Electrolux Ewf 14470 W User Manual
Here you can view all the pages of manual Electrolux Ewf 14470 W User Manual. The Electrolux manuals for Washing Machine are available online for free. You can easily download all the documents as PDF.
Page 21
ProblemPossible cause/Solution The washing machine does not start: The door has not been closed. • Close firmly the door. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installa- tion. The main fuse has blown. • Replace the fuse. The selector dial is not correctly positioned and the button 8 has not been pressed. • Please turn the selector dial and press the but- ton 8 again. The...
Page 22
ProblemPossible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (cre- ates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain hose is damaged. • Change it with a new one. The cap on the filter has not been replaced or the...
Page 23
ProblemPossible cause/Solution The machine makes an unusual noise: The machine is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor ensures a soft- er start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the machine. No water is visible in the drum:Machines based on modern technology operate very economically using very little water without affecting performance. If you are unable to...
Page 24
ProgrammeEnergy consumption (KWh)Water consumption (litres)Programme duration (Minutes) Cottons 40°0.758 Synthetics 40°0.550 Delicates 40°0.5560 Wool/ Handwash 30°0.2553 1) «Cotton Eco» at 60°C with a load of 6 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards. The consumption data shown on this chart is to be considered purely indicative, as it may vary depending on the quantity and type of laundry, on the inlet water temperature and on the...
Page 25
4. Slide out the relevant plastic spacers. 5. Open the porthole and remove the poly- styrene block fitted on the door seal. 6. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing ma-...
Page 26
levelling prevents vibration, noise and dis- placement of the machine during operation. Caution! Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. Water inlet Warning! This appliance must be connected to a cold water supply. 1. Connect the water inlet hose supplied with the machine to a tap with a 3/4 thread. Always use the hose supplied with the appliance. Important! Do not use the hose from your previous machine to connect to the water...
Page 27
• Hooked over the edge of a sink using the plastic hose guide supplied with the machine. In this case, make sure the end cannot come unhooked when the ma- chine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall.• In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground. •Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. The end of the drain hose must...
Page 28
Should the appliance power supply cable need to be replaced, this must be carried out by a Service Centre. Environment concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health,...