Electrolux Esf 2420 Instruction Book

- 11 -
In the event of a fault
The programme will not start.
The dishwasher is not Þlling with water.
Water not discharged at end of cycle.
Dishes not washed satisfactorily.
Visible lime deposits or white Þlm
on the dishes.
The dishwasher is noisy.
The dishes are not quite dry and are
not shiny.¥ Is the door closed properly?
¥ Have you pressed the start button?
¥ Is the water tap turned on?
¥ Is the dishwasher plugged in?
¥ Has the fuse blown?
¥ Is the delayed start-button pressed in?
¥ Is the previous...

- 12 -
Service
Service and spare parts
Servicing and repairs must be carried out by a service
company authorised by the supplier. Use only spare
parts supplied by these. 
Before calling service, use the trouble shooting table 
ÓIn  the event of a faultÓ to try to attend to the fault yourself.
Note that electrical faults shall always be rectiÞed by a
certiÞed electrician.
State the applianceÕs model designation, product- and
serial numbers according to the data plate afÞxed to the
rear of the dishwasher....

- 13 -
Installation instructions
Any electrical work required to install this appliance,
should be carried out by a qualiÞed electrician or
competent person.
Any plumbing work required to install this appliance,
should be carried out by a qualiÞed plumber or
competent person.
Technical speciÞcations
Capacity:6 place settings accordance EN 50242
Dimensions:Height 447 mm
Width 546 mm
Depth (to the edge of the door) 480 mm
Depth (to the middle of the door) 507 mm
Weight:Net 22 kg
Water pressures:Minimum 80...

- 14 -
12
Unpacking
Damages
If the dishwasher has been damaged during transport,
you should immediately notify the company responsible
for delivering it.
Check that the dishwasher is undamaged. If you discover
any damage, faults or that anything is missing, you should
notify the dealer immediately.
Never leave packaging material in a place
where children may play with it.
Check that the following accessories are supplied with the
dishwasher when you unpack it:
Ð A funnel for Þlling salt (1)
Ð Elbow for...

- 15 -
Installation
Water inlet
The dishwasher is equipped with safety features
which are to prevent the water from going back 
to the fresh water system. These features are ac-
cording to current water technical safety regulations.
The temperature of the water supply should not exceed 65¡ C
and the pressure should be between 80-1000 kPa (0,8 - 10 bar). 
It is important to have a tap or stopcock, positioned close to
the dishwasher and with easy access. Special mixer taps with
dishwasher connections are...

Technical changes possible
Technische €nderungen vorbehalten