Home > Electrolux > Dishwasher > Electrolux Esf 65040 User Manual

Electrolux Esf 65040 User Manual

Here you can view all the pages of manual Electrolux Esf 65040 User Manual. The Electrolux manuals for Dishwasher are available online for free. You can easily download all the documents as PDF.

Page 11

BEFORE FIRST USE
1.Make sure that the set level of the wa-
ter softener agrees with the water
hardness in your area. If not, adjust the
water softener. Contact your local wa-
ter authority to know the water hard-
ness in your area.
2.Fill the salt container.
3.Fill the rinse aid dispenser.
4.Open the water tap.5.Processing residues can stay in the ap-
pliance. Start a programme to remove
them. Do not use detergent and do
not load the baskets.
If you use the combi detergent
tablets, activate the multitab...

Page 12

Electronic adjustment
1.Press the on/off button to activate the
appliance.
2.Make sure that the appliance is in set-
ting mode. Refer to ‘SETTING AND
STARTING A PROGRAMME’.
3.Press and hold Delay and Start at the
same time until the indicators (A), (B)
and (C) flash.4.Press Program.
• The indicators (B) and (C) go off.
• The indicator (A) continues to flash.
• The display shows the setting of the
water softener. Example: 
 = lev-
el 5.
5.Press Program again and again to
change the setting.
6.Deactivate...

Page 13

DAILY USE
1.Open the water tap.
2.Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to ’SET-
TING AND STARTING A PRO-
GRAMME’.
• If the salt indicator is on, fill the salt
container.• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3.Load the baskets.
4.Add the detergent.
5.Set and start the correct programme
for the type of load and the degree of
soil.
USING THE DETERGENT
2030MAX1234+-
AB
C
1.Press the release button (B) to open...

Page 14

• The display shows the countdown of
the delay start that decreases with
steps of 1 hour.
• The phase indicators of the set pro-
gramme go off.
• When the countdown is completed, the
programme starts.
– The indicator of the phase in opera-
tion comes on.
Opening the door while the
appliance operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the delay start while
the countdown operates
Press Delay again and again...

Page 15

HINTS AND TIPS
THE WATER SOFTENER
Hard water contains a high quantity of
minerals that can cause damage to the
appliance and bad washing results. The
water softener neutralises these minerals.
The dishwasher salt keeps the water soft-
ener clean and in good conditions. It is
important to set the right level of the wa-
ter softener. This makes sure that the wa-
ter softener uses the correct quantity of
dishwasher salt and water.
LOADING THE BASKETS
Refer to the supplied leaflet with
examples of the load...

Page 16

CARE AND CLEANING
WARNING!
Before maintenance, deactivate
the appliance and disconnect the
mains plug from the mains socket.Dirty filters and clogged spray
arms decrease the washing re-
sults.
Make a check regularly and, if
necessary, clean them.
CLEANING THE FILTERS
A
B
C
C
A1
A2
1.Turn the filter (A) counter-
clockwise and remove it.
2.To disassemble the filter (A),
pull apart (A1) and (A2).
3.Remove the filter (B).
4.Wash the filters with water.
5.Put the filter (B) to its initial po-
sition. Make...

Page 17

TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solution
to the problem.
With some problems, the display shows
an alarm code:
•
 - The appliance does not fill with
water.•
 - The appliance does not drain the
water.
•
 - The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
ProblemPossible causePossible solution
The programme
does not start.The mains plug is not con-...

Page 18

• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature drying
phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tab-
lets can be the cause. Try a...

Page 19

ENGLISH19
 

Page 20

www.aeg.com/shop117922060-A-092012
 
Start reading Electrolux Esf 65040 User Manual

Related Manuals for Electrolux Esf 65040 User Manual

All Electrolux manuals