Electrolux Ewf 126410 W User Manual

user manual
Упатство за ракување
Инструкция по
эксплуатации
Washing Machine
Машина за перење
Стиральная машина
EWF 106410 W
EWF 126410 W
EWF 146410 W
 

Electrolux. Thinking of you.
Share more of our thinking at www.electrolux.com
CONTENTS
Safety information    2
Product description    4
Control panel    5
First use    8
Personalisation     8
Daily use    8
Helpful hints and tips    11
Washing programmes    13Care and cleaning    15
What to do if...    19
Technical data    22
Consumption values    22
Installation    23
Electrical connection    26
Environment concerns    26
Subject to change without notice
 SAFETY INFORMATION
Important! Read carefully &...

• When unpacking the appliance, check
that it is not damaged. If in doubt, do not
use it and contact the Service Centre.
• All packing and transit bolts must be re-
moved before use. Serious damage can
occur to the product and to property if
this is not adhered to. See relevant sec-
tion in the user manual.
• After having installed the appliance,
check that it is not standing on the inlet
and drain hose and the worktop is not
pressing the electrical supply cable
against the wall.
• If the machine is...

PRODUCT DESCRIPTION
Your new appliance meets all modern requirements for effective treatment of laundry
with low water, energy and detergent consumption. Its new washing system allows to-
tal use of detergent and reduces water consumption so saving energy.
12
3
4
5
6
1Detergent dispenser drawer
2Control panel
3Door opening handle
4Rating Plate
5Drain pump
6Adjustable feet
Detergent dispenser drawer
 Compartment for detergent used for pre-
wash and soak phase or for stain remover
used during the stain...

Programme guide 
The programme guide is on the front side of
the detergent dispenser drawer.
Other programme guides in different lan-
guages are in the user manual bag. (Not all
appliances have more than one programme
guide). To replace the programme guide:
1. Pull it out from the right side and re-
move it.
2. Put in the new programme guide.
CONTROL PANEL
Below is a picture of the cont rol panel. It shows the progra mme selector dial as well as
the buttons, pilot light and the display.  These are...

Programme Selector Dial
It allows you to switch the appliance on/off
and/or to select a programme.
Temperature
This button allows yo u to increase or de-
crease the washing temperature.
Spin speed Reduction
By pressing this butt on you can reduce the
maximum spin speed allowed for the selec-
ted programme or to select the available op-
tion(s).
Rinse hold
By selecting this function the water of the
last rinse is not emptied out to prevent the
fabrics from creasing.  Before opening the
door it will be...

Display
7.47.57.1
7.27.3
The display shows the following information:
7.1:
•Duration of the selected programme
After selecting a programme, the duration
is displayed in hours and minutes (for ex-
ample 2.05  ). The duration is calculated
automatically on the basis of the maxi-
mum recommended load for each type of
fabric. After the programme has started,
the time remaining is updated every mi-
nute.
•Delayed start
The Selected delay set by pressing the rel-
evant button appears on the display for
few...

FIRST USE
• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
• Remove the polystyrene block and
any material from the drum.
• Pour 2 litres of water into the main
wash compartment 
 of the deter-
gent drawer in order to activate theECO valve. Then run a cotton cycle
at the highest temperature without
any laundry in the machine, to re-
move any manufacturing residue
from the drum and tub. Pour 1/2 a
measure of detergent into the main
wash compartment and start...

If required, pour fabric softener into the com-
partment marked 
 (the amount used
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by
turning the programme selector dial (1)
Turn the programme selector dial to the re-
quired programme. The washing machine
will propose a temperature and automatical-
ly select the maximum spin value provided
for the programme you have chosen. You
can change these values by operating the
corresponding buttons. The green...

2. Select the delay start by pressing the but-
ton 6 .
3. Press button 8 :
– the machine starts its hourly count-
down.
– The programme will start after the se-
lected delay has expired.
Cancelling the delayed start after having
pressed button 8 :
1. Set the washing machine to PAUSE by
pressing button 8 .
2.
Press button 6 once until the symbol 0’
is displayed
3. Press button 8 again to start the pro-
gramme.
Important! The selected delay can be
changed only after selecting the washing
programme again....