Electrolux Ewn 148640 W User Manual

Warning! When the appliance is in use
and depending on the programme
selected there can be hot water in the
pump. Never remove the pump cover
during a wash cycle, always wait until
the appliance has finished the cycle,
and is empty. When refitting the pump
cover , ensure it is securely re-
tightened so as to stop leaks and
young children being able to remove it.
Cleaning the water inlet filters
If you notice that the machine is taking lon-
ger to fill, check that the filter in the water in-
let hose is...

6. When you intend to start the machine
up again, make sure that the room tem-
perature is above 0°C.
WHAT TO DO IF…
Certain problems are due to lack of simple
maintenance or oversights, which can be
solved easily without calling out an engi-
neer. Before contacting your local Service
Centre, please carry out the checks listed
below.
During machine operation it is possible that
the red pilot light of button 7 blinks, one of
the following alarm codes appears on the
display and some acoustic signals sound...

ProblemPossible cause/Solution
The machine does not emp-
ty and/or does not spin:
The drain hose is squashed or kinked. (« Cannot drain the wa-
ter. Please check that the filter is clean and then press
START/PAUSE »)
• Check the drain hose connection.
The drain filter is clogged. (« Cannot drain the water. Please
check that the filter is clean and then press START/
PAUSE »)
• Clean the drain filter.
An option or a programme that ends with the water still in the tub
or a that eliminates all the spinning...

ProblemPossible cause/Solution
Spinning starts late or the
machine does not spin:
The electronic unbalance detection device has cut in because the
laundry is not evenly distributed in the drum. The laundry is redis-
tributed by reverse rotation of the drum. This may happen several
times before the unbalance disappears and normal spinning can re-
sume. If, after 10 minutes, the laundry is still not evenly distributed
in the drum, the machine will not spin. In this case, redistribute the
load manually and...

CONSUMPTION VALUES
ProgrammeEnergy consumption
(KWh)Water consumption
(litres)Programme duration
(Minutes)
White Cottons 90°2.5062
For the duration of
the programmes,
please refer to the
display on the con-
trol panel.Cottons 60°1.7063
Cotton ECO 60° 1)1.3664
Cottons 40°0.9762
Synthetics 40°0.5552
Delicates 40°0.5368
Wool 30°0.3264
1) «Cottons Eco» at 60°C with a load of 8 kg is the reference programme for the data entered in the energy label, in
compliance with EEC 92/75 standards.
The consumption data...

A
4. Unscrew and remove the two large rear
bolts B and the six smaller bolts C .
CC
B
B
5.
Remove the bracket D and tighten up
the six smaller bolts C .
D
CC
6. Open the porthole, take out the inlet
hose from the drum and remove the pol-
ystyrene block fitted on the door seal.
7. Fill the smaller upper hole and the two
large ones with the corresponding plas-
tic plug caps supplied in the bag contain-
ing the instruction booklet.
26  electrolux
 

Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the ma-
chine is not impeded by carpets, rugs etc.
Check that the machine does not touch the
wall or other kitchen units. Level the wash-
ing machine by raising or lowering the feet.
The feet may be tight to adjust as they incor-
porate a self locking nut, but the machine
MUST be level and stable. If necessary,
check the setting with a spirit level. Any nec-
essary adjustment can be made with a span-
ner. Accurate...

4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
Water drainage
The end of the drain hose can be posi-
tioned in three ways.
•Hooked over the edge of a sink using
the plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the...

Connect the machine to an earthed
socket.
The manufacturer does not accept
any responsibility for damage or
injury through failure to comply
with the above safety precaution.
The power supply cable must be
easily accessible after installing the
machine.
Should the appliance power supply
cable need to be replaced, this
must be carried out by a Service
Centre.
ENVIRONMENT CONCERNS
The symbol    on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it...

Electrolux. Thinking of you.
Mehr zu unserem Denken finden Sie unter www.electrolux.com
INHALT
Sicherheitshinweise    30
Gerätebeschreibung    32
Bedienblende    33
Erste Inbetriebnahme    34
Persönliche Einstellungen    34
Täglicher Gebrauch    36
Praktische Tipps und Hinweise    42
Spülprogramme    44Reinigung und Pflege    46
Was tun, wenn …    51
Technische Daten    54
Verbrauchswerte    55
Montage    55
Elektrischer Anschluss    59
Umwelttipps    59
Änderungen vorbehalten
 SICHERHEITSHINWEISE...