Electrolux Ewf 127410 W User Manual

Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes and
one of the following alarm codes appears on the display to indicate that the machine
is not working:
● E10: problem with the water supply
● E20: problem with water draining
● E40:...

48electrolux something not working
MalfunctionPossible causeSolution
The machine does not
empty and/or does not spin:The drain hose is squashed
or kinked.  E20
The drain pump is clogged.
E20
The the option  or 
has been selected.
The laundry is not evenly
distributed in the drum.
Check the drain hose
connection.
Clean the drain pump.
Disable the option  or 
Redistribute the laundry.
There is water on the floor:Too much detergent or
unsuitable detergent
(creates too much foam)
has been used.
Check whether...

MalfunctionPossible causeSolution
The machine vibrates or is
noisy:The transit bolts and
packing have not been
removed.
The support feet have not
been adjusted.
The laundry is not evenly
distributed in the drum.
Maybe there is very little
laundry in the drum.
Check the correct
installation of the appliance.
Check the correct levelling
of the appliance.
Redistribute the laundry.
Load more laundry.
Spinning starts late or the
machine does not spin:The electronic unbalance
detection device has cut in...

If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the
model, serial number and purchase date
of your machine: the Service Centre will
require this information.
Technical data
Dimensions Width 60 cm
85 cm
64 cm
Height
Depth
Water supply pressure Minimum 0,05 MPa
0,8 MPa
Maximum
Cotton
Synthetics
Delicates
Woollens and handwashMaximum Load 7 kg
3 kg
3 kg
2 kg 
MaximumSpin SpeedMod. EWF —f274—f0 W —f200 rpm
Mod. EWF —f074—f0 W —f000 rpm...

(*) The “Cottons 60U and option Eco selected” is the reference programme
for the data entered in the energy
label, in compliance with EEC 92/75
standards.The consumption data shown on this
chart is to be considered purely
indicative, as it may vary depending on
the quantity and type of laundry, on the
inlet water temperature and on the
ambient temperature. It refers to the
highest temperature for each wash
programme.
Consumption values
Programme duration 
(in minutes)Programme Energy
consumption  (in...

5\belectrolux installation
Installation
Transit security bars
Before starting the machine up,  the
transport security  bars must be
removed as follows:
You are advised to keep all the transport
security bars. In case the appliance has
to be transported again.
—f. Unscrew and remove the three rear screws by means of a key.
2. Open the porthole and remove the poliesthyrene block fitted on the door seal.
3. Place the machine in an upright position and remove the three plastic
bolts.
4. Plug the 3 holes with...

3. Place the discharging hose in awashbasin or sink with the aid of the
bent piece delivered separately. The
bent piece has to be entered into the
tube’s mouth in order to assure the
support. Aforesaid piece allows the
hose to be fixed to the wall by means
of an opening on the upper part and
that way the hose does not move and
its falling is avoided.
IMPORTANT: 
The distance from the floor to the
highest part of the hose should be
between 60 to 90 cm. (It is advised to
be between 60 and 70 cm). The hose...

54electrolux environment concerns
Environment concerns
Packaging materials
The materials marked with the symbol
are recyclable.
>PEPSPP

guarantee conditionselectrolux  55
V  Appliances found to be in use within a
commercial environment, plus those
which are subject to rental
agreements.
V  Products of Electrolux manufacturer that are not marketed by Electrolux
Service and Spare Parts
In the event of your appliance requiring
service, or if you wish to purchase spare
parts, please contact your local Service
Force Centre by telephoning
Your telephone call will be automatically
routed to the Service Force Centre
covering your postcode area....

5\felectrolux customer service centres
Customer Service Centres
Should you need further assintance please contact your local Customer Service
Centre
Centro de Asistencia TOcnica
En caso de necesitar una mayor ayuda, por favor contacte con su Centro de
Asistencia TOcnica
126.2931.3\b:-  23/\b\f/1\b\5  13:57  Página 56
DownloadedSFromSWashingMachineiManualjcomSManuals