Electrolux Ewn 10780 W User Manual

something not workingelectrolux  31
MalfunctionPossible causeSolution
The machine does not
empty and/or does not spin:●The drain hose is squashed
or kinked. E20
●The drain pump is clogged.E20
●The option  ,  or 
or programme  has
been selected.
●The laundry is not evenly
distributed in the drum.
●Check the drain hose
connection.
●Clean the drain pump.
●Select the option  ,  or
.
●Redistribute the laundry.
There is water on the floor:●Too much detergent or
unsuitable detergent
(creates too much foam)
has...

32electroluxsomething not working
MalfunctionPossible causeSolution
The machine vibrates or is
noisy:●The transit bolts and
packing have not been
removed.
●The support feet have not
been adjusted.
●The laundry is not evenly
distributed in the drum.
●Maybe there is very little
laundry in the drum.
●Check the correct
installation of the appliance.
●Check the correct levelling
of the appliance.
●Redistribute the laundry.
●Load more laundry.
Spinning starts late or the
machine does not spin:●The electronic...

something not workingelectrolux  33
MalfunctionPossible causeSolution
If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase date
of your machine: the Service Centre will
require this information.

	

	






The machine makes an
unusual noise●The machine is fitted with a
type of motor which makes...

34electrolux technical data
Technical data
Dimensions Width 60 cm
85 cm
63 cm Height
Depth
Water supply pressure Minimum 0,05 MPa
0,8 MPa Maximum
Cotton
Synthetics
Delicates
Woollens and handwash
Silk and LingerieMaximum Load 7  kg
3,5 kg
3,5 kg
2 kg
1kg
MaximumSpin Speed1000 rpm 
Electrical connection Voltage
- Overall power - FuseInformation on the electrical connection is given on
the rating plate on the inner edge of the appliance
door
132972670.qxd  14/06/2007  19.13  Pagina  34
 

consumption valueelectrolux  35
The consumption data shown on this
chart is to be considered purely
indicative, as it may vary depending on
the quantity and type of laundry, on the
inlet water temperature and on the
ambient temperature. It refers to the
highest temperature for each wash
programme.(*) The programme “Cottons Eco  ”
with 7 kg at 60°C is the reference
programme for the data entered in
the energy label, in compliance with
EEC 92/75 standards.
Consumption values
Water
consumption 
(in...

36  electrolux installation
Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all transit
devices so that they can be refitted if the
machine ever has to be transported
again.
1. After removing all the packaging,
carefully lay machine on it’s back to
remove the polystyrene base from the
bottom.
2. Remove the power supply cable and
the draining hose from the hose
holders on the rear of the appliance.
3. With a suitable spanner unscrew...

installationelectrolux 37
6. Open the porthole, take out the inlet
hose from the drum and remove the
polystyrene block fitted with the
adhesive tape on the door seal.
7. Fill the smaller upper hole and the two
large ones with the corresponding
plastic plug caps supplied in the bag
containing the instruction booklet.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets,
rugs etc. Check that the machine does
not touch the wall or...

38 electrolux  installation
3. Set the hose correctly by loosening
the ring nut. After positioning the inlet
hose, be sure to tighten the ring nut
again to prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance. 
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
Important!
Before connecting the machine to new
pipework...

installation electrolux  39
Warning!
Connect the machine to an earthed
socket. 
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution. 
Should the appliance power supply
cable need to be replaced, this should
be carried out by our Service Centre.
Please ensure that when the
appliance is installed the power
supply cable is easily accessible.
Should the appliance power supply
cable need to be replaced, this
must be carried out by a...

40 electrolux  environment concerns
Environment concerns
Packaging materials
The materials marked with the symbol
are recyclable.
>PEPSPP