Electrolux Esi 65010 X User Manual

							daily use electrolux  21
Adjusting the height of the upper basket 
If washing very large plates you can load them in the lower basket after moving
the upper basket to the higher position. 
Never lift or lower the basket on
one side only
When the basket is in the higher
position you will not be able to use
the cup racks.
After loading your machine always
close the door, as an open door can
be a hazard.
To move to the higher position
proceed as follows:
1. Pull out the basket until it stops. 
2. Carefully lift both sides upwards
until the mechanism is engaged
and the basket is stable. 
To lower the basket to the original
position proceed as follows:
1. Pull out the basket until it stops. 
2. Carefully lift both sides upwards
and then allow the mechanism to
drop back down slowly, keeping
hold of it. 
Maximum height of the dishes in the lower basket
31 cm With upper basket raised
27 cm With upper basket lowered
117991 68/0en  19-01-2007  11:08  Pagina 21
 
						

							22electroluxdaily use
Use of detergent 
Only use detergents specifically
designed for use in dishwashers.
Please observe the manufacturer’s
dosing and storage recommendations
as stated on the detergent packaging.
Using no more than the correct
amount of detergent contributes to
reducing pollution.
Fill with detergent 
1. Open the lid.
2. Fill the detergent dispenser (1)
with detergent. The marking
indicates the dosing levels:20 = approximately 20 g of
detergent
30 = approximately 30 g of
detergent
3. All programmes with prewash
need an additional detergent dose
(5/10 g) that must be placed in the
prewash detergent chamber (2).
This detergent will take effect
during the prewash phase.
When using detergent tablets;
place the tablet in compartment (1)
4. Close the lid and press until it
locks in place.
1
2
Detergent tablets
Detergent tablets from different
manufactures dissolve at different
rates. For this reason, some detergent
tablets do not attain their full cleaning
power during short washing
programmes. Therefore, please use
long washing programmes when
using detergent tablets, to ensure the
complete removal of detergent
residuals.
117991 68/0en  19-01-2007  11:08  Pagina 22
 
						

							daily use electrolux  23
Activation/deactivation of the Multi-
tab function
Simultaneously press and hold the
two buttons positioned over the Multi-
tab symbol, until the "Multi-tab
function "indicator light illuminates.
This means that the function is active.
To deactivate the function press the
same buttons again until the "Multi-
tab" indicator light turns off."Multi-tab function"
This appliance is equipped with the
"Multi-tab function", that allows the
use of combi detergent tablets.
These products are detergents with a
combined cleaning, rinsing and salt
functions. They can also contain other
different agents depending on which
kind of tablets you choose ("3 in 1", "4
in 1", "5 in 1" etc...)
Check whether these detergents are
suitable for your water hardness. See
the manufacturers instructions.
Once this function is selected it will
remain active also for the following
washing programmes.
With the selection of this function the
inflow of rinse aid and salt from each
respective supply container is
automatically deactivated and also the
indicator lights for salt and rinse aid
are deactivated.
Select the "Multi-tab function" before
the start of a washing programme.
With the use of the "Multi-tab
function", the cycle durations may
change.
Once the programme is running, the
"Multi-tab function" can NOlonger be
changed. If you want to exclude the
"Multi-tab function" you have to cancel
the programme setting and then
deactivate the "Multi-tab function". 
In this case you have to set a
washing programme (and desired
options) again.
If the drying results are not
satisfactory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to
position 2. 
The activation/deactivation of the
rinse aid dispenser can only be
possible with the "Multi-tab
function" active.
117991 68/0en  19-01-2007  11:08  Pagina 23
 
						

							24electroluxdaily use
Activation/deactivation of the rinse
aid dispenser
1. Press the On/Off button. The
dishwasher must be in setting
mode.
2. Press simultaneously buttons 2
and 3, until the lights of buttons 1,
2
,and 3 start flashing.
3. Press button 2, the lights of
buttons 1 and 3 turn off while the
light of button 2 goes on flashing.
4. To activate the rinse aid dispenser,
press button 2 again, the end of
programmeindicator light
illuminates, indicating that the rinse
aid dispenser has been activated.
5. To memorise the operation, switch
off the dishwasher by pressing the
On/Off button.
6. To deactivate the rinse aid
dispenser again, follow the above
instructions until the end of
programmeindicator light turns
off.
If you decide to turn back to the
use of standard detergent system
we advise that you:
1. Deactivate the "Multi-tab function".
2. Fill up the salt container and the
rinse aid dispenser again.
3. Adjust the water hardness setting
to the highest setting and perform
1 normal washing programme
without loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the
water in your area.
5. Adjust the rinse aid dosage.
117991 68/0en  19-01-2007  11:08  Pagina 24
 
						

							daily use electrolux  25
Select and start a washing
programme
Select the washing programme and
delay start with the door slightly
opened. The start of the
programme or the countdown of
the delay start will occur only after
the closure of the door. Until then it
is possible to modify the settings.
1. Check that the baskets have been
loaded correctly and that the spray
arms are free to rotate
2. Check that the water tap is opened
3. Press the On/Off button. The
dishwasher must be in setting
mode.
4. Press the button corresponding to
the required programme (see
"Washing programmes" chart). The
light corresponding to the selected
programme will illuminate.
In the digital display 3 horizontal
lines are visible.
The programme in progress
indicator light illuminates.
Close the dishwasher door, the
programme starts automatically.
The programme in progress
indicator light remains illuminated.
In the digital display is visible only
1 horizontal line and will remain on
for all the duration of the washing
programme.Setting and starting the programme
with "delay start"
1. After having selected the washing
programme, press the delay start
button until the flashing number of
hours for the delay start will appear
in the digital display. The
commencement of the selected
washing programme can be
delayed from 1 to 9 hours. 
2. Close the dishwasher door, the
countdown starts automatically and
the number in the display stops
flashing.
3. The countdown will decrease with
steps of 1 hour
4. The opening of the door will
interrupt the countdown. Close the
door; the countdown will continue
from the point at which it was
interrupted.
5. Once the delay start has elapsed
the programme will start
automatically.
With the delay start function set,
the programme in progress
indicator light is off. Once the
countdown of the delay start has
elapsed, the washing programme
will start automatically and the
programme in progressindicator
light will illuminate.
117991 68/0en  19-01-2007  11:08  Pagina 25
 
						

							26electroluxdaily use
The selection of the washing
programme and delay start can
also occur with the door closed.
Keep in mind that in this way, once
a washing programme button is
pressed you have ONLY 3
secondsin which you can choose
another programme or select a
delay start, after which the
selected programme will start
automatically. 
Cancelling the "delay start"
To cancel a delay start in progress
you have to reset the dishwasher.
Simultaneously press and hold the
two programme buttons positioned
over the word Cancel, until all the
programme button lights will
illuminate. 
Cancelling a delay start involves
also the cancelling of the washing
programme set. In this case you
have to set the washing
programme again.
Interrupt or cancel a washing
programme in progress ONLY if it’s
absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress:
Open the dishwasher door; the
programme will stop. Close the
door; the programme will start from
the point at which it was
interrupted.
Press the On/Off button, all
indicator lights will turn off. Press
the On/Off button again; the
programme will start from the point
at which it was interrupted.
Cancel a washing programme in
progress
Simultaneously press and hold the
two programme buttons positioned
over the word Cancel, until all the
programme button lights will
illuminate and in the digital display
3 horizontal lines appear. The
washing programme has been
cancelled.
If a new washing programme is to
be selected, check that there is
detergent in the detergent
dispenser.
117991 68/0en  19-01-2007  11:08  Pagina 26
 
						

							daily use electrolux  27
End of the washing programme
The dishwasher will automatically
stop and the programme in
progressindicator light turns off.
The end of programmeindicator
light will illuminate.
The indicator light of the
programme just ended will remain
on.
The digital display turns off.
1. Switch off the dishwasher by
pressing the On/Off button.
2. Open the dishwasher’s door, leave
it ajar and wait a few minutes
before removing the dishes; in this
way they will be cooler and the
drying will be improved.
Unloading the dishwasher
Hot dishes are sensitive to knocks.
The dishes should therefore be
allowed to cool down before
removing from the appliance.
Empty the lower basket first and
then the upper one; this will avoid
water dripping from the upper
basket onto the dishes in the lower
one.
Water may appear on the sides
and the door of the dishwasher as
the stainless steel will eventually
become cooler than the dishes.
When the washing programme has
finished, it is recommended that
the dishwasher is unplugged and
the water tap turned off.
117991 68/0en  19-01-2007  11:08  Pagina 27
 
						

							28electroluxwashing programmes
Washing programmes
Programme
IntensiveHeavy soilCrockery,
cutlery, pots
and pansPrewash
Main wash up to 70°C
2 intermediate rinses
Final rinse
Drying
GlassNormal soilDelicate
crockery and
glasswareMain wash up to 45°C
1 intermediate rinse
Final rinse
Drying
Normal soil
Crockery,
cutlery, pots
and pans
Prewash
Main wash up to 50°C or 65°C
1 or 2 intermediate rinses
Final rinse
Drying Degree of
soilType of load Programme description
Normal soilCrockery and
cutlery
Prewash
Main wash up to 50°C
1 intermediate rinse
Final rinse
Drying
Light soilCrockery and
cutleryMain wash up to 60°C
Final rinse
(1)
Quick (2)
(3)
117991 68/0en  19-01-2007  11:08  Pagina 28
 
						

							washing programmes electrolux  29
Washing programmes information
(1) During the "Auto" washing 
programme the amount of soil on 
the dishes is determined by how 
cloudy the water is.
The programme duration, water 
and energy consumption levels 
can vary; this depends upon if 
the appliance is fully or partially 
loaded and if the dishes are 
lightly or heavily soiled.
The temperature of the water is 
automatically adjusted between 
50°C and 65°C.
(2) Ideal for washing a partially 
loaded dishwasher. This is the 
perfect daily programme, made to 
meet the needs of a family of 4
personswho only wish to load 
breakfast and dinner crockery 
and cutlery.
(3) Test programme for test 
institutes.
117991 68/0en  19-01-2007  11:08  Pagina 29
 
						

							30electroluxcare and cleaning
Cleaning the filters
The filters must be checked and
cleaned from time to time. Dirty filters
will degrade the washing result.
1. Open the door, remove the lower
basket.
2. The dishwasher filter system
comprises a coarse filter (A), a
microfilter (B) and a flat filter.
Unlock the filter system using the
handle on the microfilter.
3. Turn the handle about 
1/4a turn
anticlockwise and remove the filter
system.
Before cleaning the filters ensure
that the machine is switched off.
4. Take hold of the coarse filter (A)
by the handle with the hole and
remove from the microfilter (B).
5. Clean all filters thoroughly under
running water.
6. Remove the flat filter from the
base of the washing compartment
and clean both faces thoroughly.
7. Put the flat filter back in the base
of the washing compartment and
ensure that it fits perfectly.
8. Place the coarse filter (A) in the
microfilter (B) and press together.
9. Put the filter combination in place
and lock by turning the handle
clockwise to the stop. During this
process ensure that the flat filter
does not protrude above the base
of the washing compartment.
Care and cleaning
NEVER use the dishwasher without
filters. Incorrect repositioning and
fitting of the filters will produce poor
washing results and may result in
damage to the appliance.
117991 68/0en  19-01-2007  11:08  Pagina 30