powder with biological proper- ties. Cleaning the dispenser drawer The washing powder and additive dispens- er drawer should be cleaned regularly. • Remove the drawer. electrolux 21
• To aid cleaning, the top part of the addi- tive compartment should be removed. • Use a stiff brush to clean and remove all washing powder residue. • Clean all the removed parts of the dis- penser drawer under a tap to remove any traces of accumulated powder. • Use the previous brush to clean the re- cess, ensuring that upper and lower part of it is well cleaned. After having cleaned the dispenser and the drawer recess, replace it. Cleaning the drain filter The filter permits to hold fluff or foreign bod- ies left unawares in the laundry. The pump must be cleaned regularly. To clean the filter, proceed as follows: • Tturn programme selector dial to position . • Unplug the appliance.; • Open the door. • Turn the drum and align the filter cover ( FILTER ) with the arrow on the door seal.; 22 electrolux
• Open the filter cover by pressing the spe- cial hook and by rotating the cover up- wards.; Warning! Keep the filter cover open until the filter removal. • Before removing the filter, remove any fluff or small objects from around the filter. • Remove the filter and clean it under the tap. • If necessary, place the filter cover in the right position again. • Open the filter cover and insert the filter again. electrolux 23
• The filter is inserted correctly when the indicator on its top is visible and blocked. • Close the filter cover. • Insert the mains plug again. Cleaning the water inlet filters Important! If the appliance doesnt fill, it takes a long time to fill with water, thestarting button flashes red or the display (if available) shows the relevant alarm (see chapter What to do if... for more details), check if the water inlet filters are blocked . To clean the water inlet filters: • Turn off the water tap. • Unscrew the hose from the tap. • Clean the filter in the hose with a stiff brush. • Screw the hose back onto the tap. Make sure the connection is tight. • Unscrew the hose from the appliance. Keep a towel nearby because some wa- ter may flow. • Clean the filter in the valve with a stiff brush or with the piece of cloth. • Screw the hose back to the appliance and make sure the connection is tight. • Turn on the water tap. 24 electrolux
WHAT TO DO IF… The appliance does not start or stops dur- ing operation. Certain problems are due to lack of simple maintenance or oversights, which can be solved with the help of the in- dications described in the charts, without calling out an engineer. During appliance operation it is possible that the red pilot light of the button 6 flash-es and one of the indicator pilot lights illumi- nates to indicate that the appliance is not working. Before contacting your local Service Cen- tre, please carry out the checks listed below. Fault code and mal- functionPossible cause - Solution The light of button 6 flashes and the light 7.1 illuminates: Problem with the wa- ter supplyThe water tap is closed. • Open the water tap. The inlet hose is squashed or kinked. • Check the inlet hose connection. The filter in the inlet hose or the inlet valve filter are blocked • Clean the water inlet filters (read Cleaning the water inlet fil- ters for more details). The light of button 6 flashes and the light 7.2 illuminates: Problem with the wa- ter drainageThe drain hose is squashed or kinked. • Check the drain hose connection. The drain filter is clogged • If the appliance stops working without discharging the water , first carry out an emergency drain: – Turn the programme selector dial to ; – Unplug the appliance; – Close the water tap; – If necessary, wait until the water has cooled down; – Unscrew the drain hose from the rear support (see Frost precaution) and unhook it from the sink or spigot; – Let it run along the floor; – Place a bowl on the floor and place the end of the draining hose into the bowl. The water should drain by gravity into the bowl. When the bowl is full, empty it. Repeat the proce- dure until water stops flowing out ; – Screw the draining hose to the rear support and reposition it; – Open the door and remove the laundry; – Carry out the drain filter cleaning as described in Cleaning the drain filter; – At the end of cleaning action, close the door and insert the mains plug again; – Run a drain programme to check if the appliance works now. electrolux 25
The light of button 6 flashes and the light 7.3 illuminates: Door openThe door has not been closed or is not closed properly. • Close firmly the door. The appliance does not start or stops dur- ing operation without any visible alarm.Before contacting your local Service Cen- tre, please carry out the checks listed below. MalfunctionPossible cause / Solution The appliance does not start: The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The main fuse has blown. • Replace the fuse. The programme selector dial is not correctly positioned and the button 6 has not been pressed. • Please turn the selector dial and press the button 6 again. The delay start has been selected. • If the laundry are to be washed immediately, cancel the delay start. The appliance fills then empties immedi- ately:The end of the drain hose is too low. • Refer to paragraph in Water drainage in chapter Installation. The appliance does not empty and/or does not spin:An option or a programme that ends with the water still in the tub or a that eliminates all the spinning phases has been selected. • Select the draining or spinning programme. The laundry is not evenly distributed in the drum. • Redistribute the laundry. There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one. The door will not open: The programme is still running. • Wait the end of washing cycle. The door lock has not been released. • Wait until the door lock is released. There is water in the drum. • Select drain or spin programme to empty out the water. 26 electrolux
MalfunctionPossible cause / Solution The appliance vibrates noisily: The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The appliance is not levelled correctly. • Adjust the feet. The laundry is not evenly distributed in the drum. • Redistribute the laundry. Maybe there is very little laundry in the drum. • Load more laundry. Spinning starts late or the appliance does not spin: The electronic unbalance detection device has cut in because the laun- dry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 mi- nutes, the laundry is still not evenly distributed in the drum, the appli- ance will not spin. In this case, redistribute the load manually and select the spin programme. • Load more laundry. The load is too small. • Add more items, redistribute the load manually and then select the spinning programme. No water is visible in the drum:Appliances based on modern technology operate very economically us- ing very little water without affecting performance. Unsatisfactory wash- ing results Too little detergent or unsuitable detergent has been used. • Increase the detergent quantity or use another one. Stubborn stains have not been treated prior to washing. • Use commercial products to treat the stubborn stains. The correct temperature was not selected. • Check if you have selected the correct temperature. Excessive laundry load. • Reduce the laundry load. The appliance makes an unusual noiseThe appliance is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor ensures a softer start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the appliance. After completing these checks, switch on the appliance and press the button 6 to re- start the programme. If the malfunction shows again, contact your Service Centre. The necessary data for the service centre is on the rating plate. We recommend that you write the data here: Mod. ... ... ... Prod. No. ... ... ... Ser. No. ... ... ... Mod. .. . ... ... Prod. No. .. . ... .. Ser. N o. . .. ... ... electrolux 27
Model description (MOD.)............................... Product number (PNC)............................... Serial number (S.N.)............................... 28 electrolux