Electrolux Ewi 1235 Instruction Booklet

WASHING MACHINETVÄTTMASKIN
PYYKINPESUKONE
STIRALWNAÅ MAfiINA
INSTRUCTION BOOKLET BRUKSANVISNINGKÄYTTÖOHJE
RUKOVODSTVO PO ÈKSPLUATACII
EWI 1235
132 984 410
S
FIN
RUS GB
132984410 copertina  1-11-2005  9:34  Pagina 1
 

Contents
2
Dear customer,
Please read these operating instructions carefully
and pay particular attention to the safety notes
indicated in the first pages. We recommend that you
keep this instruction booklet for future reference and
pass it on to any future owners.
The symbols you will see on some paragraphs of this booklet have the following meaning:
The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly
important for your safety or correct functioning...

ENGLISH
Warnings
Installation
• All internal packing must be removed before using
the appliance. Serious damage may be caused to
the machine or adjacent furniture if the protective
transit devices are not removed or are not
completely removed. Refer to the relevant
paragraph in the instruction book.
• Any electrical work required to install this appliance
must be carried out by a qualified electrician.
• Any plumbing work required to install this
appliance must be carried out by a qualified
plumber.
•...

Technical specifications
DIMENSIONS Height 82 cm
Width 60 cm
Depth 54 cm
MAXIMUM LOAD Cotton 5 kg
Synthetics 2 kg
Delicates 2 kg
Woollens/handwash 1 kg
SPIN SPEED 1200 rpm max.
POWER SUPPLY VOLTAGE/FREQUENCY 220-230 V/50 Hz
TOTAL POWER ABSORBED 2200 W
MINIMUM FUSE PROTECTION 10 A
WATER PRESSURE Minimum 0,05 MPa
Maximum 0,8 MkPa
This appliance complies with the following EEC Directives:
73/23/EEC of 19/02/73 relating to low voltage
89/336/EEC of 03/05/89 relating to electromagnetic compatibility.
4...

ENGLISH
Installation
5
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the rear
right-hand bolt and lay the machine on its back,
taking care not to squash the hoses. This can be
avoided by placing one of the corner packing
pieces between the machine and the floor.
2. Remove the polystyrene base and take off...

6
Water inlet
Connect the water inlet hose supplied with the
machine to a tap with a 3/4 thread. Do not use
already employed hoses.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially
designed for this type of...

ENGLISH
Preparation and assembly of the door
The machine is originally pre-arranged for the
assembly of a door opening from right to left.
In this case it is sufficient to screw in the hinges (1)
and the counter-magnet (6) provided with the
appliance, at the right level (Fig. B).
a) Door
The dimensions of the door should be:
- width  595-598 mm
- thickness  16-22 mm
The height (C-Fig. C) depends on the height of the
adjacent furnitures base.
b) Hinges
To mount the hinges it is necessary to drill two...

Your new washing machine
8 This new washing machine, which is fitted with the Direct Spray system, meets all modern needs for effective
treatment of laundry with low water, energy and detergent consumption.
Further savings are achieved by washing small loads of laundry, since water and electricity consumption is
proportional to the quantity and type of laundry being washed.
•The programme selector dialcombines the function of programme and temperature selection, making it
easier to set the programme....

ENGLISH
9
Use



 











	

 


		



	



Control panel
1 Detergent dispenser drawer
2 Mains-on light
This light comes on when the ON/OFF button  is
pressed, and goes out when it is pressed again.
3 ON/OFF button 
Press this button to switch the machine on. Press it
again to switch the machine off.
Programme Option buttons
Depending on the programme, different functions
can be combined. These must be selected after
choosing the desired...

6 Soak button 
To be used for heavily soiled laundry. The machine
performs a soak of about 30 minutes at 30°C. By
pressing the DELAY START button  the soak time
can be prolonged up to 10 hours max. After this time
the wash cycle will start automatically.
This option is not suitable for wool/handwash and
cannot be selected with PREWASH option  .
The soak programme ends with a short spin in
programmes for cottons and synthetics, and with
emptying of the water without spinning for delicates.
7 Quick wash...